Oil that has a density of 880 kg/m3 flows under a head of 30 m. The pipe that the oil flows through is 3000 m long and 0.35 m in diameter. Due to the cooling along the span of the pipe the viscosity changes, this may be taken as 0.57 kg/m-s over the first 1500 m and 1.14 kg/m-s over the second 1500 m. Confirm that laminar flow conditions exist and calculate the flow in dm³/s. Neglect entry and exit losses.

Q: Calculate the viscosity of a fluid that would allow a pressure drop of 35 kPa over a 5 m length of…

A: Given:Pressure drop, ∆P=35 KPaL=5 md=34 in =0.01905 mQ=2 L/min =0.00260  m3/sDensity, ρ=1010 Kg/m3

Q: Q: What is the type of flow of a liquid with a viscosity (0.0104kg / ms) and its density (900kg /…

A: Given data:

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A:

Q: 1. It shows that the behavior of fluid is + P. From the equation stated, show the formula vp- for…

A: Given, -dA/A=dV/V+dρ/ρ

Q: Water with a density of= 999.7 kg/m3 and absolute viscosity of 1.307 x 10-3 kg/m·s is flowing…

A:

Q: Viscosity of the fluid particles will be high while they are flowing as a turbulent flow

A: No, Viscoscity of fluid is low while flowing as a turbulent flow.

Q: Water with a density of= 999.7 kg/m3 and absolute viscosity of 1.307 x 10-3 kg/m·s is flowing…

A:

Q: Consider laminar flow of a Newtonian fluid ofviscosity m between two parallel plates. The flow is…

A: Given : The velocity profile is given as: The shear stress acting on the bottom of plate is given…

Q: A piston contains a type of fluid that has a S.G of 0.9 and a dynamic viscosity of 0.02 Poise. The…

A:

Q: Oil (u = 0.4 N • s/m²) flows between two fixed horizontal infinite parallel plates with a spacing of…

A: As,  μ=0.4 N.s/m2d=5 mmPr. gr.=-900 N/m2

Q: Water with a density of 999.1 kg/m3 and absolute viscosity of 1.138 X 10-3 kg/m·s is flowing…

A:

Q: Glycerin, with a density of 1260 kg/m3 and an absolute viscosity of 1.5 kg/m.s, flows in a tube with…

A:

Q: Water with a density of= 999.7 kg/m3 and absolute viscosity of 1.307 x 10-3 kg/m·s is flowing…

A:

Q: water 7.5 cm vapor diameter 1. Water is siphoned from the large, open tank as shown. The 9.2 m gas…

A: Solution: Water vapour on top of the barometer balances the liquid column and thus prevents the…

Q: Consider the problem of draining a hemispherical tank of radius H* feet that is full of water and…

A: dVdt=-KA2gh(t)  ........(1)dhdt=dVdt(1πr2)    .....(2)From (1) and (2):dhdt=-KAπr22gh(t)

Q: Water with a density of 999.1 kg/m3 and absolute viscosity of 1.138 X 10-3 kg/m·s is flowing…

A: Given question belongs to the subject Fluid Mechanics and from the chapter Flow through pipes.

Q: Verify that the flow of oil is laminar (barely) for an oil gusher that shoots crude oil 25.0 m into…

A: Understand that at the topmost point the velocity of the water stream will be zero and the water…

Q: Consider the problem of draining a hemispherical tank of radius H* feet that is full of water and…

A:

Q: A thin oil having a density of 800 kg/m³ is pumped from an underground storage tank through a 300 mm…

A: ⇒given data;⇒density(ρ)=800kg/m3⇒diameter of pipe line(d)=300mm=0.3m⇒horizontal distance or…

Q: A Pitot-static probe is mounted in a 2.5-cm-inner diameter pipe at a location where the local…

A: Given data: The diameter of the pipe, d = 2.5 cm. The density of oil, ρ = 860kg/m3. The viscosity…

Q: If the value of Reynolds number is less than 2000 the flow is called ...................flow steady…

A:

Q: 1- Oil with a density of 850 kg/m3 and kinematic viscosity of 0.00062 m2/s is being discharged by a…

A: Given data: ρ=850 kg/m3v=0.00062 m2/sd=8 mmL=40 mh=4 m Need to determine the flow rate of oil…

Q: Consider the problem of draining a hemispherical tank of radius H* feet that is full of water and…

A: Given data: -  The radius of circular drain hole is R = 3 in. The change in volume is dVdt=-kA2ght.…

Q: Water with a density of 999.1 kg/m3 and absolute viscosity of 1.138 X 103 kg/m-s is flowing steadily…

A:

Q: Q1 What is the Reynolds number? How is it defined for (a) flow in a circular pipe and (b) flow over…

A: This question is based on the concept of fluid mechanics.

Q: Water flows from a large resePV through 5-cm diameter smaller one a smooth piping system as shown in…

A: Given   Flow rate, Q = 6 L/s   Diameter, d = 5 cm Find   Elevation, Z

Q: Water at 35 degrees Celsius is flowing through a smooth pipe with a length of 95m and a diameter of…

A: Given data Pipe flow through a smooth pipe.Length = 95 mDiameter = 350 mm = 0.35 mReynold's number =…

Q: A pipe 100 feet long and 20 inches in diameter contains water at 200°F flowing at a mass flow rate…

A:

Q: Water with a density of= 999.7 kg/m3 and absolute viscosity of 1.307 x 10-3 kg/m·s is flowing…

A:

Q: . Determine the nature of flow when an oil of specific gravity 0.85 and kinematic viscosity 1.8 x…

A: We have to determine Nature of flow The above question

Q: In a pipe conveying steady flow of incompressible fluid, what factor determines the magnitude of…

A: The factor which affects the velocity of fluid flow through a pipe is needed to be identified. The…

Q: A large plate is pulled at a constant speed of U = 4 m/s over a fixed plate on 5-mm-thick engine oil…

A: Part a We have from given diagramy=V2KV2=KyNow for above equationWe use the bondary…

Q: For water at 30 °C that flows through a horizontal pipe of 0.1906 m diameter, with a flow rate of Q…

A: At  30 °C  Density of water (ρ) = 997 kg/m3 kinematic viscosity (ν) = 1×10-6 m2/sec flow rate Q =…

Q: For a fully developed flow or water in a pipe having diameter 10 cm, velocity 0.1 m/s and kinematic…

A:

Q: Fluid with a density of 800 kg/m^3 and velocity of 9.375 m/sec flows through a pipe diameter of 20…

A: Reynold's Number, Re=ρVdμRe=800*9.375*0.020.015Re=10000 Since Re>10000, Flow is turbulent

Q: Q2 Oil with a density of 850 kg/m³ and kinematic viscosity of 0.00062 m²/s is being discharged by a…

A:

Q: with density ρ=900 kg / m3 and kinematic viscosity ν=0.0002 m2 / s as shown in the figure, through a…

A:

Q: Crude Oil is flowing through a circular pipe with a centerline velocity of 0.5m/s at a temperature…

A: Given, Vmax = 0.5 m/sT = 60 °Cμ = 5.5 mPa s = 0.0055 Pa sρ = 855 kg/m3D = 20 mm = 0.02 m   Radius of…

Q: SAE 30 Engine Oil at 20 °C has a density of 0.882 g/cm² and kinematic viscosity of 272 mm³/s and is…

A: Given data: d=0.01 mL=5 mh=5 mv=272×10-6 m2s

Q: Water at 35 degrees Celsius is flowing through a smooth pipe with a length of 80m and a diameter of…

A: Answer: (a) The friction head developed in the flow is 0.01471 m. (b) The inlet pressure reduced due…

Q: A pipe delivers grape juice to a 1.5 m diameter tank. Another pipe (5 cm in diameter), located near…

A: Given data: Dexit=0.05 mH=2.5 m

Q: Consider a duct with 100m in length, diameter = 0.1m and 2mm roughness that transports water at a…

A: