ment 1. Calculate the volume of liquid in a vertical cylindrical tank when the height of liquid is known. Tank height = 15 feet Tank diameter = 10 feet Volume of cylinder is V = T (d2/4)h π = 3.14 D= diameter h = height emil to boneq pnol s 10 sauso vom gniwol lav ogier svo art to dainW 1080

Q: I am trying to decide thesis topic for chemical engineering. Any suggestions? Thanks.

A: There are many thesis topic for Chemical Engineering. As we know that Chemical Engineer are always…

Q: Number of carbon atoms per molecule in Fuel oil is

A:

Q: A modified atmosphere requires higher-than-normal amounts of oxygen but sparing amounts of water…

A: Given that, The composition of stream A (dry air) xN2,A = 0.79xO2,A = 0.21xH2O,A = 0 The composition…

Q: A cylindrical pressure vessel of radius r = 10.2 in is filled with a gas at a pressure of 455.0 psi…

A: As given  Cylindrical vessel radius r = 10.2 in Gas pressure  = 455 psi Cap end radius R = 22 in

Q: Diesel index is defined ? as O (API) x (100)/Aniline Point, °F O (API) x (100)/Aniline Point, °C O…

A: It is required to define the Diesel Index.

Q: A process using two distillation columns in series is used to separate a feed stream (flow rate of…

A: It is given that process is having two distillation columns in series. Given data are as follows:…

Q: The following ratios make up an inert gas mixture: 80% N2, 15% CO2, and 5% Ar. The gas is injected…

A:

Q: An oil has a kinematic viscosity of 2 x 10 m²/s and a density of 0.8 x 10 kg/m³. If we want to have…

A:

Q: A four year old child has been playing in soil contaminated with 310 mg/kg of tetrachloroethylene.…

A:

Q: Ethanol gas is converted to ethylene gas and steam in a continuous pressurized reactor at 5 atm. If…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: A plate column is used to absorb SO2 from a gas stream with air, using pure water at 20 o C. 6.48…

A: As per the given  data, the flow diagram of the scrubber is given as : To Find

Q: 3. A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A: Hjjvbnjk

Q: Write the letter that corresponds to the unit processes Unit Process 1. Combustion 2. Neutralization…

A:

Q: Water is to be heated from 20°C to 70°C as it flows through a 40 mm internal Hiameter and 600 mm…

A: Given that T1 = 20 CT2 =70 Cd =40 mm =0.04 m l =600 mm =0.6 m m =0.2475 kgs

Q: 9-25. You have 100 grams of water at 25°C in a container that holds exactly 200 ml. What mass of…

A: We have a water (2) methanol (1) system. The mass of water added in a 200 ml capacity container is…

Q: Create an isothermal process that takes a gas/thermodynamic system from a Pi, Ti, Vį to a state…

A:

Q: 5.5 A series of experiments are done using a membrane osmometer on a sample of polystyrene, PS,…

A: Given data: Temperature = 25 0C Density of benzene = 874 kg/m3

Q: A huge amount of clean water at 78.98°F flowing past over a flat slab of solid C7H6O2. The velocity…

A: Given that- Velocity of fluid (water), v =0.361 ft/s= 0.11 m/s length of slab, L=9.6 inch=0.244 m…

Q: A differential manometer is used to measure the drop in pressure across a filter at a water…

A:

Q: Question 1- chapter 8 A rigid tank is divided into two equal parts by a partition. One part of the…

A:

Q: 1.0 moles of an ideal gas at 27.0°C expands isothermally from an initial volume of 20.0 dm³ to a…

A:

Q: A light hydrocarbon gas mixture is stored in a tank at 25C and 9.5 MPa. The gas mixture contains…

A: A mixture of hydrocarbon is given.

Q: QUESTION 3 A balloon filled with 12.50 L of Ar at 25.0°C and 1 atm rises to a height in the…

A: Given Data  Volume of the balloon (Vi) filled by Ar= 12.50 LTemperature (Ti) = 250C=298 KPressure…

Q: For the design case report: Two AES exchangers in series have trouble heating up a process stream…

A: Given that- Two AES exchangers are in series and have trouble in heating and cooling up a process…

Q: An airship has a volume of 60,000 m³ at 100 kPa and 20°C. How many kg of helium are needed to fill…

A: Given: Volume = V = 60000 m3Temperature = T = 20 C  = 293 K Pressure =P = 100 KPa = 100000 Pa we…

Q: in a job shop operation, four jobs may be performed on any of four machines. The hours required for…

A: The hours required for each job on each machine are presented in the following table as JOB…

Q: Txy diagram for acetone/ethanol system at 1.01 bar: T (°C) 80 75 70 65 60 55 0.0 0.1 Txy Plot for…

A: As given  Mole of feed F = 75  Composition of ethanol = 40%  Composition of acetone = 60% Mole…

Q: The reactor operates with an incoming RF flowrate of 20,500 lbmol/hr. There is a 50% excess air in…

A:

Q: An evaporation-crystallization process

A:

Q: 7.2. In Ex. 7.5 an expression is found for the Joule/Thomson coefficient, μ = (@T/P). that relates…

A:

Q: Saturated water vapor at 100 kPa is in a piston-cylinder device. At the initial state the piston is…

A:

Q: A thermostat control with dial markings from 0 to 200 is used to regulate the temperature of an oil…

A: Introduction Thermostat controller A tool that routinely controls heating or cooling device in this…

Q: A cylindrical tube has inner diameter of 20 mm and outer diameter of 30 mm. Find out the rate of…

A:

Q: pressure at the bottom of the tank?

A:

Q: What are the independent equations used and the volume of the second

A:

Q: The general formula for the alkynes is CnH2n-2 O True O False

A:

Q: 1000 kg/h of an aqueous feed solution containing 38 wt.% potassium nitrate (KNO3) and 0.2 wt.%…

A:

Q: Which of the following compounds is called 18-Crown-6? A B 0 C

A:

Q: For a monosized media filter with a particle size of 2.5 mm in diameter, a bed depth of 2 m and…

A: Given data: Diameter of particle = 2.5 mm Depth of bed = 2 m Porosity = 20 % Water temperature = 15…

Q: Any suggestions for thesis topic related to chemical engineering (environmental processes and…

A:

Q: Determine the process control strategy shown in this figure. Steam Feed FIT O Feedback Control O…

A: In the given figure, we have two input streams, one is the feed, and another one is the steam.…

Q: Badly need help pls. Use a tolerance value of 1 x 10-2 for your calculations. Do not use excel.

A: Note:  Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: A cylindrical pressure vessel of radius r = 10.2 in is filled with a gas at a pressure of 455.0 psi…

A: As given  Maximum force on bolt that can withstand = 32505lbf Net force exerted on each bolt holding…

Q: A mixture of mole fraction 0.500 ethanol and 0.500 water at 25 ºC is fed continuously to a vessel at…

A: Mole fraction of ethanol in the given mixture is 0.5 and mole fraction of water in the given mixture…

Q: Consider 50 m³ of moist air at 101 kPa, 25 °C, and 55% relative humidity. Calculate: (a) Humidity…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: a. 1. For the reaction: C(s) + CO2(g) →2CO(g) .Drive the relationship between Kp and Kc. b.…

A: Since we only answer up to 3 sub-parts, we'll answer the first 3. Please resubmit the question and…

Q: The elementary irreversible organic liquid-phase reaction A+B→C is carried out adiabatically in a…

A: An elementary irreversible organic liquid phase reaction is carried out adiabatically in flow…

Q: Given the following reaction with a feed rate of 15.0 kg/s each of H₂ and 0₂: 2H2(g) + O2(g) → 2H₂0…

A: Write the reaction as follows: 2H2g + O2g → 2H2Ol Two moles of H2 reacts with one mole of O2 and…

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A: Flow rate of recycle stream is to be determined.

Q: Question: C) The Antoine Constant For N-Heptane Are A = 13.8587, B = 2911.32 And C = 56.56.…

A: Given details: for n-heptane Antoine constants, A=13.8587 B=2911.32 C=56.56 we have to determine,…