One of the following can be considered as a source of systematic error telphone General purpose interface bus the effect of temperature on the instrument Nearby power cables

Q: Actuators and transducers are both examples of sensors: Select one: Oa. False O b. True

A: What is example of the sensor?  Is it true Or false  "actuator and transducer is example of sensor "

Q: q17 The readings of an instrument are not affected by nearby power cables if the instrument is…

A: Solution :   In the above question they are discussing about the sensors.     Generally sensors are…

Q: One of the following can be considered as a source of systematic error General purpose interface bus…

A: Systematic errors can be classified into three types: 1) instrument error 2) environmental error  3)…

Q: Determine the (i) operating frequency and (ii) feedbac fraction for Colpitt's oscillator shown in…

A:

Q: Fast video ADC's are used in O microcontrollers O software defined radio O digital oscilloscopes O…

A: Fast video ADC's are used in TV tuner cards. microcontrollers: slow 8,10,12 and 16 bit ADC is used…

Q: The capacity of mobile communication system can be increased by O Frequency reuse O Cell splitting O…

A: "Since you have posted multiple questions, we will solve the first one for you. To get the other…

Q: Choose the correct answer. )----- These provide information that enables human beings to take some…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: H3. (Dynamical System ) Explain various types of oscillator in non linear system

A: Nonlinear oscillator : Whenever a force is exerted on any particle then there is movement in the…

Q: fullwave bridge type rectifier whose transformation ratio is 10:1 for an

A:

Q: i. Noise can be seen as enemy in communication, By what means can you prove that Thermal noise is…

A: i) Thermal Noise : Power Spectral Density :Vn2¯=4 kTRBwhere, k→Boltzman's…

Q: Give some rectifications technologies

A: Following are few rectification technologies:- High power ( Thyristor ) based rectifiers:…

Q: A control system is stable, if it is able to avoid sustained oscillations. Select one: True False

A: Control system

Q: Which statements are correct APU can supply to both AC buses if needed During normal startup of the…

A: APU- The Auxiliary Power Unit (APU) provides both electrical power and air to the airplane. It is…

Q: 10. Transmission of graphical information over telephone network is accomplished by * Television…

A: Communications

Q: Determine the DC Voltage for a bridge rectifier with a 115 Vrms, 60 Hertz primary transformer. The…

A:

Q: It provide a means of exchanging data between the external environment and the computer. Select the…

A: Answer Option:3 monitor

Q: State the advantages and disadvantages of the DSB_SC DSB_LC SSB

A: Advantage and disadvantage of DSB-SC DSB-SC stands for double side-band suppressed carrier.…

Q: A microprocessor can be connected to a DAC using 8255PPI (True/False) Select one: True O False

A: 8255 is used as parallel port to send the digital data to DAC . 8255PPI general purpose programmable…

Q: Q3: For the following digital system, calculate and draw the first 5 samples for the output y(kT)…

A:

Q: Input Output A B Y ! %3D Input Output 3. %3D Input Oulput Fig. (4)

A:

Q: Equation (1) represents the characteristic equation of a digital control system. By using Jury test,…

A:

Q: 3. The ability of a measuring device to give the same output when repetitively measuring the same…

A: Accuracy:- It is the ability of the instrument to measure the true value or it is the measure of…

Q: Loading effect causes inaccuracy in measurement can be avoided by using appropriate instruments or…

A: Accuracy:  It is the degree of closeness between different measured values for a common input value.…

Q: 4. One-way communications is called * O Half - Duplex O Full - Duplex O Monocomm O Simplex O O O O

A: Choose the correct option.  One way communication is called?    as per our guidelines we are…

Q: Data bus has communication type: O A. none of the options O B. Simplex C. Full Duplex O D.…

A: Data bus is bidirectional ( two way )  of communication.   Simplex are generally known as the…

Q: 6 Select the character of the measuring system by which it reads a value close to the true value. a.…

A: Need to elaborate  given explanation corresponding to which qunatity

Q: ( upload solution as single PDF file in Moodle) Determine the output of the given Sequential device…

A: Given:  Note : In the clock they have mentioned with the (dotted lines) negative edge of the clock…

Q: Ahe heat solvent methed the products controlled in terms of can be osize astoichiametry Murphology…

A: The solvothermal analysis is used for the fabrication of the nanomaterials. In this method, the size…

Q: An electrical firm manufactures light bulbs that have a length of life that is approximately…

A:

Q: Calculate i, in the op amp circuit of Fig. 1. X is equal to the last non zero digit of your student…

A: A very simple question based on analog electronics . In this opamp is given and io is to be…

Q: 91. Choose only seven for the following: 1) ******** ............of measurement is difference…

A: Given  Multiple choice questions based on measurement. Please find the below attachment for clear…

Q: The electronic sensing devices are used in passive solar house. Select one: O True False

A: The electronic sensing devices are used in passive solar house Is This statement true or false?

Q: 1 1 A Consider: B A = 1 B = 0 C = 1 Q = ? a. 1 b. 0 c. Can be both d. Neither 1 nor 0 A virus which…

A: In this question we will find output of given logic circuit... Note:- due to bartleby policy , I…

Q: The following text "Cannot discriminate among close optical channels" would be best describe: Select…

A: Wavelength division multiplexing (WDM) is a technique for multiplexing several optical carrier…

Q: 18. A sensing-element used in a measuring system is able to measure measurable quantity x through…

A:

Q: A 616 meter is having an accuracy of ± 0.16% of FSD. Calculate the %error for a measurement of 12,…

A: Error for 616 range is, Error=616*0.16100=0.9856 Full scale error valueAccuracy=0.9856100-0.16…

Q: Which among the given power electronics circuit converts AC input voltage into a fixed DC output…

A: 1. Controlled rectifier give the fixed output voltage.

Q: exist to improve the quality of the output of a measurement system in some way. O signal processing…

A:

Q: An interconnection of elements and devices for a desired purpose is called.. process O controller O…

A: Correct option is system control system is defined as an interconnection of components forming a…

Q: Note: Write all solution steps: QI Determine the output waveform ( X ) in proper relation to the…

A:

Q: A discrete memoryless source emits the following alphabet symbols: M1 M2 M3 M4 M5 M6 0.3 0.25 0.2…

A:

Q: To reduce or eliminate the random errors, we use multi range ammeter statistical analysis of data…

A: The solution is given below

Q: Consider designing an Aryton shunt ammeter with a multirange of (1mA and 10mA). Using a movement…

A:

Q: Electrical Engineering Apply pre-processing techniques of your choice such as histogram…

A: Histogram Equalization- This technique is used as an contrast enhancement technique in every kind of…

Q: The resolution of temperature sensor, which have ability to read the following data (0.1, 0.2, 0.3,…

A: Electrical devices are used for measuring electrical parameters. Current, voltage and power are…

Q: A Television broadcasting service uses a single coaxial cable with a bandwidth of 680 MHz to…

A:

Q: The input temperature (x) is given as 20°C and measured value (y) is obtained as 21.3°C in a…

A: Given Data, Tx=20°CTy=21.3°C The relative error can find out by, ER=Am-AtAt Am= measured value  At=…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.