Paralleling of two generator step by step
Q: A radio receiver consists of an RF amplifier with a power gain of 25 dB and a noise figure of 11 dB.…
A: Given: G1=25 dB,G2=15 dB and G3=20 dB.NF1=11 dB, NF2=15 dB and NF3=15 dB. Required: Equivalent…
Q: Question # 1: Find the Laplace transform for f(t) = t e-St Question # 2: Find the inverse Laplace…
A: Given 1) ft=te5t2) Fs=10ss+2s+32
Q: A Thevenin Equivalent circuit is: An equivalent circuit with a voltage source, A) Vth, in series…
A: We need to select correct option for thevenin equivalent circuit .
Q: (a) Determine the power and the rms value for the signal x(t) shown in the Figure below. (b) Sketch…
A:
Q: Norton's Equivalent circuit consists of: A) A current source in series with a resistor. B A current…
A:
Q: Problem 2 (Divergence theorem) Given A = kR³ag, determine whether the divergence theorem holds for…
A: Introduction: The divergence theorem states that "the area integral of the normal components of a…
Q: Consider the digital control system shown below. Plot the root loci as the gain K is varied from 0…
A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…
Q: R₁ Vcc Q₁ Vout 7 Rout Determine Vout, Rin & Rost (include rol & loz for all three calculations)
A:
Q: amp current is flowing through 4 ohm resistor what will be power absorbed by the resistor.
A:
Q: Problem-11 A 3-phase, 400 V supply is connected to a 3-phase star connected balanced load. The line…
A: Given- Load supplied P = 12 kW = 12000 W, Line voltage , VL=400 V, Line current, IL= 20 A, To Find -…
Q: Give R₁ = 602, and R₂ = 11 02. Find the current i₁. R₂ O a. Ob. www O C. 2.2 A 1.8 A 1.94 A 2 A FD V…
A: Given circuit: An, R1=6 Ω,R2=11 Ω.
Q: 1. Determine the frequency deviation and carrier swing for a frequency-modulated (FM) signal which…
A: We need to analyse the given frequency modulated signal
Q: CES Question 8 Find the equivalent resistance of the circuit in the figure at the terminals A-B. 0…
A:
Q: 4 Electric power is to be generated by installing a hydraulic turbine-generator at a site 70 m below…
A:
Q: Q5: a) Find the bandwidth efficiency of 16-PSK modulation system, If 180 kHz of bandwidth is…
A:
Q: H.W3]: For the circuit shown below; find to? R₁ = 1K₁₂², R₁₂ = 2K₁2 R₂ = 3kr, Re=9kr Ans: Vo= 6v₁…
A: We need to find out the output voltage for given circuit
Q: An RLC series resonant circuit has a resonance frequency of 1.5 MHz and a bandwidth of 10 kHz. If C…
A: Given, A RLC series resonant circuit has. Resonance frequency, fo=1.5 MHz. Bandwidth, B.W.=10 kHz.…
Q: Suppose that the current entering the positive terminal of an element is 4A. The total charge…
A: Given: The current is, i=4 A. Time t=0 s to t=3 s.
Q: Design an SCR circuit that could give a 75⁰ degrees conduction angle and 105⁰ firing delay angle.…
A: Given,To design a SCR circuit,The conduction angle is 75°.andThe firing delay angle is 105°.
Q: 5V 9 (+1) し 1052 وما h 6V + 72 с 9 92 +- -8√ 822 +7V
A: We need to find out the value of node voltage for given circuit
Q: Special Procedure In figure 2.4 (same circuit as figure 2.1), using the Resistance Mode of the…
A: Given
Q: what is the answer for these question? Pls answer these. Thank you
A: From the above circuit the various components are as: Fuse, key, transformer, resistance, and diode.…
Q: To design a switching network that select one of 6 numbers (X, Y, W, L, M, N) of 7- input data…
A: MULTIPLEXER: 1. A multiplexer is indeed a combinational logic circuit that has a single output line,…
Q: A coil having inductance of 0.04 H is connected across 50 hertz AC supply. Calculate the inductive…
A:
Q: ander Q1: In the single-side band (SSB) amplitude modulation system, the carrier c(t)= 10 cos…
A:
Q: A 35 A current flows through a 47 Q resistor. What is the voltage across the resistor? Ex: 540 V
A: Given, Current, I=35 A. Resistance, R=47 Ω.
Q: Q2) Select the correct answer: 1- The signal y(t)=x(-2t) is a- shifted and compressed, b- reflected…
A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the…
Q: A branch circuit consists of five (5) convenience outlets. Determine the size of the conductor to be…
A: Given information, A branch circuit has five convenience outlets. We need to determine the size of…
Q: 2. A short-sbunt compound generator ष 30A delivers a load current at 220 volts, and has an armature,…
A:
Q: =Use G (s) = CO R(a) 11 to find the response, c(t) to an input, r(t) = u(t), a unit step, assuming…
A:
Q: Use G (s) = R(a) = to find the response, c(t) to an input, r(t) = u(t), a unit step, assuming zero…
A: Given that G(s) = CsRs=1s(s+5) We have to find the response c(t) to an input r(t) = u(t) with…
Q: Two perfectly matched silicon transistor are connected as shown in the figure. Assuming the ß of the…
A: Given: R = 1kΩVBE = 0.7 V β same for both IR = 0-0.7-(-5)1kΩIR = 4.31kΩIR = 4.3 × 10-3 AmpIR = 4.3…
Q: Q.2. In order to find the meanings of the following words, which entries should you look for in the…
A: SOLUTION Given--> 1- visited --------…
Q: QUESTION 4 Find the mesh currents i1, 12 and 13, and the resistor R in the circuit below. Show all…
A:
Q: B- If x(t) = u(t), find the Laplace transform of x(2t), and x(-t).
A: We need to find out Laplace transform of given signal
Q: How do you convert a current source in parallel with a resistor with infinite resistance to a…
A: We need to select correct option for given statement
Q: Q2) Tick the correct answer for the following statements 1. An ideal transformer is connected to a…
A: Given data, Turn ratio, 1:2 Primary voltage, V1=50 V. Load resistance RL=50 Ω.
Q: I. Fill in the blanks. Write your answer in the space provided. 1. What is the numerical equivalent…
A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…
Q: Which of the PLC instruction can operate as astable or multivibrator and explain its operation?
A: PLC System: An industrial computer control system called a PROGRAMMABLE LOGIC CONTROLLER (PLC)…
Q: Using the rules of Boolean algebra, simplify the following expression. F=BC+ABC+AB+ABC A. F-BC+AB+BC…
A: Given Boolean expression, F=B.C+A.B.C+A.B+A.B.C
Q: A 250 V, 4-pole, wave-wound d.c. series motor has 782 conductors on its armature. It has armature…
A:
Q: Q3-Determine the stability and the causality for the LTI systems with the following impulse…
A:
Q: Convolve the spatial impulse response and the input signal h(n₁, n₂) = . (0, x (n₁, n₂) (n₁, n₂) =…
A:
Q: op-Amp circuit that produce output given by V₂ = -(4√₁ + √₂ +0:1√₂) if v₁ = 2 sin wt ; V₂ = 5V, and…
A:
Q: The 110V output of a transformer is applied to a 2202 resistive circuit, causing 0.22Amps to flow in…
A: According to question, V2=110 VR2=22 ΩI1=0.22 A
Q: Choose the correct answer. 1. A fluxgate magnetometer allows a robot to locate itself on the basis…
A: Solution of question (1): It is asked to tell how does a fluxgate magnetometer allows a robot to…
Q: photoelectric proximity sensor might have
A: 1. A photoelectric proximity sensor might have trouble detecting d. All of the above photoelectric…
Q: A coil having inductance of 0.04 H is connected across 50 hertz AC supply. Calculate the inductive…
A:
Q: 2.54 Show that the output of an LTI system can be expressed in terms of its unit step response s(n)…
A:
Q: Q.1.A: Given the point p(-3,5,3) and vector A = ya, + zay express P and A in Cylindrical
A: It is given that: p-3,5,3 and Vector A=yax+zay
Paralleling of two generator step by step
Step by step
Solved in 2 steps with 1 images
- In over compounded generator, full load terminal voltage is equals to no load voltage greater than no load terminal voltage less than no load terminal voltage non of theseLoad characteristic of DC generator is a graph between Il and Vt. True or FalseIn DC shunt generator, the load characteristics is drawn between
- The purpose of diverting resistance in series dc generator to control the effect of field windingIn differential compound DC Generator the shunt field current and the series field current are in opposite direction Select one: True False For lap and wave wound generators the generated power is same. Select one: True FalseThe internal characteristics of DC shunt generator can be obtained from *
- Which of the following is true in the phasor diagrams drawn according to the ohmic, inductive and capacitive operating states of the round pole synchronous generator a) Due to the voltage Efd, the excitation current is large in capacitive operation and small in ohmic operation b) Due to the voltage Efd, the excitation current is large in ohmic operation and small in inductive operation c) Due to the voltage Efd, the excitation current is small in capacitive operation and large in inductive operation. d) Due to the voltage Efd, the excitation current is large in capacitive operation and small in inductive operation.two alternators A and B having 5% speed regulation are working in parallel at a station. Alternator A is rated at 15 MW while B is at 20 MW. When the total load to be shared is 12 MW, then how much of the load will be shared by the alternator B?10- A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then series field current is a. 10A b. 9A c. 1A d. 2A