Part AAssuming the final solution will be diluted to 1.00 L, how much more HOl should you add to achieve the desired pH?Express your answer to three significant figures and include the appropriate units.> View Available Hint(s)HAValuemlSubmitPrevious AnswersX Incorrect; Try Again; 4 attempts remainingProvide FeedbackNext > Imagine that you are in chemistry lab and need tomake 1.00 L of a solution with a pH of 2.40.You have in front ofyou100 mL of 7.00 × 10-²mol L-1HCI,• 100 mL of 5.00 x 10-2mol L-1NaOH, and• plenty of distilled water.You start to add HCl to a beaker of water whensomeone asks you a question. When you return toyour dilution, you accidentally grab the wrongcylinder and add some NaOH. Once you realizeyour error, you assess the situation. You have 83.0mL of HCl and 86.0 mL of NaOH left in theiroriginal containers.Provic

The initial amount of HCl 100 mL and 0.07 M. Initial amount of NaOH = 100 mL and 0.05 M. Volume of…

Part A Assuming the final solution will be diluted to 1.00 L, how much more HCl should you add to achieve the desired pH? Express your answer to three significant figures and include the appropriate units. > View Available Hint(s) µA Value ml

Part A Assuming the final solution will be diluted to 1.00 L, how much more HCl should you add to achieve the desired pH? Express your answer to three significant figures and include the appropriate units. > View Available Hint(s) µA Value ml

Living By Chemistry: First Edition Textbook

1st Edition

ISBN:9781559539418

Author:Angelica Stacy

Publisher:Angelica Stacy

ChapterU4: Toxins: Stoichiometry, Solution Chemistry, And Acids And Bases

SectionU4.22: Drip Drop: Titration

Problem 6E

See similar textbooks

Similar questions

Use the same symbols as in Question 61 ( = anion, =OH) for the box below. (a) Fill in a similar box (representing one liter of the same solution) after 2 mol of H+ (2) have been added. Indicate whether the resulting solution is an acid, base, or buffer. (b) Follow the directions of part (a) for the resulting solution after 2 mol of OH- (2 ) have been added. (c) Follow the directions of part (a) for the resulting solution after 5 mol of OH- (5 ) have been added. (Hint: Write the equation for the reaction before you draw the results.)
Using the diagrams shown in Problem 10-117, which of the solutions would have the greatest buffer capacity, that is, greatest protection against pH change, when the following occurs? a. A strong acid is added to the solution. b. A strong base is added to the solution.
Calculate the pH of each of the following solutions. (a) 10.0 mL of 0.300 M hydrofluoric acid plus 30.0 mL of 0.100 M sodium hydroxide (b) 100.0 mL of 0.250 M ammonia plus 50.0 mL of 0.100 M hydrochloric acid (c) 25.0 mL of 0.200 M sulfuric acid plus 50.0 mL of 0.400 M sodium hydroxide
What is a salt? List some anions that behave as weak bases in water. List some anions that have no basic properties in water. List some cations that behave as weak acids in water. List some cations that have no acidic properties in water. Using these lists, give some formulas for salts that have only weak base properties in water. What strategy would you use to solve for the pH of these basic salt solutions? Identify some salts that have only weak acid properties in water. What strategy would you use to solve for the pH of these acidic salt solutions? Identify some salts that have no acidic or basic properties in water (produce neutral solutions). When a salt contains both a weak acid ion and a weak base ion, how do you predict whether the solution pH is acidic, basic, or neutral?
Two students were asked to determine the Kb of an unknown base. They were given a bottle with a solution in it. The bottle was labeled aqueous solution of a monoprotic strong acid. They were also given a pH meter, a buret, and an appropriate indicator. They reported the following data: volume of acid required for neutralization = 21.0 mL pH after 7.00 mL of strong acid added = 8.95 Use the students' data to determme the Kb of the unknown base.
Consider 0.10 M solutions of the following compound: AlCl3, NaCN, KOH, CsClO4, and NaF. Place these solutions in order of increasing pH.
Aqueous Solutions of Acids, Bases, and Salts a For each of the following salts, write the reaction that occurs when it dissociates in water: NaCl(s), NaCN(s), KClO2(s), NH4NO3(s), KBr(aq), and NaF(s). b Consider each of the reactions that you wrote above, and identify the aqueous ions that could be proton donors (acids) or proton acceptors (bases). Briefly explain how you decided which ions to choose. c For each of the acids and bases that you identified in pan b, write the chemical reaction it can undergo in aqueous solution (its reaction with water). d Are there any reactions that you have written above that you anticipate will occur to such an extent that the pH of the solution will be affected? As pan of your answer, be sure to explain how you decided. e Assume that in each case above, 0.01 mol of the salt was dissolved in enough water at 25C to make 1.0 L of solution. In each case what additional information would you need in order to calculate the pH? If there are cases where no additional information is required, be sure to state that as well. f Say you take 0.01 mol of NH4CN and dissolve it in enough water at 25C to make 1.0 L of solution. Using chemical reactions and words, explain how you would go about determining what effect this salt will have on the pH of the solution. Be sure to list any additional information you would need to arrive at an answer.
The pH of a 0.10-M solution of caffeine is 11.16. Determine Kb for caffeine from these data: C8H10N4O2(aq)+H2O(l)C8H10N4O2H+(aq)+OH(aq)
. Strong buses are bases that completely ionize in water to produce hydroxide ion, OH-. The strong bases include the hydroxides of the Group I elements. For example, if 1.0 mole of NaOH is dissolved per liter, the concentration of OH ion is 1.0 M. Calculate the [OH-], pOH, and pH for each of the following strong base solutions. a. 1.10 M NaOH b. 2.0104M KOH c. 6.2103M CsOH d. 0.0001 M NaOH
For oxyacids, how does acid strength depend on a. the strength of the bond to the acidic hydrogen atom? b. the electronegativity of the element bonded to the oxygen atom that bears the acidic hydrogen? c. the number of oxygen atoms? How does the strength of a conjugate base depend on these factors? What type of solution forms when a nonmetal oxide dissolves in water? Give an example of such an oxide. What type of solution forms when a metal oxide dissolves in water? Give an example of such an oxide.
A 10.0-mL sample of an HCl solution has a pH of 2.000. What volume of water must be added to change the pH to 4.000?
Strong Acids, Weak Acids, and pH Two 0.10-mol samples of the hypothetical monoprotic acids HA(aq) and HB(aq) are used to prepare 1.0-L stock solutions of each acid. a Write the chemical reactions for these acids in water. What are the concentrations of the two acid solutions? b One of these acids is a strong acid, and one is weak. What could you measure that would tell you which acid was strong and which was weak? c Say that the HA(aq) solution has a pH of 3.7. Is this the stronger of the two acids? How did you arrive at your answer? d What is the concentration of A(aq) in the HA solution described in part c? e If HB(aq) is a strong acid, what is the hydronium-ion concentration? f In the solution of HB(aq), which of the following would you expect to be in the greatest concentration: H3O+(aq), B(aq), HB(aq), or OH(aq)? How did you decide? g In the solution of HA(aq), which of the following would you expect to be in the greatest concentration: H3O+(aq), A+(aq), HA(aq), or OH(aq)? How did you decide? h Say you add 1.0 L of pure water to a solution of HB. Would this water addition make the solution more acidic, make it less acidic, or not change the acidity of the original solution? Be sure to fully justify your answer. i You prepare a 1.0-L solution of HA. You then take a 200-mL sample of this solution and place it into a separate container. Would this 200 mL sample be more acidic, be less acidic, or have the same acidity as the original 1.0-L solution of HA(aq)? Be sure to support your answer.