Problem 4 (a) Water from a water reservoir is delivered through a 2-cm pipe to a 200-litre tank as shown in Figure below. The water level (H) is at 2 m above the pipe. Calculate (a) the time it would take to fill the tank and (b) the height difference of the mercury, h in a U-tube manometer. State all assumptions needed. (Non-anonymous questionO)

Problem 4 (a) Water from a water reservoir is delivered through a 2-cm pipe to a 200-litre tank as shown in Figure below. The water level (H) is at 2 m above the pipe. Calculate (a) the time it would take to fill the tank and (b) the height difference of the mercury, h in a U-tube manometer. State all assumptions needed. (Non-anonymous questionO)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1. A tank is filled with air at a gauge pressure of 6 bar and 55 °C, determine the specific weight of the air in the tank. True changing with time. Non-wo... AURREREAN ly 6. A Venturimeter having inlet diameter 1.8 cm and throat diameter 0.5 cm. The oil-mercury differential manometer has a reading of 5 cm. Calculate the discharge of an oil of SG=0.9.
Oil of sp.gr. = 0.9 flows through a vertical pipe (upwards). Two points A and B one above the other 40 cm apart in a pipe are connected by a U-tube carrying mercury. If the difference of pressure between A and B is 0.2 kg/cm, 1- Find the reading of the manometer. 2- If the oil flows through a horizontal pipe, find the reading in manometer for the same difference in pressure between A and B. %3D
Q1(b) A multi fluid manometer is shown in Figure Q1(b). Determine the following: (i) Determine height 'h' if the difference in pressure between the two pipes is 15.38 kPa; (ii) Difference in pressure between the two pipelines if both pipes are in the same level. Take density of air = 1kg/m³ and density of water = 1000kg/m³. Oil SG 0.79 Gasoline SG = 0.70 PIPE Air- 45 cm Pipe hcm 22 cm 10 cm `Water `Mercury SG = 13.6
Water [2] the diameter of a cylindrical water tank is Do and its height is H. The tank is filled with water, which is open to the atmosphere. An orifice of diameter D with smooth entrance (i.e., no losses) is open at the bottom. Develop a relation for the time required for the tank (a) to empty halfway and (b) to empty completely. Tak Des Onfice Hole Water out
pls ans asap Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to measure the velocity inside the pipe. Based on manometer reading, the differential gauge is deflected 1.2 meter. If the specific gravity of the manometer fluid is 1.60, the diameter of the pipe, in millimeter (mm), that was used is
(D1) The client is considering the use of a manometer to measure the differential pressurebetween Tank A and Tank B for operational purposes.a) Given:s.g of A = 1.3s.g of B = 1.7s.g of manometric fluid = 1.9h1 = 1.45m, h2 = 0.75m and h = 0.4mExplain how the manometer depicted can be used to find the differential pressure between Tanks A andB. Additionally give two (2) limitations of using a manometer to measure pressure.
If a closed tank contains compressed air and oil (SGoil = 0.90), with a U-tube manometer using mercury (SGHg = 13.6), is connected to the tank as shown in the figure below. For equivalent pressure of Poil = 8387.55 Pa, and Pmercury=28.01736 kPa then the gage ready would be Air Oil Pressure gage kPa (1) h₂ h₂ Open 11₂ (2) Hg 3
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 65 cm above the pipe B. The height of oil in right limb is 35 cm. Also, the mercury level difference is found in right limb as 50 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. -The difference of pressure between two pipes (PA-PB) (Unit is in kPa) = -Equivalent to Water head in mm =
1. In the benzene plant, the pressure drop at some point of a pipeline in which benzene is passing through is measured with a U-tube manometer (Rm,1) as 10 cm (1st situation). The manometer fluid is carbon tetrachloride (CC14). Then, in order to avoid CC14 poisoning, it is decided to add a layer of water to both arms of manometer (2nd situation). So, 4 cm of water is added to the left arm and 8 cm of water is added to right arm. In this new situation, what will be the height difference of manometer fluid (CC14) between the arms of the manometer (Rm,2)? Data: pbenzene=876 kg/m³, pwater=997 kg/m², pccCI4=1587 kg/m³ Benzene Flow Benzene Flow "wright=8cm Rm,1 Rm2 =4cm[ 1 st Situation: Before adding water to manometer's arms 2 nd Situation: After adding water to manometer's arms
A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbon tetrachloride having specific gravity 1.594 under a pressure of 11.772 kPa and pipe B contains oil of sp. gr. 0.8 under a pressure of 11.772 kPa. The pipe lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. a. 31.36 cm of mercury b. 25.11 cm of mercury c. 64.74 cm of mercury d. 13.62 cm of mercury
Q/ A manometer connected to a pipe which contain a liquid A flow at vacuum pressure gauge as shown in Figures. (i) Find the specific gravity of liquid B Figure (i)? (ii) If the end of this manometer is completely evacuated and closed as shown in Figure (ii) find hg? i. ii. PA sp.gr.A PH20 hai he-i p° sp.gr.B ha-i he-i (psi-V) - 1.58 | (Ib/ft³) (ft) (ft) (psi) (ft) (ft) 1.6 62.4 1.5 1.25 14.66 ? 11.5 ? Оpen Closed (i) (ii) Air Air hat PA PA hs-i hs-i hai Liq. B Liq. B Liq. A Liq. A
10. Amicrometer, having a ratio of reservoir to limb areas as 40, was used to determine the pressure in a pipe containing water. Determine the pres- sure in the pipe for manometer reading shown in Fig. 2.45. [Ans. 688.8 mm] Limb Reservoir: Ein 245 50 mm 80 mm