Problem 94Oil from an uncapped well in the ocean isradiating outward in the form of a circularfilm on the surface of the water. If the radiusof the circle is increasing at the rate of 2meters per minute, how fast is the area of theoil film growing when the radius is 100meters ( in square meters per minute)?а. 1024b. 1333с. 1256d. 1432

Answered: Image /qna-images/answer/35bf209c-3127-4cf1-a2b2-6f8f93f45091.jpg

Answered: Oil from an uncapped well in the ocean…

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter4: Temperature Effects On Atom Arrangements And Atom Motion

Section: Chapter Questions

Problem 11CQ

See similar textbooks

Similar questions

Calculate suppprt reaction
1. When the force of 3 mN is applied to the plate the line AB in the liquid remains straight and has a velocity of 0.6x103 m/s. If the surface area of the plate in contact with the liquid is 0.6 m2, determine the approximate viscosity of the liquid. В в B B' 3 mN 4 mm A
To measure the sensitivity, the bubble tube can be attached to the telescope of a theodolite, so that: O A. It can be moved up and down with the telescope O B. It can be tilted up and down with the tube O .It can be tilted up and down with the telescope O D. It can be clamped up and down with the telescope
A capillary tube of diameter 2 mm is placed in a reservoir of water, and a similar capillary tube is placed in a reservoir of methanol. If both tubes are made of clean glass and the water-glass and methanol-glass contact angles are both approximately equal to 0°. Surface tension of water is 0.073 N/m. Surface tension and density of methanol are 0.0225 N/m and 791 kg/m3, respectively. 8.0 Determine the rise of methanol. a.) 7.4 mm b.) 5.8 mm c.) 14.9 mm d.) 2.9 mm e.) 9.0 Determine the rise of water. a.) 7.4 mm b.) 5.8 mm c.) 14.9 mm d.) 2.9 mm e.).
Select the correct FBD of particle A. 30° A. 40° 100 kg
Which of the following is false regarding factor of safety in the design of structures? a. It considers uncertainties in the material properties. b. A higher factor of safety is preferable in designing safe structures c. It should not be less than 1 to ensure the structure’s safety. d. It considers changes in the loading pattern on the structure. Consider a 1,000-mm long, 25-mm diameter sample subjected to a tension test. Automatic high-precision gages recorded that for an applied load of 150 kN, the sample experienced a longitudinal strain of 2×10−3mm/mm. Assuming that the material remained elastic while loaded, determine its modulus of elasticity. A. 175.0 GPa B. 63.7 GPa C. 152.8 GPa D. 72.9 GPa
Dead time is the time spent by analyte in both mobile and stationary phases True False
30 kN 10 kN 20 kN 5 kN/m в 3 m 2 m 1 m 2 m RA RB RA RB (c) (d)
98% ?. l3Ī 7 I 16:58 Month 1.pdf Q1:- The coplanar force system shown in Figure below is subjected to a couple moment (M) and three forces. Two forces are known in magnitude and direction and shown in the Figure (150 N and 60 N). The third force is passing through the center of the semi-circle (point C). The resultant of all these forces is a single couple (750 N.m) counterclockwise. a) Determine the magnitude and direction of the third force. b) Determine the magnitude of moment (M). Replace the couple (M) by two vertical equal forces acting at D and E. d) Replace the force (150 N) by and single force at D and a couple. Radius = 5 m 150 N E В M 60 N 4 A F. Q2:- Determine all forces acting on member DEF of the frame shown in Figure below:- 150 Ib/ft F3.0 m -3.0 m
Two parallel plates of area 100 cm2 are given charges of equal magnitudes 0.000000445 C but opposite signs. The eclectic field within the dielectric material filling the space between the plates is 1400000 V/m. Calculate the dialectic constant of the material * 7,2 3.6 O 2.7
The wavelength of a stone moving at 1 m/s is 1.3 x 10-31 m. What is the mass of the stone? A 8 g в) 5g (c) 6g D 7g
PROBLEMS: An SDF system is excited by a sinusoidal force. At resonance the amplitude of displacement was measured to be 5 cm. At an exciting frequency of one-tenth the natural frequency of the system, the displacement amplitude was measured to be 0.5 cm. Estimate the damping ratio of the system.

SEE MORE QUESTIONS

Recommended textbooks for you

Materials Science And Engineering Properties

Civil Engineering

ISBN:

9781111988609

Author:

Charles Gilmore

Publisher:

Cengage Learning

Materials Science And Engineering Properties

Civil Engineering

ISBN:

9781111988609

Author:

Charles Gilmore

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS