Neglect any energy transfer to or from the container. 5. Steam at 100°C is added to ice at 0°C. a. Find the amount of ice melted and the final temperature when the mass of steam is 14 g and the mass of ice is 45 g. b. Repeat with steam of mass 1.8 g and ice of mass 45 g.

Neglect any energy transfer to or from the container. 5. Steam at 100°C is added to ice at 0°C. a. Find the amount of ice melted and the final temperature when the mass of steam is 14 g and the mass of ice is 45 g. b. Repeat with steam of mass 1.8 g and ice of mass 45 g.

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter19: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 13P: In an insulated vessel, 250 g of ice at 0C is added to 600 g of water at 18.0C. (a) What is the...

See similar textbooks

Similar questions

In 1986, a gargantuan iceberg broke away from the Ross Ice Shelf in Antarctica. It was approximately a rectangle 160 km long, 40.0 km wide, and 250 m thick. (a) What is the mass of this iceberg, given that the density of ice is 917kg/m3 ? (b) How much heat transfer (in joules) is needed to melt it? (c) How many years would it take sunlight alone to melt ice this thick, if the ice absorbs an average of 100W/m2, 12.00 h per day?
(a) How much heat transfer is required to raise the temperature of a 0.750kg aluminum pot containing 2.50 kg of water from 30.0C to the boiling point and then boil away 0.750 kg of water? (b) How long does this take if the rate of heat transfer is 500 W 1watt=ljoule/second(lW=lJ/s) ?
A person inhales and exhales 2.00 L of 37.0C air, evaporating 4.00102g of water from the lungs and breathing passages with each breath. (a) How much heat transfer occurs due to evaporation in each breath? (b) What is the rate of heat transfer in watts if the person is breathing at a moderate rate of 18.0 breaths per minute? (c) If the inhaled air had a temperature of 20.0C, what is the rate of heat transfer for warming the air? (d) Discuss the total rate of heat transfer as it relates to typical metabolic rates. Will this breathing be a major form of heat transfer for this person?
(a) If a 500mL glass beaker is filled to the brim with ethyl alcohol at a temperature of 500C, how much will overflow when its temperature reaches 210C ? (b) How much less water would overflow under the same conditions?
Unreasonable Results (a) An automobile mechanic claims that an aluminum rod fits loosely into its hole on an aluminum engine block because the engine is hot and the rod is cold. If 1he hole is 10.0% bigger in diameter than the 22.0C rod, at what temperature will the rod be the same size as the hole? (b) What is unreasonable about this temperature? (2) Which premise is responsible?
A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is completely filled with turpentine at 20.0C. The turpentine and the aluminum cylinder are then slowly warmed together to 80.0C. (a) How much turpentine overflows? (b) What is the volume of the turpentine remaining in the cylinder at 80.0C? (c) If the combination with this amount of turpentine is then cooled back to 20.0C, how far below the cylinders rim does the turpentines surface recede?
(a) Calculate the rate of heat conduction through house walls that are 13.0 cm thick and that have an average thermal conductivity twice that of glass wool. Assume there are no windows or doors. The surface area of the walls is 120m2 and their inside surface is at 18.0C, while their outside surface is at 5.00C. (b) How many 1-kW room heaters would be needed to balance the heat transfer due to conduction?
Unreasonable Results Suppose the relative humidity is 80% on a day when the temperature is 30.0C. (a) What will the relative humidity be if the air cools to 25.0C and the vapor density remains constant? (b) What is unreasonable about this result? (c) Which premise is responsible?
A high—pressure gas cylinder contains 50.13L of toxic gas at a pressure of 1.40107N/m2 and a temperature of 25.0C. Its value leaks after the cylinder is dropped. The cylinder is cooled to dry ice temperature (78.5C) to reduce the leak rate and pressure so that it can be safely repaired. (a) What is the final pressure in the tank, assuming a negligible amount of gas leaks while being cooled and that there is no phase change? (b) What is the final pressure it onetenth of the gas escapes? (c) To what temperature must the tank be cooled to reduce the pressure to 1.00 atm (assuming the gas does not change phase and that there is no leakage during cooling)? (d) Does cooling the tank appear to be a practical solution?
What does it mean to say that two systems are in thermal equilibrium?
A deepsea diver should breathe a gas mixture that has the same oxygen partial pressure as at sea level, where dry air contains 20.9% oxygen and has a total pressure of 1.01105N/m2. (a) What is me partial pressure of oxygen at sea level? (b) If the diver breathes a gas mixture at a pressure of 2.00106N/m2, what percent oxygen should it be to have the same oxygen partial pressure as at sea level?
(a) If you toss 10 coins, what percent of the time will you get the three most likely macrostates (6 heads and 4 tails, 5 heads and 5 tails, 4 heads and 6 tails)? (b) You can realistically toss 10 coins and count the number of heads and tails about twice a minute. At mat rate, how long will it take on average to get either 10 heads and 0 tails or 0 heads and 10 tails?