Please select all that applies. The possible failure modes for bolted joints are: shear in the bolts bearning of the bolts on the connected material tension in the connected parts torsion in the connected parts

explain the operational difference between CV joints and universal joints. (50-80 words)

17- What welded joints is the gap gauge used? (ISO 17637) for fillets weld joint a- b- for butt weld joints c- responses a) and b) d- the gauge specified is not used according to ISO 17637 18- Specify what of the defects listed below is not allowed irrespective of the size and quality level according to ISO 5817: a- lack of fusion b- incomplete root penetration c- cracks d- Both a &c are correct 19- Specify the maximum allowable angle of weld toe fillet welding when testing to the quality level D according to ISO 5817: a- 90 degrees b- 100 degrees c- 110 degrees d- 120 degrees 20- How is the defect like "interdendritic shrinkage" normally oriented relative to the weld surface (ISO 6520-1)? a- perpendicular to the weld face b- parallel to the weld face c- at the angle of 45 degrees to the weld face d-correct are all the responses above

Label all links starting with "1" and all joints starting with "A". Include whether the joint is a half joint or full joint as well as the type of joint.

What is the effect of joint spacing on joint tensile strength?

Q-The lap distance in different types of bonding is equal to the horizontal distance between two Perpend joint in the rows sequential and must be equal to half the width of the brick minus half width of the Perpend joint and the value was .. and it must be applied to prevent the continues of perpend joints in the sequential rows. five point five cm (5.50 cm) five point seven five cm (5.75 cm) Non of them five only (5.00 cm) five point two five cm (5.05 cm)

11. According to the Goodman criteria, how should the fatigue factor of safety change for a tension joint change if the alternating stress increases by 50%? A. It must be decreased by 33%. B. It must be decreased by 50%. C. It must be increased by 50%. D. It must be increased by 33%.

Show Links/Joints in diagram. Need within 15-30min with correct answer (Don't hold for long time )

The relation between joint and frame is J = (2N - 3) (Where N - number of members, J - Number of Joints ) Sentence is : Select one: True False

For applying the method of joint at joints the forces need to be concurrent؟ Select one: True False