The connection diagram shows multiple gates and the pins assigned to each gate. Forexample, from the datasheet connection diagram of IC 7400, four individual NAND gatescan be observed. Pins 1, 2 and 3 are all related to one of the four NAND gates. For eachgate the top input is assigned the letter A while the bottom input is assigned B and theoutput is assigned the letter Y.The function tables of the ICs are normally given in terms of H (High logic level) and L(Low logic level). Referring to the datasheet function table of IC 7400 shows the fourdifferent input combinations of A and B and the corresponding output Y for one of thefour NAND gates. There is also one more letter assignment that could be found infunction tables, this is the letter X, a don't care assignment. In cases where an X is given,it can be replaced by either an H or L assignment without effecting the resultantfunctionality of the IC. An example of this case can be seen for the function table of IC7402.The IC is an active component that requires power to operate. Two pins are assigned forpower purposes. For all ICs that are going to be used within this lab the bottom left pin isassigned as the ground (GND) while the top right pin is assigned to the input voltage(VCC). The voltage requirement of VCC is +5V. Make sure to power your IC otherwiseyou will not obtain any results.Finally, ICs are electronic devices consisting of multiple gates. The gates within an ICmay fail. It is important to test the gates on the IC before including it within your circuit.To test the gates simply obtain the function table of the gate you are testing. If the gatedoes not operate as per the function table, then verify the other gates before obtaininganother IC.A digital logic simulator is going to be used within this lab. The program is a calledLogisim. Included on all PCs within the lab is the software and a library called IC V8.cir.The library contains the complete set of ICs that is included within the lab. Make sure totake a copy of the software, the library IC V8.cir and the datasheets folder.Pre-lab Task a. Fill in the following the values to complete each truth table of variousgates.Table 1.1InputsA.BOutput of gateAND NOR NANDORXORXNORF2F3F4F5

Question

Accepted Answer

A digital logic simulator is going to be used within this lab. The program is a called Logisim.…

Pre-lab Task a. Fill in the following the values to complete each truth table of various gates. Table 1.1 Inputs Output of gate A OR AND NOR NAND XOR XNOR F1 F2 F3 F4 F5 F6