PROBLEM 1: Following figure is related to IED Based Substation Automation. Describe each layer related substation Automation. Also explain the functions of each element in the layers. IED Baed Computer networks for Substation Automation HMIS Modbus TCP/IP Sub-station Operation Center Host N MODBUS RTU IED1 IED2 IED 3 IEDN Cabeling CT/VT Switch CT/VT Switch Power System Environment CT/VT Switch CT/VT Switch Lower Middle Layer Layer Upper Layer

Q: Match the following : List - I List - II a.…

A: There is one match the table question given. There are 4 statements in the list - I and for matching…

Q: Refer to the network diagram file (EOC network diagram.pkt) and answer the following questions.…

A: Here, we have to answer the above questions.

Q: Task 1. Create VLAN’s, enable switchport mode, and assigning VLAN’s interfaces on each switch.…

A: You can logically partition a Local Area Network (LAN) into distinct broadcast domains using a…

Q: A data link layer switch SW1 is connected with four hosts (H1, H2, H3, H4) as shown in figure below:…

A: NOTE: - Since it is a multi-part question, so as per the guidelines only first three parts are…

Q: Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as…

A: Code:

Q: Question 2 The majority of the functions of the link-layer controller's functionality is mplemented…

A: The function of the link-layer controller's  controller located is

Q: QUESTION 3 In an SDN-controlled network, the routing function is? Centralized within the SDN…

A: SDN stands for Software Defined Networking. It is a network architecture which virtualizes the…

Q: Design a star topology consisting of the devices seen in Table 1. 1. Configure the devices using the…

A: given data  Design a star topology consisting of the devices seen in Table 1.1. Configure the…

Q: A data link layer switch SW1 is connected with four hosts (H1, H2, H3, H4) as shown in figure below:…

A: Explanation: 1. ARP is used by network computers to determine the MAC address of the IP address…

Q: The physical layer, in reference to the OSI model, defines a. the virtual circuit interface to…

A: Asked MCQ, The physical layer, in reference to the OSI model, defines...   Physical Layer describes…

Q: Design an implementable routing and bridging solution for the network. Your solution must address…

A: It is defined as a networking device that forwards data packets between computer networks. Routers…

Q: Design an implementable routing and bridging solution for the network. Your solution must address…

A: It is defined as a networking device that forwards data packets between computer networks. Routers…

Q: Consider now, that the two Access Points are within the same ISP, located in two neighboring…

A: The 802.11 convention doesn't separate totally despite the fact that the two ISPs designed their APs…

Q: (c) Discuss in detail “Method 1" over “Method 3" as depicted in Figure 1-3. 2 46-1500 Destination…

A: Solution:--   1)A diagram named as the Switch forwarding method has been given in the     question.…

Q: QUESTION 17 What is true regarding the IEEE 802.11 WLAN standard? a. WLANS operate in the licensed…

A: The 802.11 standard is established by a number of WLAN specifications. It specifies a wireless…

Q: (c) Discuss in detail “Method 3" over “Method 1" as depicted in Figure 1-3. 2 46-1500 Destination…

A: Given below the description about each part in the diagram: Preamble :  informs the receiving system…

Q: .Observe the network diagram and fill in the data for Switch-1 MAC table LAYER 3: 192.168.10.1 LAYER…

A: A way to map each port to the mac address is called the mac address table.   An IP address is a…

Q: in a virtual network, there are three switches k1, k2 and k3. Source P need to communicate with…

A: Bundle Switching and Delays in Computer Network

Q: 6.4-1 Network- and Link-layer addressing: an end-to-end-scenario (1a). Consider the network shown…

A: What is the Source MAC address on the frame at the point(3)? What is  the destination MAC address on…

Q: What is the "Northbound Interface (NBI)" of a Software-Defined Networking (SDN) Controller? How it…

A: Answer: Software Defined Network (SDN): Software-defined networking (SDN) is a newly developing…

Q: STP and Etherchannel Consider the below topology, noting that all the switches have the same…

A: Q1(a) ​​​​​​ From the given topology, Primary Root Bridge = SWC Secondary Root Bridge = SWD…

Q: 6.4-2 Network- and Link-layer addressing: an end-to-end-scenario (1b). Consider the network shown…

A: Here is the answer with an explanation:-

Q: a) Calculate the number of parameters involved in the following Sallow ANN and in the convolutional…

A: i = number of neurons in the input layerh = number of neurons in the hidden layero = number of…

Q: a) Calculate the number of parameters involved in the following Sallow ANN and in the convolutional…

A: The  “lаyers”  in  АNN  аre  rоws  оf  dаtа  роints  hоsted  thrоugh  neurоns  thаt  аll  use  the…

Q: an implementable routing and bridging solution for the network. Your solution must address the…

A: It is defined as Network-to-network connections are what make the Internet possible. The "network…

Q: n Figure 4.0, Router Rl and Switch Sl need to be configured to support router-on-a stick inter…

A: SWITCH CONFIGURATION: Switch#show running-config Building configuration... Current configuration :…

Q: 135. What is the difference between a switch and a hub? a. Switches operate at physical layer while…

A: Given data:- What is the difference between a switch and a hub? a. Switches operate at physical…

Q: In following Figure, assume that the communication is between a processes running at Computer A with…

A: GIVEN:  In the following Figure, assume that the communication is between a process running at…

Q: In following Figure, assume that the communication is between a processes running at Computer A with…

A: Given:   In following Figure, assume that the communication is between a processes running at…

Q: In following Figure, assume that the communication is between a processes running at Computer A with…

A: GIVEN : In following Figure, assume that the communication is between a processes running at…

Q: In following Figure, assume that the communication is between a processes running at Computer A with…

A: Given: In following Figure, assume that the communication is between a processes running at Computer…

Q: True or False: a. Virtualization layer sits between control programs and network operating system…

A: Defined the true and false for the given statements

Q: 17824 bits of data is to be transferred from a station A to station B. Assume a call setup time of…

A: Given: call set up time = 0.01 s hops = 3 Total bits N = 17824 Signal Propagation speed = 200 km/s…

Q: Figure has been attached A) List down the functionality of each layer of a OSI model.( Do not write…

A: Solution: A) Functions of OSI  model: 1.Physical Layer: Line Configuration Data Transmission…

Q: Compare between Repeaters and Bridges in term of: A. OSI Layer  B. How it  operate?

A: Compare between Repeaters and Bridges in term of: A. OSI Layer  B. How it  operate?

Q: Compare between Repeaters and Bridges in term of: A. OSI Layer  B. How it  operate?

A: A.  OSI Layer Repeaters is an electronic device which operates at the physical layer of the OSI…

Q: Compare between Repeaters and Bridges in term of: A. OSI Layer  B. How it  operate?

A: Bridge is a networking device operating at the data link layer (Layer 2) of the OSI model with…

Q: Compare between Repeaters and Bridges in term of: A. OSI Layer  B. How it  operate?

A: Compare between Repeaters and Bridges in term of : A. OSI Layer B. How it operate?

Q: Compare between Repeaters and Bridges in term of: A. OSI Layer B. How it operate?

A: Question Comparee between Repeaters and Bridges in terms of: A. OSI layer B. How it works

Q: a) You have been hired by a startup company to design, plan, and implement an Ethernet network. The…

A: Given: You have been hired by a startup company to design, plan, and implement an Ethernet network.…

Q: Question 3 Examine the given network diagram in Figure 3 and answer the questions. a. Explain the…

A: Answer:)

Q: 4. Answer the following questions based on Layer 3 VLAN Configuration. Ropero Fa0/0 10.10.10. 1/24…

A: According to the information given;- we have to write the configuration as per the instruction…

Q: 1. Consider the following switched Ethernet network with redundant core switches. E S5 B- S1 S3 D-…

A: Spanning Tree Protocol(STP) It is a network protocol which builds a loop-free logical topology for…

Q: A junior network associate had setup Layer 3 switch inter-vlan configuration as depicted in Figure…

A: In this question i have to identify error in setup Layer 3 switch inter-vlan configuration.It…

Q: Assume a system of 32 cells with a cell radius of 1.6 km, a total of 32 cells, a total frequency…

A: Given: Assume a system of 32 cells with a cell radius of 1.6 km, a total of 32 cells, a total…

Q: In following Figure, assume that the communication is between a processes running at Computer A with…

A: The content of packets and frames at the network , DLL and transport layer for each hop

Q: Table 1 OSI Layer Number Layer’s Importance and Network Function TCP Layer/Protocols

A: Table is as follows:

Q: According to the OSI model, the network layer provides the virtual circuit interface to…

A: Required:   According to the OSI model, the network layer provides the virtual circuit interface to…

Q: According to the OSI model, the network layer provides the virtual circuit interface to…

A: OSI Model: Open Systems Interconnection It is a model build on the basis of 7 layers that are used…

Q: According to the OSI model, the network layer provides the virtual circuit interface to…

A: To Do: To write about network layer.