[Q2] n analog signals (each is bandlimited to 10kHz) are transmitted simultaneously over a channel viathe TDM-PAM system. If the TDM output transmission pulse rate is set to be 360k samples per second,compute n. (Assume the sampling frequency is the Nyquist rate).[Q3] Let m(t) be a baseband signal whose spectrum is described in the figure below. This signal is sampledat the rates (a) 17kHz, (b) 30% over the Nyquist rate. Draw the spectrum of the sampled signal in eachcase.(イィ3-7e1747.55 q4584-7.5 26.534-3 - 51M(f)34+3= 3734+ス-ウs uり.5-7.5k-3k0.3k7.5k

nals (each is bandlimited to 10kHz) are transmitted simultaneously over a channel via ystem. If the TDM output transmission pulse rate is set to be 360k samples per second, me the sampling frequency is the Nyquist rate). a baseband signal whose spectrum is described in the figure below. This signal is sampled 7kHz, (b) 30% over the Nyquist rate. Draw the spectrum of the sampled signal in each (イォ3=て。 174755 q45 34-1.5 26.5 34-3 51 M(f) 34+3= 3 34+スウェ 4、5 -7.5k -3k 0. 3k 7.5k

nals (each is bandlimited to 10kHz) are transmitted simultaneously over a channel via ystem. If the TDM output transmission pulse rate is set to be 360k samples per second, me the sampling frequency is the Nyquist rate). a baseband signal whose spectrum is described in the figure below. This signal is sampled 7kHz, (b) 30% over the Nyquist rate. Draw the spectrum of the sampled signal in each (イォ3=て。 174755 q45 34-1.5 26.5 34-3 51 M(f) 34+3= 3 34+スウェ 4、5 -7.5k -3k 0. 3k 7.5k

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Discuss how the circuit produces a Frequency Modulated Signal
After getting the formula of FM and PM moducation signal, how can I sketch this one.
[Q1] Assume there are 50 signals, each one is band-limited to 10kHz and sampled at a rate 28% over the Nyquist rate. Assuming these signals have the same voltage range, the samples of each signal are quantized with the maximum quantization error is 0.31% of the peak amplitude. The quantized samples are coded to be binary using PCM. The binary bits from each signal are multiplexed using TDM-PCM. Determine the channel bandwidth required to transmit the multiplexed signal.
A modulated signal with a bandwidth equal to 11.1 KHz. The LSB of the modulated signal is 9.6 KHz and the modulation percentage is fifty-five only. Calculate the following: a. (@.) and (-@.); b.Om; Vm if the amplitude of the LSB is equal to one c. Vc fourth of Vm
4. Write down the general expressions of frequency modulated signal and phase modulated signal. And show the methods to generate FM signals.
Q2: An audio signal given by 15 sin(4000mt) + 20 sin(B000nt) amplitude modulated(DSB-FC) a sinusoidal carrier wave 60 sin(100,000nt) a. Derive an expression for the modulated signal. b. Find the modulation index. c. Find the spectrum of the modulated signal. d. Sketch the spectrum of the modulated signal e. Which type of demodulation method you propose to reconstruct the audio at receiver. Why'?
Q36)The signal can be reconstructed from its samlpes a. None of the mentioned b. Above Nyquist rate c. At & above the Nyquist rate d. At Nyquist rate This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer.
How do we get the smal signal model and why CL and Cb doesn’t short the resistance because of the high frequency?
Draw the spectrum of the sampled signal when the sampling rate is equal to 2.5 × 10* d) Draw the spectrum of the sampled signal when the sampling rate is equal to 1× 104 Draw the spectrum of the sampled signal at the Nyquist rte. An analog signal given by: x() = stn'(104) %3D is sampled using an ideal sampling tchnique. a) What is the Nyquist rate of this signal. Samplesec. the samplekse,
Q3] Let m(t) be a baseband signal whose spectrum is described in the figure below. This signal is sampled at the rates (a) 16kHz, (b) 25% over the Nyquist rate. DraW the spectrum of the sampled signal in each case. Mf) (Hz) 3k 0 3k 7.5k -7.5k
Q2. For the scheme shown in Figure Q2, Draw the spectrum of the baseband signal (multiplexer output) for the multiplexer. Determine the bandwidth of the baseband signal (multiplexer output) for the multiplexer. Determine the minimum transmission bandwidth of the multiplexer. Explain, briefly, the modification needed for the multiplexer in the figure to achieve this bandwidth. i. ii. ii. 4 kHz cos 10,000xt Baseband signal 2 kHz cos 24,000nt cos 2000nt cos 32,000nt Figure Q2
The following figure depicts a sampled analog signal for digital signal representation. By applying the concept of Pulse Code Modulation find the 4-bit code words and finally draw the line coding by using Bipolar-AMI scheme. You have to solve the problem by using step by step formulation of normalized PAM values, normalized quantized value, normalized error and quantization code. Assume that the sampling amplitudes are between -40V to +40V. Time Analog Signal Value (V) 23.7 1 -15.7 2 -29.6 3 20.5 33.5 4.