Note: explain your solution A certain transformer has a ratio of 8 is to 1. the primary winding resistance is 0.00283 ohm per turn and has 1155 more turns than the secondary winding. if the copper losses in the primary is 20% less than in the secondary, find the resistance of the secondary winding.

Note: explain your solution A certain transformer has a ratio of 8 is to 1. the primary winding resistance is 0.00283 ohm per turn and has 1155 more turns than the secondary winding. if the copper losses in the primary is 20% less than in the secondary, find the resistance of the secondary winding.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.3P: Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source...

See similar textbooks

Related questions

Q: A inverting op amp circuit is shown. a. Find vo. b. What is the current in? c. What are the voltages…

A: here we have to find the output voltage and voltage at inverting and non inverting terminal of the…

Q: 1a) Determine vo and i in the circuit 492 www 12 V 652 ww 2% 4V

Q: 6) For the circuit, find il, i2, i3 to 14 2Ω κα 5A τη 6Ω www 3% 4Ω ΑΜΕ 8Ω Ω 292 10 V

A: A supply voltage source of 10 V is applied across the left peripheral of the circuit. A current…

Q: Q3) Using step and ramp functions, write equations that describes waveforms shown 4 2 N

A: In this question We need to represent the given signal to unit and ramp function. We know u(t) is…

Q: Given a = 2, b = 1, c = 1, d = 12, e=24, f = 1 and g = 7.5, in the circuit below, obtain the phasor…

A: here we have to find the current I0 .

Q: In the following network, the voltage magnitudes at all buses are equal to 1 p.u., the voltag phase…

A: Given- Voltage magnitudes at all buses = 1 p.u. Voltage phase angles are small, Line resistance are…

Q: d) Discuss about the principles of electromagnetism used in the simulation

A: Given: Discuss about the principles of electromagnetism used in the simulation.

Q: Get I Drop at 32 lov = 42 :20v and r using supty

A: Here we have to find the current across the 5 ohms and 2 ohms.

Q: If Vin (t) = 5cos(35,000t +45°) V, find Vout (t) in the form of Aout cos (wt+out)- (Hint: H() = out)

Q: govt Find Nx and i ata 902 13F str t 301 0.5i ·505

Q: тол 225-28+ 25V 22 {4_2 € 50V Get I prop and VDrop for 102 and 42 Solve the circuit using Nodal…

A: here we have to find the current and voltage across the 10 ohms and 4 ohms.

Q: Question-1 Consider the following circuit, assuming Vs = 50 V, Rs = 1k, RL=9k , and Vz= 10 V: Rs +…

A: it is asked to find whether the given zener diode is ON or OFF and in what region it is operating

Q: A 4 pole, lap wound de motor has 540 conductors. Its speed is found to be 1000 rpm when it is made…

Q: 1. For the base-biased png transistor in the following figure, assume Boc = 200. Finc RB 1.5 M -Vcc…

Q: 8 ΚΩ ww A non-inverting op amp configuration is shown. a. Find the gain of the amplifier, vo/vs. b.…

Q: Problem Imagine that the object is part of a spherical shell. It may be described as 3 ≤r ≤ 5,60° ≤…

A: Disclaimer: As per Bartleby's guidelines only 3 subparts can be solved. Please send other subparts…

Q: A balanced three-phase star-connected R-C load of 145 kW takes a current of 88 A with a line voltage…

A: In this question we need to find the impedance , power factor , resistance, reactance and…

Q: H.W: Simplify the following Boolean expressions: 1. (Ā+B+C).(Ā+B+C).(C+D).(C+D+E) 2. A.B.C +…

Q: 9nm 8nm P 6nm 7nm D A B с 3.0x10 17C -5.0x10-17C 2.0x10-17℃ -4.0x10-17C What is the total work done…

A: Potential at a point due to a point charge V=kQr where k→contant Q→Charge r→distance of point from…

Q: 3. The design of an FIR filter using the Parks-McClellan algorithm achieved the following magnitude…

A: Given data : Filter response is given as,

Q: 3. Consider the following circuit: R₁ Vi(t)m H(s) = MR₂ + Assume that prior to t=0, the capacitor…

Q: d. Invert Vċ(s) to find Vċ(t). e. Show that Vc(t) satisfies the differential equation from part (a)…

Q: A 220V long shunt compound motor has an armature resistance of 0.54Ω and a series field resistance…

Q: A three phase unbalanced currents are: la=10∠30 lb=0 Ic=10∠150 Find the negative…

A: To find the negative sequence current of phase b, we need to use the following formula:…

Q: Vin www R₁ L₁ C₁ X 000 Assume R₁ = 24502, L₁ Vout = rad 3.3mH, C₁ = 0.22 μF, and w= 35,000 for the…

Q: Moore's Law is used in the construction of ERP. Is Moore's Law still applicable in the modern era?

A: Moore's Law is a prediction made by Intel co-founder Gordon Moore in 1965 that the number of…

Q: The signal at the input of an amplifier has an S/N of 42dB. If the amplifier has a noise figure of…

Q: Consider the circuit below. The voltage on the capacitor C₁ at t = 0 is 100 kV and the voltage on…

A: The ac circuit is given as The initial voltage of capacitor C1 is VC10-=100V

Q: I am unsure of how to find the equivalent resistance I suspect that I have to transform this into a…

A: It is given that: vs=vin=400 mVRin=500 kΩRo=5 kΩAoL=300000

Q: Question-2 E Consider the following circuit (assuming the ideal diode model): 11/ ²45. Dic↓ ILY (a)…

Q: D please

A: We use S domain to solve this question

Q: 1. (2 pts) An inverting op amp circuit is shown. a. Find vo. b. What is the current in? C. What are…

Q: 1. Given a Three-Phase Y Connection load: VLL=208 <30° V P= 7500 W Power Factor = 0.9 Leading Find:…

A: In this question We need to determine the complex power and current in line and phase. We know…

Q: One phase of a 3-phase alternator consist of 12 coils in series. Each coil has an rms voltage of 10V…

A: It is given that: β=10°m=10Es=10 V

Q: 5) Find the current io in the circuit 12 24 V 10 Ω 12 Ω 4Ω 13 α 24 Ω Δια

Q: 1. Find the rms current,??,???,flowing through the secondary side of the transformer. 2. Find the…

A: In this question We need to determine the rms current in the secondary side, voltage across the…

Q: 55. A half-wave rectifier circuit is shown in the figure. The minimum reverse voltage rating (V) of…

A: In this question we need to choose a correct option

Q: For a circuit element (not shown) of unknown type and impedance, assume the voltage is v(t) =…

A: To calculate the active and reactive power, we need to first find the RMS voltage and current: Vrms…

Q: Compute for the total consumption in 30 days should charges 4.50 per kWhr. Hour of Consumption per…

Q: 5. A three-phase power system consists of a wye-connected generator connected to a wye-connected…

A: A generator's combined real power and reactive power output make up its overall complex power.…

Q: In units of dB, what is the magnitude of the transfer function at f = 900 Hz, |H(f = 900 Hz)|db?…

A: From the given bode plot the magnitude of the plot at frequency 900Hz should be calculated and the…

Q: Q2. A Battery of 40 cells is to Be Charged from A 130V supply. The internal resistance of of each…

Q: Can you please more greatly explain step 3, thank you.

Q: A germanium diode draws 32 mA with the forward bias 0.27 V. IfT-300 K calculate the reverse…

A: Given data, Diode current is given as, ID=32 mA Forward bias voltage is given as,VD=0.27 V…

Q: 3. Consider a system defined by the following operator S N S{f(x)} = Σhn · f(x - n^x) . n=0 (a) Is…

A: According to the question, for the given system as shown below Sfx = ∑n=0N hn.fx-n△x ; We need to…

Q: B). supplied [PI1c] Find the power of the 6V source and state whether it is or absorbed.

Q: Hanging a ceiling fixture directly from a plastic outlet box is permitted only if

A: Hanging a ceiling fixture directly from a plastic outlet box is permitted only if the box is…

Q: In a step-up converter, consider all the components to be ideal, Let Va be 8-16 V, V.-24 V…

Q: 1.) A communication system is defined below: Transmitter Power: = 45 dBm; Frequency = 1 GHz Transmit…

A: a. Free-space range equation: The received power can be calculated using the free-space range…

Q: A relay has 12 ohms resistance, and a 2.4 H inductance is suddenly switched across 120 volts supply…

A: it is asked to find the instantaneous current after 0.1 second for given relay

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

Note: explain your solution

A certain transformer has a ratio of 8 is to 1. the primary winding resistance is 0.00283 ohm per turn and has 1155 more turns than the secondary winding. if the copper losses in the primary is 20% less than in the secondary, find the resistance of the secondary winding.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: About the Question

VIEW

Step 2: Calculation of no. of turns

VIEW

Step 3: Calculating secondary winding resistance

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 16 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For an ideal transformer, the efficiency is (a) 0 (b) 100 (c) 50
For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
All values of a transformer are proportional to its __________________ ___________________.
Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source whose voltage is e1(t)=100(1| t |)volts for 1t1ande1(t)=0 for | t |1 second. A2- farad capacitor is connected across winding 2. Sketch e1(t),e2(t),i1(t),andi2(t) versus time t.
Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated sheets of alloy steel (ii) Eddy current loss (b) Can be reduced by the use of special high grades of alloy stl as core material.
8- The equivalent resistance of the primary of a transformer having K = 4 and RI - 0.1 ohm when referred to secondary becomes..ohm. a-0.1 b-0.01 c-0.004 d- 1.6
In this Center tapped transformer Find the peak voltage of V1 and V2, RMS voltage of V1 and V2, and Peak to peak voltage of V1 and V2
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diodeshave? (Use constant voltage drop model for the Silicon diode) D IN4001 OV 10 kN IN4001 DELL
DC 200 V is applied to the primary of a transformer with a conversion ratio of 1/5. From secondaryExplain the reason for this by writing the voltage value to be made?
Certain transformer has full-load copper losses of 500 W. What is value of copper loss at half load
In a transformer having a 10 to 1 ratio, the copper losses in the primary are 15 per cent less than in the secondary. The resistance per turn of the primary is 0.00394 ohm, and there are 1,485 more turns in the primary than in the secondary. Calculate the resistance of the secondary winding.
How does the coupling factor affect the primary and secondary voltages? For example if the turns ratio in my transformer is 1:2 and the Vin is 10V, the voltage on the primary side is 10V and the voltage on the secondary side is 20V when the coupling factor (k) is 1. What will the primary and secondary voltages be if the coupling factor becomes 0.5?