Part 2: If the circuit that is shown in Figure 4 is modified as shown in Figure 5: L1 680mH V1 4:7µF R1 120 Vrms 4700 60 Hz C2 1.5pF Figure 5 RLC Circuit Calculate: A) The total Impedance (Z) B) The phase angle. C) The total current I D) The voltage dropped across C1 using two methods. Compare between the two values. E) The voltage dropped across R1. F) Verify KVL on around the closed loop 1. G) What is your grandfather name.

Part 2: If the circuit that is shown in Figure 4 is modified as shown in Figure 5: L1 680mH V1 4:7µF R1 120 Vrms 4700 60 Hz C2 1.5pF Figure 5 RLC Circuit Calculate: A) The total Impedance (Z) B) The phase angle. C) The total current I D) The voltage dropped across C1 using two methods. Compare between the two values. E) The voltage dropped across R1. F) Verify KVL on around the closed loop 1. G) What is your grandfather name.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

4) Determine the value of voltage across resistor and capacitor5) Convert in rms values
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
please help with this circuits problem
In the given circuit, a step down transformer with an RMS voltage as 110V /11-0-11 V is used with RL = 1 KO. Assume diode as Germanium and the input frequency is F= 50HZ. D, CT Vin RL D2 1- Name the given circuit. 2- Find The PIV. 3- Find Current trough load resistance. 4- Draw the Input and Output wave forms. all
In a series circuit with the following devices to a 230volts 60Hz supply with a resistor in the range of 300 ohms and 990 ohms. What are the steps in calculating the impedance ...
What's the rise time for this system with its closed-loop poles as shown? 14 -6 -4 12 -j6 Select one: a. 0.607 sec b. 3.14 sec C. 1.80 sec d. 0.254 seC e. 0.554 sec
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
Q18. An AC waveform is shown in figure B3. 4 10 20 30 40 50 70 100 Time (ms) 110 -2 -3 -4 -5 Figure B3 i) For the above waveform, determine a. Peak-to-peak voltage b. Time period c. Frequency ii) For the above waveform, determine a. Peak Factor b. Form Factor
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce
An inductor of 150hms and resistance of 10 Ohms are connected in series to a 230V, 50 Hz ac supply. Determine the active and reactive power and power factor in the circuit.
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7