please solve parts d, e and fd in the picture e) The value of K when the root loci intersect the imaginary axis f) Plot the root loci for the closed loop system Q.3 For closed loop control system withG(s)=K(s+9)s(s²+4s+11)andH(s)=1a) Determine the zeros and poles of the systemb) Determine the root loci on the real axisc) Determine the asymptotes the root locid) Find the value of K to keep the system stable

RH criteria help to find the stability of closed loop system with the help of OLTF gain It gives a…

Answered: please solve parts d, e and f d in the…

please solve parts d, e and f d in the picture e) The value of K when the root loci intersect the imaginary axis f) Plot the root loci for the closed loop system

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Related questions

Q: 3. The shift keying technique with a minimum requirer a. ASK b. PSK c. FSK d. None of the above.

A: here none of the above option is correct the MSK is used with minimum requirements.

Q: Use mesh analysis 2 + 50x 5 TOY to solve for i at 5. 4

Q: 2) Goy(+ Find i, and i₂ 10 7 6 4 8 U2 Soy 7

Q: 3.2 For the circuit in Fig. 3.51, obtain Up and Uz. ΖΩ 12 Α VI 2/2 10 Ω www 5Ω 4Ω Μ 64

Q: 1- Find the transfer function, for the network shown in Figure 1. 1H 1H 000 V₁ 1F 1F 10

Q: O Consider the phase-shift oscillator in Figure P15.30. (a) Derive the expres- sion for the…

Q: 4.41 Find the Thevenin and Norton equivalents at term nals a-b of the circuit shown in Fig. 4.108.…

A: In this question, We need to determine the Thevenin equivalent and norton equivalent circuit across…

Q: What is dc and what is ac ?

A: Electricity can flow in two directions, alternating current (AC) or direct current (DC). The passage…

Q: B- Select the best answer from multiple choices 1. The better multiplexing technique is: a- TDM. b.…

A: MULTIPLEXING : Multiplexing is the process of combining many signals into a single signal and…

Q: 1. A 208Y/120-volt feeder in a commercial building supplies lighting and receptacle loads as well as…

A: Here in this Q. the calculations of load of the motor in VA is to be done.

Q: 3.52 Use mesh anals to find i1, 12, and is in the circuit of Fig. 3.9 ML 12 292 8 Ω 3 A 12 V (+1)…

A: In this question, We need to calculate the current i1 , i2 and i3 as shown the circuit using the…

Q: The area of impulse functi equal when t=0 O Infinity Zero O Option 4 1 O O O O

A: In this question we will write about area of unit impulse....

Q: A balanced delta-connected load with impedance per phase of 30230° 2 is connected to an abc-sequence…

A: Complex power show the direction of current. Reactive power show the lagging power factor means the…

Q: 4.38 Apply Theverin's theorem to find V in the circuit of Fig. 4.13. 4Ω ΤΩ ww 3 Α 16 Ω 5Ω 12 V 10 Ω

Q: 2. A series circuit consisting of a variable resistor in series with a capacitor of 80 μF capacitor…

A: The required parameters can be calculated by using the total impedance of the series connected…

Q: 1. Perform the required integrations to get the result in the notes [1/₁³ [²²-½ e²t dr [²²] et dt Ze…

Q: What is the total impedance of circuit? 240 Ω j95 Ω Α) 227.852 – 18.31° Ω C) 419<0° Ω 784 Ω Β)…

A: In this question we need to find a total impedance of the given circuit.

Q: A 250 kVA,480 V,3-phase,4 pole, 60Hz synchronous generator with a synchronous reactance of 099…

A: The per-phase equivalent voltage of the synchronous generator is, Vt=E3E=480 VVt=4803Vt=277.13 V…

Q: Refer to the figure. Determine the minimum value of lg that will produce saturation. (assume…

A: When the transistor is in saturation, voltage across collector to emitter(VCE)=0.2V is 0.2V

Q: 1. This specialized cable or other structure designed to conduct electromagnetic waves in a…

A: To fill the answers

Q: If a current of 9.6-A flows through a long wire of radius 0.0003 m, what is the flux density…

A: Given,Current, I=9.6 ARadius, R=0.0003 mDistance, D=0.045 m

Q: Determine the reading of the two wattmeters

A: Active Power- It is power utilized by the load.Reactive power- It is the power which remains within…

Q: 7. A dc electric motor consumes 36 MJ when con- nected to a 250 V supply for 1 hour. Find the power…

Q: The B-flux is determined to be 52.35 mWb. If the material that surrounds this flux has a…

Q: Q.4/A/ Fill in The Blanks: 1- A salient pole synchronous motor is running at no load. Its field…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: mixer with a noise figure of 20 dB is preceded by an amplifier with a noise figure of 9 dB and

A: In this question we will find noise figure referred to input....

Q: 3 Given: F3(WXY) = (W+X)(W'+Y+X') Convert F3 into a form suitable for an All-NAND implementation…

Q: E7.4 Use the differential equation approach to find i() for t> 0 in Fig. E7.4. 3 k 2kf 6 mH 6V…

Q: Calculate the inductance and stored energy

A: Inductor- Inductor is one of the passive element which can't act like source it can only utilize…

Q: After a long time in position-a, the switch in the circuit shown Fig.5 is change to position-b at…

Q: Apply KCL at node Vc(S) ve(s)-/+ vess+ 60)/2 = 1 vc(s)-¹% Vc(S) vc(s)-/s 5S 10 10 3 $5 S vc (S) 1₁ +…

A: All we need is manipulation Just replace the terms, we will get desired terms at both terms.

Q: 1. Determine the values of Vs and Pvs. (if current through R₂ = 10 mA and R³ = 25 mA). Note: Use…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Q2/A/ What are the conditions for satisfying parallel operation of single phase transformer? Deduce…

Q: 23/A) A 1000-VA 230/115-V transformer has been tested to determine its equivalent reunt. The results…

Q: Q20. 1) Determine the finng angle required to deliv 1000W to the load. 2) Determine the RMS source…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: given a line charge distribution of (10 C/m) on z axis, find VAB where A(3, 1/2,1) and B(4, z, 6).

Q: f. oooo M x(1) f(n)

A: In mechanical network interconnection of mechanical network along a circuit diagram. In mechanical…

Q: 1. Determine the impedance of the circuit of Figure 4.1 at frequencies of 100 Hz, 10 kHz and 1 MHz.…

Q: 7. A dc electric motor consumes 36 MJ when con- nected to a 250 V supply for 1 hour. Find the power…

A: Given a DC electric motor with, Energy consumes, E = 36 MJ Supply voltage, V = 250 V Time, t = 1…

Q: 440 V, 60 Hz generatorsuppliestwo parallel-connected loads A and B,. Load A draws an apparent power…

A: In this question two parallel connected load given.....We have to find out kVA supplied by…

Q: For the given circuit, Vin(20,-20), R-R KQ. What is the maximum and minimum values of Vout? Plot the…

A: Brief description: In the above given circuit diagram we need to know status of diode. After finding…

Q: Find the total power consumed by the circuit 2 ↑) 50 A 3 M

A: Given:

Q: 4 Find the transfer function of digital filter shown K(n) x(n). (E) (2) y(n) 2 Z ½/₂ -1/4

A: We need to find out the transfer function for given system .

Q: Find vo(t) in the circuit of Fig. 16.7. Assume v,(0) = 5 V. 1052 www 10e 'u(1) V %(1) : 0.1 F 28(1)…

Q: Solve the total power of the entire circuit(in watts) given: r1= 2 ohms r2= 35 ohms E= 91 V

A: The current in series element are equal. The real part of complex power is real power and imaginary…

Q: A 250 V shunt generator has a full load armature current of 40 A. Under this condition the losses…

A: a) The given generator is a shunt generator. The full load copper loss is known, the armature…

Q: What is the SOP function for inputs A=1 B=0 C=1?

A: In the given problem three inputs are given so that eight combinations are possible.

Q: Determine the current through a 4Ω resistor connected to a voltage source Vs = 24sin45t V

A: We need to find current for given voltage for given resistor .

Q: 2.7) True or False: Directional antennas provide poor efficiency of power transmission. 2.8) Fill in…

A: Given True or false question and few fill in the blanks based on antenna theory. Please find the…

Q: Instructions: Solve the following circuit problems and show your solution. 1. Determine the values…

Concept explainers

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.

Question

please solve parts d, e and f

d in the picture

e) The value of K when the root loci intersect the imaginary axis

f) Plot the root loci for the closed loop system

Q.3 For closed loop control system with
G(s)
=
K(s+9)
s(s²+4s+11)
and
H(s)=1
a) Determine the zeros and poles of the system
b) Determine the root loci on the real axis
c) Determine the asymptotes the root loci
d) Find the value of K to keep the system stable

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You have an unfair six-sided die, where the probabilities of rolling each number are asfollows:P(1) = 0.1, P(2) = 0.2, P(3) = 0.3, P(4) = 0.15, P(5) = 0.1, P(6) = 0.15Calculate the mean and variance of this die
A certain servomechanism system has dynamics dominated by a pair of complex poles and no finite zeros. For this system, do the following.
4. Why the O.C.C. characteristic is non-linear?
What's the maximum percent overshoot for this system with its closed-loop poles as shown? Jo Select one: O a. 64% O b. 15.7% O c. 14.9% O d. 33.6% O e. 21.5%
Comment briefly on the relationship between input and output power at varying excitation levels and on the relationship between excitation and power factor or reactive power, when the synchronous machine is connected to an infinite busbar
Find the values of K₁ and K₂ to yield a peak time of 1.5 seconds and a settling time of 3.2 seconds for the closed-loop system's step response. R(s) + OK₁=0.8984, K₂=0.04 OK₁=0.5197, K₂=0.045 OK₁=0.5949, K₂=0.05 ⒸK₁=0.4218, K₂=0.06 K₁ 10 s(s+ 2) K₂s C(s)
What are interpoles, and what is their purpose?
Moving to another question will save this response. Question 6 A shunt generator delivers 350A at 230 V and the resistance of the shunt field and armature are 50 Q and 0.03 Q respectively. the generated e.m.f. equals to 239.138 V 243.638 V 235.138 V 240.638 V A Moving to another question will save this response. I'm Cortana. Ask me anything. DELL
Nyquist criterion, how many closed loop poles are in the right half plane (1st picture) Nyquist criterion, how counter-clockwise encirclements of -1 made mapping are in the system (2nd picture)
10. If only P-mode control is used in a closed-loop control system, the proportional control will cause the system to have smaller steady-state error ess. function (a) p = 50 + 2ep (b) p = 50+ 12ep
The diagram for the pantograph and catenary coupling shown in Figure 2, where the catenary is represented by the spring, Kave and fup(t) is the upward force applied to the pantograph under active control. ycat(t) is the catenary displacement. Determine the transfer function G(s) = Ycat(s) / Fup(s) .
The economic p.f. is the point at which the economic benefits of adding shunt capacitors just equal to the cost of capacitor True False