Part A Suppose that L = 6.6 in. (Figure 1) Locate the centroid (, j). Express your answers using three significant figures separated by a comma. vec in. Submit Request Answer Provide Feedback Figure 1 of 1> L H MacBook Air

Q: A truck with axle loads of 20 kN and 60 kN on a wheel base of 5 m rolls across a 13-m span. Compute…

A:

Q: A car weighing 3000 lb, with a wheel base of 9 ft, carries 1400 lb of its load on the front wheels.…

A: Given data,  Car weight = 3000 lb Wheel base = 9 ft Front wheel load = 1400 ob Span = 14 ft   To…

Q: Using both Three-Method Equation and Slope Deflection Method. Determine

A:

Q: What is the equivalent coefficient of permeability (k) for soil layers of k2 and k3? where k2= 1.75…

A: To find equivalent permeability

Q: A circular shaft AB of radius Ras shown in the figure below is subjected to torsion T at the free…

A: To find T1/T

Q: 1. Liquid Carbon Tetrachloride (CCL4) having a volume of 387 liters has a mass of 600kg. Determine…

A: As per the guidelines, we are supposed to solve 1st question only, kindly repost the other part of…

Q: P,=40k P = 80k P- 20k PL = 40k A simply supported beam is loaded at 5 ft and 15 ft from the left…

A: L = 20feet  For A992 Fy = 50ksi

Q: 2. Locate the centroid of the given plane. 6 in- 6 in. 3 in. 6 in. 6 in. 38 in. 16 in. Fig. P5.4…

A:

Q: 554. What safe value of W can be applied to the beam loaded as n in Fig. P-554 if o, < 60 MPa and o,…

A:

Q: A concrete beam of rectangular cross-section of size 120 mm (width) and 200 mm (depth) is…

A: Given data: Width = 120 mm Depth = 200 mm Pre-stressed force = 150 kN Eccentricity = 20 mm (below…

Q: Four wheel loads rolls as a unit across a 18-m span. The loads are 40 kN, 40 kN, 20 kN, and 10 kN…

A:

Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A-15 kN:

A:

Q: 521.. A channel width is 0.312 m. A venture flume having a throat of 5.6 inch was set in the…

A: In this question, we will use the relation between the metre discharge and the theoretical…

Q: A planimeter measures the area of figure, traversed clockwise with anchor point inside and tracking…

A:

Q: Water is transported in a pipe, at an average flow rate of Q = 80 L/s. Calculate the pressure…

A: Solution of a part a and part b

Q: 24,00,000 litres of water passes through a sedimentation tank which has rate of flow 300 cubic meter…

A: Given data,  Volume of sedimentation tank = 24,00,000 litre   =2400 m³          Flow rate = 300…

Q: what do they mean asset mapping

A: Need to explain Asset mapping

Q: 30 cm well completely penetrates an unconfined aquifer of saturated depth 40 m. After a long period…

A:

Q: 2. A centrifugal pump delivers 700 L/s of water against an elevation head of 40m when rotating at…

A:

Q: 24,00,000 litres of water passes through a sedimentation tank which has rate of flow 300 cubic meter…

A:

Q: Suppose that a1.69 m and bs13 m. (Egute D Part A Determine the moment of inertia for the shaded area…

A: Given:- A shaded area is given with equation y = x1/2  The value of a = 1.69 m  The value of b = 1.3…

Q: Solve the capacity of a 4.2-m steel column, pin-supported at both ends, having the cross section as…

A: Load carrying capacity = Cross Sectional area * Fy Cross-sectional area = (2*300*45)+(300*55)= 43500…

Q: Three wheel loads rolls as a unit across a 12-m span! The loads are A 15 kN; B = 25 kN, %3D 2 m to…

A:

Q: P kN W= 7 kn/m w kN/m P= 52 8m 6m 2m

A:

Q: Using Centroid by Composite Shapes, determine the x- and y-coordinates of the centroid of the shaded…

A: To find out the x and y coordinates of centroid of shaded area.

Q: Three wheel loads rolls as a unit across a 12-m span, The loads are A+ 15 kN: B 25 kN. 2 m to the…

A: PC = 15KN PD = 25KN PE = 50KN

Q: Determine the moment of inertia (Ix and Iy) of the T-section of a cast-iron beam as shown with…

A:

Q: The angular velocity of the disk is defined by ω = (5t2 + 2) rad/s, where t is in seconds. Determine…

A: Given: Angular velocity= (5t^2+2) rad/s Radius, r= 0.8 m

Q: Two reservoirs are connected by a pipeline consisting of pipe 1, pipe 2, pipe 3

A:

Q: PROBLEM he centroid of the T-section shown is 1.6 ches above the base and x is 10. What hould be the…

A:

Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A = 15 kN; B = 25 %3D kN, 2 m to…

A:

Q: A car weighing 4000 lb, with a wheel base of 9 ft, carries 1600 lb of its load on the front wheels.…

A: To find the maximum moment

Q: A car weighing 4000 lb, with a wheel base of 9 ft, carries 1300 lb of its load on the front wheels.…

A: To find the maximum shear in lb

Q: What is the equivalent coefficient of permeability (k) for soil layers of k2 and k3? where k2= 1.75…

A: ASKED: To determine the equivalent coefficient of permeability (k) for soil layers of k2 and and k3…

Q: Four wheel loads rolls as a unit across a 16-m span. The loads are 40 kN, 30 kN, 30 kN, and 10 kN…

A:

Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A = 15 kN; B = 25 kN, 2 m to the…

A:

Q: The centroid of the T-section shown is 2.7 inches above the base and x is 8. What should be the…

A: Use formula of centroid from base.

Q: Find the centroid and the moment of inertia with respect to the x-axis of the following plane…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A = 15 kN; B 25 kN, 2 m to the…

A:

Q: Find the reaction at points A and B below: 50k/ ft 40 kip 50 kips- ft A B - 4.5 ft- 5ft- 8 ft

A:

Q: B Pin connected Pin connected Roller

A:

Q: Two reservoirs are connected by a pipeline consisting of pipe 1, pipe 2, pipe 3 connected in series…

A:

Q: Members, determine the following if the External Load F is equal to the magnitude of the x -…

A:

Q: For the given truss system and its loading: which of the first 4 following statements is FALSE? 4m…

A: Since the system is redundant to 2 degree so it is indeterminate to 2 degree Top members of the…

Q: Three wheel loads rolls as a unit across a 12-m span. The loads are A = 15 kN; B = 25 kN, 2 m to the…

A:

Q: Three wheel loads rolls as aunilacrossa 12 spt The loads areA 15 kN; B-25 kN. 2 m to the right of A…

A:

Q: Determine the moment of inertia (Ix and ly) of the T-section of a cast-iron beam as shown with…

A: Parallel axis theoreom is applied to transfer moment of inertia about refrence line to shift to the…

Q: Wnat is the relevance of wood as a construction material in an age that mostly use concrete, iron,…

A: Given : Building materials To find:  Relevance of wood as construction material

Q: In figure, if K ent.=0.6, Kexit=1,- Kelbow=0.75, Kvalve= 10, V=7 ft/s, diameter =0.5 ft, the minor…

A:

Q: A truck with axle loads of 30 kN and 60 kN on a wheel base of 5 m rolls across a 12-m span. Compute…

A: Given data Wheel load = 30 KN and 60 KN  Wheel base = 5m  Span = 12 m

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.