Name the twó érrör recovery strategies, and briefly explain how they work...

Q: What is edge triggering?

A: Triggering of a circuit is referred to the enabling of circuit working. When the circuit is…

Q: 10. Which of the following is true about microprocessors?

A: The correct option along with the explanation is provided in the following section.

Q: 1- Design a 3-bit UP-DOWN synchronous counter such that the UP or DOWN counter is selected by a…

A: The state diagram for the UP-DOWN synchronous counter is shown in the below figure.

Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…

A: Flip flop is a latch with additional control input (clock or enable ). A flip flop is used to store…

Q: Describe the costs and benefits of aliasing, and explain how it can be avoided

A:

Q: 1. What is the difference between synchronous binary counter and asynchronous binary counter?

A: Note:Dear student here you have posted multiple question in sigle request.We will solve first…

Q: S Display will be designed for a thermometer. The display will show that degree for minimum…

A: As per our policy we can provide solution of first three questions only. For a) As given, the…

Q: (a) How many FFs are required to build a binary counter that counts from 0 to 1023? (b) Determine…

A:

Q: Describe of RCD delay Types? Give an example how we can use it

A: Here we discuss about the RCDs i.e. Residual current devices.

Q: Design a 3Bit Odd Parity Detector using :a) Multiplexer b) Decoder, and appropriate gates?

A: To design a 3 bit odd parity detector, we will use 3 bits A, B, C & output will be Y Therefore…

Q: What is the difference between synchror binary counter and asynchronous binary counter?

A: Counters can be classified into two typed based on how clock signal is applied.

Q: You have been asked to design an intruder alarm circuit using logic gates. Compare TTL and CMOS…

A: Intoduction - TTL technologies - TTL is an abbreviation for Transistor-Transistor Logic. Every logic…

Q: If an 8-bit binary number is used to represent an analog value in the range from 010 to 10010, What…

A: Given  010101102 is the given binary number.

Q: 1. Why are tristate buffers required to interface digital devices to a bus?

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: On our MCS, which chip is used for uni-directional bus buffering?

A: On our MCS, 74LS244 chip is used for unidirectional bus buffering.

Q: how to find the percent error ?

A: As per bartleby guidelines, we will be solving only first 3 subparts. For remaining parts please…

Q: What are the shortcomings of one dimensional parity error detection scheme? And discuss the…

A: Shortcomings of one dimensional parity error detection scheme : There are mainly two shortcomings of…

Q: 4. Draw 3-bit synchronous counter and write its truth table?

A: We need to design 3 bit synchronous counter . We will Design the 3 bit up counter by using of T flip…

Q: What is the 64-QAM constellation and phase (in degrees with 3 significant digits only) of the point…

A:

Q: Why when sending an accurate voltage to a device does the remote sensing terminals become an…

A: Due to the distance between output and the load there is a voltage drop so the important function of…

Q: 1 the minimum signal to noise ratio (SNR) to receive the symbols bability of bit error 106 or less?…

A:

Q: Determine the truth table of the digital circuit shown in the figure below and explain its…

A: A bipolar junction transistor (BJT) is a current-controlled switch. The current between the…

Q: What is the step size for a 15V range, 9 bit digit?

A: We need to find out step size

Q: 4) Illustrate the generation of noncoherent version of PSK signal for the input binary sequence…

A: Non-coherent PSK Generation : Initially, we are giving the input binary stream and delayed output…

Q: What are the vulnerabilities do you see in EIGRP protocol? How one can mitigate that?

A: The EIGRP stands for the Enhanced interior gateway routing protocol. It is advanced routing…

Q: Explain how AMI can perform simple error detection and what is the advantages of using HDB3 over…

A: AMI stands for Advanced Metering Interface(AMI) .It is an engineering architecture for computerized,…

Q: 8085 microprocessor, the ISR for handling trap interrupt is at which location?

A: In this question we will write about the ISR for handling trap interrupt is at which location in…

Q: 08 cancelled if the pulse width is made to be Q10. Using single pulse width modulation for single…

A: For the angle single-phase inverter in the single pulse width modulation scheme, the n harmonic is…

Q: We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each output slot…

A:

Q: Make a counter with the irregular binary count sequence given in diagram.

A: Counter is a  sequential circuit made up of flip flop which are connected to count the pulses .…

Q: he time to reach the steady-state final value of a ripple adder decreases with the length of the…

A:

Q: Design a 3-bit Gray code counter. Counter have to be run, reversely.

A: The solution is given below

Q: Please write equations for both the pull up and pull down of the complex gate. Note: these are not…

A: The equations are

Q: How are bias errors different from random errors?

A: Given:  The difference between bias and random errors is shown as:

Q: true or false ?? an even two bit parity checker will output a parity error if data A=LOW data ,…

A: Given, An even two bit parity checker will output a parity error if data A=LOW, data B=HIGH, parity…

Q: 5. Write a pseudocode program for the process by which two numbers, say 4 and 3, could be multiplied…

A: Below find the solution !!

Q: Explain the function, truth table, schematic design and etc of the 4 bit full adder circuit

A: We need to explain the function, truth table, schematic design and etc of the 4-bit full adder…

Q: (a) Write an 8086 program for our LAB emulator that sort descendingly the followng sequence : 1,…

A: Since you have asked multipart questions, we will solve the first question for you. Let us consider…

Q: choose the correct answer The BCD equivalent and binary equivalent of the decimal number 10 are…

A: The BCD equivalent and binary equivalent of decimal number 10 is not same.

Q: Construct a bus system using tri state buffer for 2 registers having 4 bits each.

A: We have given the following problem Construct a bus system using tri state buffer for 2 registers…

Q: 19. What is the minimum distance required for single error detection according to Hamming's analysis…

A: Hamming distance Working to ensure that any 2 possible code-words are sufficiently different from…

Q: what do you mean by term parity of a digital world ?

A: In digital world, parity is a technique that checks whether the data is lost or written over when it…

Q: If an 8086 running at 10MHz performs bus cycles with two wait states, what is the duration of the…

A: 8086 Microprocessor: This microprocessor is a 16-bit microprocessor having a 20 address lines and…

Q: How to represent a priority encoder by using truth table  and draw a diagram

A: The binary encoder is used to compress a large number of the inputs to a smaller output. For…