nger diameter is 7/8 inch and its weight is 1.8 pounds. What is the safe maximum deadweight in kg, that must be place atop the piston table in order to produced 10,000 psig? Show calculatio

Q: 1. What are the base units of the SI and U.S. Customary systems? 2. What is the definition of an…

A:

Q: Calculate the approximate specific weight of the object.

A: The weight of the object in air Wair=75 lbs The weight of the object when immersed in water…

Q: What height of oil column will cause the pressure of 575kn/m2? What is the equivalent height of…

A:

Q: In a car service station, a force of 100 N is required to raise the car on the hydraulic lift. If…

A: Given ThatF=100Nr-radius of pistonD-diameter of hydraulic Lift20D=rso10r=rm=? ****Please Note that…

Q: Pressures up to 2000 atm are measured with a dead-weight gauge. The piston diameter is 4 mm. What is…

A:

Q: 1. For the shown hydraulic jack the gage pressure indicates 140 kpa how much kilograms should be…

A:

Q: A 450g of toblerone with a triangular trough in shape has the following dimensions of 6 ft in…

A: Given    Mass, m = 450 kg Volume, V = 1.82 x 0.101 x 0.035 m3 Find   Density   Specific gravity

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00221 N/cm2…

A: Given: pi - po = 0.00221 N/cm2 σ = 0.075 N/m

Q: The diameter of the plunger is 18 mm and its weight is 616 grams.  If the deadweight atop the piston…

A: Given Datad=18mmW=616gramDw=10kgsHydraulic gauge pressureP=?

Q: 1. An open hemispherical vessel with a radius of 1.2m is full of oil (0.85) a. How fast in rpm…

A: Given: The radius of vessel, r = 1.2 m The specific gravity of oil, SG = 0.85

Q: Problem 1. What is the mass of the ball in kg, if it weighs 300 Kgr? Problem 2. A closed drum…

A: Dear student                    According to the guidelines I am allowed to answer only three…

Q: Calculate the specific weight, density, and specific gravity of 1 liter of liquid which weighs 7 N.

A:

Q: Engine has a capacity of 20 milliliters per cylinder and the length of the axle arm is 5 cm Find the…

A:

Q: A pump develops a power of 50 KW at 300 rpm with fluid specific gravity of 1.02 when impeller…

A: GIVEN DATA - FOR PUMP -1 Power P=50KW  , N =300 rpm , D=150mm , Sp. Gravity = 1.02 FOR PUMP-2 POWER…

Q: A compressed air tank has a volume of 0.85 m3. When the tank is filled with a gauge pressure of 3…

A:

Q: The specific gravity of mercury relative to water is 13.55. What is the specific weight of mercury?…

A:

Q: A frustum of a right conical vessel stands vertically on its vertex. It has an altitude of 1.0 m.…

A: Given: dbottom=0.5 mdtop=0.8 mh=1mN=90 rpmTo find:volume of water remained after rotation=?

Q: An inverted right circular conical tank loses water out of a 4-in hole at the bottom. The radius of…

A:

Q: A block of wood of 2m x 1m x 1m x in size and specific gravity of 0.75 is floating in water. What is…

A:

Q: A cylindrical tank is filled with water at the rate of 5,000 gal/min. The height of water in the…

A: Given data: Q=5000 gal/mint=15 minh=20.42 ft Need to determine the diameter of the tank.

Q: 5) Before transferring the rod into the graduated cylinder, the cylinder tipped and some of the…

A: In case of equal density, means the calculated density and the actual density are the same then…

Q: Compute the height in feet of a high building if the pressure at the ground floor is 30 in Hg and at…

A:

Q: The given figure is a representation of a piston inside a cylinder. What do you call parts A, B, C,…

A: given figure is a representation of a piston inside a cylinder. To name the parts A, B, C, D, &…

Q: mooth pipes, each having a mass of 300kg, are supported by the forked tines of the tractor as Fig.…

A: Two smooth pipes each having a mass of 300kg are supported by the forked lines of the factor.

Q: 5.25mg cylindrical tube ice has the following dimensions of radius 2.5 cm and stands 1.25mm.…

A: Given     Mass, m = 5.25 mg = 5.25 x 10-6 kg   Radius, R = 2.5 cm = 0..025 m   Length, L = 1.25 mm =…

Q: At what depth below the surface of the oil, relative density 0.89 will produce a pressure of 120…

A: The given data are: Here, d denotes the relative density and P denotes the pressure.

Q: A conical vessel with vertical axis has an altitude of 1 m and is filled with water. Its base, 0.60…

A:

Q: If the pressure at a point in the ocean is 1500 kPa, what is the pressure 20 m below this point? The…

A:

Q: A tube contains an oil of specific gravity 0.9 to a depth of 120 cm. Find the gauge pressure at this…

A: Givenoil specific gravityγ=0.9Depth=1.2mRequired:- Gauge pressure at 1.2m

Q: Poise b. Counterweight c. Lever ratio (for weighing scales)

A: counterweight : it is the reference mass that is used to measure the mass of the object being…

Q: A 10 ft by 15 ft rectangular cistern (storage tank for rainwater) has its top 30 ft below ground…

A: Calculus is frequently used to determine the amount of labour required to empty a tank of the…

Q: Pressures up to 2000 atm are measured with a dead-weight gauge. The piston diameter is 4 mm. What is…

A:

Q: A prismatic object 8 inches thick by 8 inches wide by 16 inches long is weighed in water at a depth…

A: Given: The thickness of inch, t = 8 in The width of object, b = 8 in The depth of object in water, L…

Q: avity of certain oil is 0.82. Calculate its  (a) specific weight, in

A:

Q: In a forklift, cylinder area 512mm^2 and pressure 584 N/mm^2 Calculate the mass( in tonnes)

A: Taking g=10m/s^2.

Q: The specific gravity of mercury is 13.6. The specific weight of mercury is

A:

Q: Compute the atmospheric pressure at elevation 20,000 ft, considering the atmosphere as a static…

A:

Q: A cylindrical container with a diameter of 11.5 m. It has an outlet almost to the bottom, rounded…

A: Given: Diameter : 11.5 m Diameter of hole : 1.2 m h = 12 m

Q: What is the force from water pressure on a dam?

A: The force exerted by the water on the surface of dam is called the pressure force. This force always…

Q: A gas under a pressure of 1 MPa absolute has a specific weight of 99 N/m^3. What is the value of R…

A: Given data  P=1MPa =1000 kPa  Specific weight= 99 N/m^3  Density = (99/9.81)kg/m^3  Density=10.09…

Q: At what depth below the surface of the oil, relative density 0.86 will produce a pressure of 110…

A:

Q: At what depth below the surface of the oil, relative density 0.83 will produce a pressure of 100…

A: Fluid Mechanics

Q: Example 2. Calculate the density, specific weight and weight of one liter of petrol of specific…

A:

Q: A hydraulic lift system utilizes two 5 in diameter cylinders. Workers must determine how much the…

A: The capability of the lift can be calculated easily using the formula given below as- F=PA where, F…

Q: A gage pressure of 52.3 kPa is read on a gage. Find the absolute pressure if the elevation is: (a)…

A: Given:Gage pressure, Pg=52.3 kPa

Q: The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32 mm…

A: INTRODUCTION : The Mean Effective Pressure is a theoretical quantity used to predict an internal…

Q: For surface submerged horizontally in a liquid, the centre of pressure and the distance of centre of…

A: For surface submerged horizontally in a liquid, the centre of pressure and the distance of centre of…

Q: At what depth below the surface of the oil, relative density 0.85 will produce a pressure of 110…

A: