Nr Table 1 shows the relative viscosity, nr for a polyisobutylene with the molecular weight of 1500000 g/mol in benzene at the theta temperature of 25 °C. Determine the intrinsic viscosity of this polyisobutylene solution at this theta temperature. Table 1: Relative viscosity for 1500000 g/mol of polyisobutylene in benzene at 25 °C Concentration (g/L) Relative viscosity, n 1.066 1.136 1.209 1.287 0.05 0.10 0.15 0.20

Nr Table 1 shows the relative viscosity, nr for a polyisobutylene with the molecular weight of 1500000 g/mol in benzene at the theta temperature of 25 °C. Determine the intrinsic viscosity of this polyisobutylene solution at this theta temperature. Table 1: Relative viscosity for 1500000 g/mol of polyisobutylene in benzene at 25 °C Concentration (g/L) Relative viscosity, n 1.066 1.136 1.209 1.287 0.05 0.10 0.15 0.20

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter10: Solutions

Section: Chapter Questions

Problem 67QAP

See similar textbooks

Similar questions

The density of liquid NH3 is 0.64 g/mL; the density of gaseous NH3 at STP is 0.0007 g/mL. Explain the difference between the densities of these two phases.
10. (20 points) The surface tension and viscosity values for diethyl ether, acetone, ethanol, and ethylene glycol are shown here. Compound diethyl ether C₂H5OC₂H5 acetone C₂H5OC2H5 ethanol C₂H5OH ethylene glycol CH₂(OH)CH₂(OH) Molecule Surface Tension (mN/m) 17 23 22 48 Viscosity (mPa s) 0.22 0.31 1.07 16.1 (a) Explain their differences in viscosity in terms of the size and shape of their molecules and their intermolecular forces. (b) Explain their differences in surface tension in terms of the size and shape of their
Is it possible to have a homogeneous, binary liquid solution that has a higher (or lower) viscosity relative to either component?
21) (5 points) The surface tension of ethanol (CHCH2OH) is 0.022 J/ m2 and the surface tension of hexane (CH3CH2CH2CH2CH2CH3) is 0.0179 J/m2. Define surface tension and explain why the values for the listed molecules are different.
Naphthalene melts at 353 K. The vapor pressure of the liquid is 9329.0 Pa at 407 K and 28,638 Pa at 442 K. The vapor pressure of the solid is 3.13 Pa at 286 K and 726.3 Pa at 349 K. Calculate the triple point temperature. Calculate the triple point pressure.
Use the information in the figure below to estimate the boiling point (in °C) of water in Albuquerque (NM) when the atmospheric pressure is 83.8 kPa. Pressure (kPa) 133 107 80 53 27- °C ethyl ether 20 40 ethyl alcohol 키트 1 water 1 1 ethylene glycol 1 100 120 80 60 Temperature (°C)
e/1FAlpQLSeextwy9UfUly7FREN-OK6CIVXhuufSTFeiimZOJb00f90INQ/formResponse Your email will be recorded when you submit this form * Required MULTIPLE CHOICE PROBLEM SOLVING |3| The boiling point of 350mL of substance A was determined to be 97.5oC. Based on this information, the boiling point of 100OL of substance A is Higher than 97.5 degrees Centigrade Lower than 97.5 degrees Centigrade Undetermined Equal to 97.5 degrees Centigrade The boiling point of Benzene, Methanol, Aniline and Nitrobenzene are 80°C, 650C 184°C and 212 C respectively. Which will show highest vapor pressure at
(a) Would you expect the viscosity of n-pentane,CH3CH2CH2CH2CH3, to be larger or smaller than the viscosityof n-hexane, CH3CH2CH2CH2CH2CH3? (b) Wouldyou expect the viscosity of neopentane, (CH3)4C, to besmaller or larger than the viscosity of n-pentane? (See Figure11.6 to see the shapes of these molecules.)
Consider material Z in the attached ternary phase diagram. If the temperature is lowered to T1, answer the following questions:1. What are the proportions of solid and liquid?2. What is the composition of the solid portion?
The boiling points, surface tensions, and viscosities ofwater and several alcohols are as shown below:(a) From ethanol to propanol to n-butanol the boilingpoints, surface tensions, and viscosities all increase. Whatis the reason for this increase? (b) How do you explainthe fact that propanol and ethylene glycol have similarmolecular weights (60 versus 62 amu), yet the viscosity ofethylene glycol is more than 10 times larger than propanol?(c) How do you explain the fact that water has thehighest surface tension but the lowest viscosity?
Use a table for the Vapor Pressure of Water to answer the following. Report temperatures to the nearest 5 °C and pressures to the near a) What are the pressure of water and the dew point in a system in which the relative humidty is 50.5% at 70 °C? Pressure of water = 118.01 v torr Dew Point = X °C b) The pressure of water vapor in the atmosphere is found to be 23.8 when it is 40 °C. What are the dew point and relative hunidty? Dew Point = °C Relative Humidity = X %
See attached picture. Viscosities of five liquids at 25°C are given in the following table. Explain the observed trends in viscosity.