Problem 4: Question You have been provided with the voltage and current data measured for an unknown electrical element (the measured voltage across the element and the corresponding current measured through the element). Plot this data (by hand or using MS Excel or Matlab) and determine if this element is a resistor. If it is a resistor, what is the resistance value of the resistor? Voltage (V) 1 2345 2 5 Current (A) 4.50 8.60 13.0 17.6 21.9

Problem 4: Question You have been provided with the voltage and current data measured for an unknown electrical element (the measured voltage across the element and the corresponding current measured through the element). Plot this data (by hand or using MS Excel or Matlab) and determine if this element is a resistor. If it is a resistor, what is the resistance value of the resistor? Voltage (V) 1 2345 2 5 Current (A) 4.50 8.60 13.0 17.6 21.9

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

3. The figure on the left below shows a schematic diagram of a battery. The voltage measured by U1 is called the terminal voltage given R1 = 1 ohm. In the figure on the right below, the terminal voltage of each of the battery-resistor combination is Vr = 1.5 volts. Find the following: a. The current passing through R5. b. The currents passing through R1 and R3 C. The voltage across R1. d. The voltage of the battery EMF. e. The percentage of voltage loss ot the battery due to the internal resistance R1. The power dissipated by the internal resistance R1. g. The power dissipated by R5 if R1 = R2 = R3 = R4 = 0. h. The percentage of power dissipation loss due to the four resistors R1, R2, R3, and R4 f. R1 R3 S10 R1 U1 1.500 EMF EMF R5 100 V1 R2 $10 EMF R4 EMF EMF
topic: Resistance and ohms law
nichrome ribbon resistor elements each has a resistance of 1 ohm. the element is made from sheet of nichrome alloy, 0.025 cm thick. if the width 9f the ribbon is 0.3 cm , what is the length is required per element? assume specific resistance of nichrome alloy to be 10g micro ohm-cm
In the figure the ideal batteries have emfs ɛ1 = 20.4 V, ɛ2 = 9.05 V, and ɛ3 = 5.40 V, and the resistances are each 2.40 Q. What are the (a) size and (b) direction (left or right) of current i,? (c) Does battery 1 supply or absorb energy, and (d) what is its power? (e) Does battery 2 supply or absorb energy, and (f) what is its power? (g) Does battery 3 supply or absorb energy, and (h) what is its power? (a) Number i Units (b) (c) (d) Number i Units (e) (f) Number i Units (g) (h) Number i Units
The references for the voltage and current at the terminals of acircuit element are as shown . The numerical values for v and i are −20 V and −5 A. Do the electrons gain or lose energy as they pass through theelement in the box?
D3 D1 V1 sine R1 1 kHz D2 D4 Given: • V1 = 5.9 Vrms • R1 = 7 kOhm • Diode voltage = 0.9 V What is the maximum voltage across resistor R1 (in V)?
Look for Requivalent(Equivalent Resistance).Please show details
The resistance of wire increases from 40 – ohm at 20 0C to 50 – ohm at 70 0C. Find the temperature coefficient of resistance at 0 0C.
A. Using long coupon bond(s), make a written discussion of what you learned in this lesson. Your discussion includes but not limited to the following: 1. Electric current, direct and alternating current, average current 2. Emf, dependent and independent sources 3. Conductance and conductivity 4. Resistance and resistivity 5. Percent conductivity 6. D-c measurements of voltage, current, resistance B. Calculate the resistivity and percent conductivity of the elements and alloys listec in the table below. 1. Resistivity Elements Ohm-cm Ohm-meter Alloys Ohm-cm Ohm-meter Brass Silver German silver Copper, Manganin Copper, Lucero Gold, pure Advance Aluminum Constantan Magnesium Excello Tungsten Nichrome Zinc Nichrome II Nickel Chromel Iron, cast Platinum Iron, Lead
For solar cell the Open Circuit Voltage (Voc) occurs when O a. voltage is minimium f O b. voltage is zero ion O C. current is maximium O d. current is zero page
The temperature coefficient of resistivity of carbon is -0.0005/C° . If the resistor is made of graphite as a resistance of 5 kΩ at 20°. find the resistance at 27°
O * 33% A moodle1.du.edu.om e SIM aY The measured temperature is 173 OF and the reference is 45 °F. The voltage. in mV is Select one: O a. 4.643 O b. 4.097 O e. 3.732 O d. -3.732 Previous page Next page