me proposed mechanism for the formation of phosgene (COC12) can be written in a simplified form as: Cl₂(g) Part A What rate law corresponds to this mechanism? k₁ k5 [CO]³/2 [C1₂] k3 K₁ K₂ k5 O k5 Oks k4 k₂ k3 k₁ k3 K₁ K₂ k¹ [CO][C1₂]³/2 [CO][C1₂]³/2 k₁ k₂ k3 k1 [CO]³/2 [C1₂] 2C1(g) Cl(g) + CO(g) COCI(g) k4 COCI(g) + Cl₂(g) → COC12 (g) + Cl(g) ks k₂ Fast Fast Slow

Q: Q1/ A / A frictionless piston cylinder arrangement containing fluid 200 kJ of heat is transferred…

A:

Q: Q8: HH H HH HH II c=c+c=c+c=c Styrene monomers I Polymerization HH HHHH I c-c-c-c-c-c-H C I H…

A: Polymerization is a chemical process in which tiny molecules, known as monomers, are chemically…

Q: Q.2: The combustion analysis using ORSAT apparatus, where the analysis indicated as 15% CO2, and…

A: Given data:In the dry stack gas, the composition of CO2 is 15 %.The fuel is C4H9OH.

Q: 4. A pump is used to take 33 L/s of vegetable oil (910 kg/m³) from a tank to an open discharge 18 m…

A: The objective of the question is to calculate the power requirements of a pump used to transport…

Q: Demonstrate the process of manufacturing of portland cement.

A: The objective of the question is to explain the process of manufacturing Portland cement, which is…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A: A (eth) + B (eth) → P (s)DHreact =−250kJ/mol-rA = k cA cB

Q: mol A batch reactor operates a reaction of AB. The reaction has the following rate law Determine the…

A: Given that

Q: (b) (c) Page 5 of 6 Calculate the gain, in percent transmitter output (%TO) per variable unit…

A:

Q: A gauge pressure of 83 psi to an absolute pressure in ??, if atmospheric pressureis 101 200 Pa

A: The objective of the question is to convert a given gauge pressure to absolute pressure. Gauge…

Q: Calculate the flow rate of Stream D from Question 1 (Figure 1). Your complete solution should…

A: Flow rate of Stream D.The process is at a steady state.All the propane in stream B reacts in the…

Q: 3-19. Draw the block diagram representing the following transfer functions. In each case, do not do…

A: Block diagrams are made up of a single block or a group of blocks. These are used to graphically…

Q: What is the relation between Q heat, Enthalpy and number of moles?

A:

Q: Key to the thermodynamic analysis of a cycle is remembering
U = 0 and
S = 0 a) Why is this true?…

A: The statement ΔU = 0 and ΔS = 0 is true for a cyclic process because in a cycle, the system returns…

Q: Write the oxide composition limits of OPC and explain their necessity

A: The objective of the question is to understand the oxide composition limits of Ordinary Portland…

Q: 1. Gaseous fuel consists of 20% CH4, 10% C2H6, 25% C3H8, 25%H2, 5% CO, 3% CO2, 3% O2, 4 % N2 and 5%…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: A 4mx5m wall consists of 3 glass windows of 1.5mx1.0m dimensions. The wall has thickness of 0.125 m…

A:

Q: What did we need to do to solve a problem like this? : released or 201°c and "absorbed when EVOH @…

A:

Q: 2. Calculate the specific surface in square centimeters per ram of pyrite having the screen analysis…

A: MeshPercentage…

Q: Complete the question by hand calculation(please show every step):- Do the mass balance and energy…

A: The following syngas gas conditions and composition are givenComponent Composition (mol%)Carbon…

Q: Q3. A mixed-base oil fraction of k=11.5 and API = 35, determine the latent heat of vaporization of…

A: Given, mixed-base oil fraction characterization factorThe formula to obtain specific gravity of…

Q: - Specifically define endothermic, exothermic, dissolution, and enthalpy -Explain how enthalpy can…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Antoine's equation is a correlation for vapor pressures based on the Clausius- Clapeyron equation.…

A:

Q: Question 4 (i) Why does a liquid crystalline fluid appear cloudy, but when heated sufficiently…

A: The question has three parts. The first part is asking why a liquid crystalline fluid appears cloudy…

Q: 2 A wire of diameter D = 2 mm and uniform temperature T has an electrical resistance of 0.01 2/m and…

A:

Q: the table provides data for ethane and argon at TR= 1.64. Use the given data to illustrate the law…

A: The compressibility factoris the ratio of a gas's molar volume to that of an ideal gas at constant…

Q: For the complete combustion of propane, C3H8, with 40% efficiency determine a. Balanced equation for…

A: The air-fuel ratio (AFR) is the mass ratio of air to a solid, liquid, or gaseous fuel used in a…

Q: What is osmosis? What is osmotic pressure? Match the items in the left column to the appropriate…

A: Osmosis is the movement of solvent molecules (usually water) from an area of lower solute…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A: The batch process involving the reaction of A and B to form P in an ethanol solution presents…

Q: 4.43. The popularity of orange juice, especially as a breakfast drink, makes this beverage an…

A: A flowchart for the given process should be constructed and labeled. The validity of the offered…

Q: A fluid with a density of 2 slug/ft3 flows steadily between two stationary flat plates as shown in…

A: The objective of the question is to determine the normal stress throughout the fluid using the x and…

Q: Stream B Rate: B = ?? Composition: Water: BW= 100% Evaporator 1 Feed: Stream A Rate: A = 50,000 kg/h…

A:

Q: A settling tank and related streams are shown in Figure 1, below. Dimensions in meters are given in…

A:

Q: For the predeposition heat treatment of a semiconducting device, boron atoms are to be diffused into…

A:

Q: Given the following adsorption data of Shen and Smith (1968), and using the Freundlich isotherm, 0 =…

A: Freundlich isotherm,Where,

Q: 2. Extent of reaction and fractional conversion: Consider the process to make ethylbenzene from…

A: The formation of Ethylbenzene form Benzene and Ethylene is given in the process as,Intital moles of…

Q: Krypton is contained in a closed cylinder fitted with a weightless piston at 162 K and 1 bar. Heat…

A: Given Data:Krypton is contained in a closed cylinder fitted with a weightless piston.The Pressure P1…

Q: Consider a plane composite wall that is composed of two materials of thermal conductivities k = 0.1…

A:

Q: Solubility (g solute/100ml solvent) 90 80 70 60 50 30 20 10 0 1Graph 1: Solubility Curves for KCI…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: 4. A total of 200 mol/s of a liquid mixture with 40 mol% benzene and 60mol % toluene is fed to a…

A:

Q: A closed rigid tank contains krypton at 100 K and 1 bar. Heat is added to the system until we reach…

A: The objective of the question is to calculate the amount of heat added to the system when the…

Q: The chemical reaction sequence A →B A+B →P takes place isothermally in a continuous, stirred-tank…

A:

Q: 6.52 Single pass and overall conversion: The diagram below shows a chemical process in which…

A: stream numberparameter1a1b234total mole…

Q: Water at 40 °C is pumped from an open tank through 200 m of 50mm diameter smooth horizontal pipe as…

A: The objective of the question is to calculate the power supplied to the pump, the Net Positive…

Q: Module code: CAPE205001 2 Ethylene oxide (C2H4O) is produced by a catalytic oxidation of ethylene…

A: Given data:

Q: Q2: Determine the size of a vertical separator to handle 600 bpd (barrel per day) of 55° API…

A:

Q: Heat Conduction The wall (thickness L) of a furnace, with inside temperature 800° C, is comprised of…

A:

Q: DRAW 2D DIAGRAM OF A SOLUTION TO  MAKE THE MIXING MUCH MORE EFFICIENT WITH DETAILED PARAGRAPH…

A: The first-order irreversible reaction performed in the  continuously stirred tank at produced a…

Q: a. Energy conversion based on hydrocarbon fuel combustion leads to the formation of pollutants. In…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Provide detailed drawing and explanation for the questions. No AI!

A: The objective of the question is to identify which of the given compounds has a stereoisomer that is…

Q: 1. a) Show representative interstitial sites (both octahedral and tetrahedral) present in FCC,BCC…

A: The objective of the first part of the question is to understand the interstitial sites in different…