need all parts MediumtDEmedium 2incidentwavetransmittedwarereflectedwaveE, Ma PzAplanewave isvertically incident fromthe medium 1(8, = 9ɛf = Hn) to the medium 2(& = 4e l2 = H). The incident electric field is E'. E'-r 2e [V/m].Solve the following problems.(1) Characteristic impedance of medium 1 and 2. (71:1)(2) Reflection coefficient I(3) Power reflectance coefficient(4) Transmission coefficient T(5) VSWR

Given: Note: It is the kind notice that according to the guidelines of the company,we supposed to…

Medium t medium 2 DE transmitted ware incident wave reflected wave E, Ma Pz A plane wave is vertically incident from the medium 1(8 = 9ep»H = H) to the medium (e, = 4e H2 = Hy). The incident electric field is E'. E'-r 2e[V/m]. Soive the following problems. (1) Characteristic impedance of medium 1 and 2. (7.12) (2) Reflection coefficient I (3) Power reflectance coefficient (4) Transmission coefficient T (5) VSWR

Medium t medium 2 DE transmitted ware incident wave reflected wave E, Ma Pz A plane wave is vertically incident from the medium 1(8 = 9ep»H = H) to the medium (e, = 4e H2 = Hy). The incident electric field is E'. E'-r 2e[V/m]. Soive the following problems. (1) Characteristic impedance of medium 1 and 2. (7.12) (2) Reflection coefficient I (3) Power reflectance coefficient (4) Transmission coefficient T (5) VSWR

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A wave guide in non magnetic medium with a= 2.28cm,b=1.01cm ,ɛ, =2.25. Find cutoff frequency for TE11 mode
A 2 V signal is incident to the interface from a 75 Ohm region propagating to a 50 Ohm impedance region. What is the reflection coefficient? What is value of the incident, reflected and transmitted wave? What voltage would you measure on either side of the interface right after the signal goes through the interface. For the interface, I'm a little confused. I used a voltage divider and got V_transmitted = 0.8 and V_incident = 1.2. But shouldn't they be the same?
P 2.7a What will be the cutoff wavelength for dominant mode in rectangular waveguide whose length is 10 cm? (2)
for non magnetic material having relative permeability of 2.25 sigma= 10^-4 S/m. find loss tangent, attenuation constant, phase constant, and intrinsic impedance for a wave having a frequency of 2.5MHz. assume material to be a good dielectric.
A uniform plane electromagnetic wave incident normally on a planesurface of a dielectric material is reflected with a VSWR of 3. What is the percentage of incident power that is reflected?
A uniform plane wave in air partially reflects from the surface of a material whose properties are unknown. Measurements of the electric field in the region in front of the interface yield a 1.5-m spacing between maxima, with the first maximum occur- ring 0.75 m from the interface. A standing wave ratio of 5 is measured. Determine the intrinsic impedance, 1„, of the unknown material.
What does the TE mean? Why does one have a 10 as subscript and the other mn? What is a broad and short dimension and a rectangular waveguide?
Q5 a) A fiber has the following characteristics: n1 = 1.45 (core index) and A=2%. Find the N.A and the acceptance angle.
1)Find the skin depth of an electromagnetic wave which is incident from air to a conductor and the frequency of the wave was 50 Hz with a permeability of 4.55*10-2.The conductivity in the conductor is given as 2.22. Select one: a.0 b. 0.15 c. 0.35 d. 0.25
A rectangular copper block is depth d along z, width w along y, and length / along x. In response to a wave incident upon the block from above, a current is induced in the block in the positive x-direction. Determine the ratio of the ac resistance of the block to its dc resistance at frequency f. 0: 5.8.107.- S m /:=1.2 m d: 40 cm W: 50 cm f:=2 kHz
The left end of a taut string of length L, is connected to a vibrator with a fixed frequency f. The right end of the string is tied to a suspended object of varying mass, m, through a pulley. For a mass m1 of the object, a standing wave with one loop is observed. For a mass m2 of the object, a standing wave with four loops is observed. What is the ratio "m2 / m1 = ?"
COS (2T10 Problem 4. A voltage wave of the form V+ = (2x 10-4V) cos( t-kz is incident from cable 1 with characteristic impedance 201 = 1200 onto a connection to cable 2 with characteristic impedance Z02=1002. Take the speed of the cable wave in each cable to be 2 x 10 m/s. A) Find the amplitudes of the reflected and transmitted voltages. B) Find the incident, reflected, and transmitted powers.