Macmillan Learning A thin stick is placed along the x-axis so that one of its ends is at x₁ = 0.00 m and the other one at x₂ = 4.15 m. The stick has a non-uniform mass density λ(x) = ax + b, where a = 0.089 kg/m² and b = 1.077 kg/m. What is the x-coordinate of the center of mass of the stick? Xcm = m

Macmillan Learning A thin stick is placed along the x-axis so that one of its ends is at x₁ = 0.00 m and the other one at x₂ = 4.15 m. The stick has a non-uniform mass density λ(x) = ax + b, where a = 0.089 kg/m² and b = 1.077 kg/m. What is the x-coordinate of the center of mass of the stick? Xcm = m

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter13: Rotation Ii: A Conservation Approach

Section: Chapter Questions

Problem 79PQ

See similar textbooks

Similar questions

Find the net torque on the wheel in Figure P10.23 about the axle through O, taking a = 10.0 cm and b = 25.0 cm. Figure P10.23
Consider the disk in Problem 71. The disks outer rim hasradius R = 4.20 m, and F1 = 10.5 N. Find the magnitude ofeach torque exerted around the center of the disk. FIGURE P12.71 Problems 71-75
A 215-kg robotic arm at an assembly plant is extended horizontally (Fig. P14.32). The massless support rope attached at point B makes an angle of 15.0 with the horizontal, and the center of mass of the arm is at point C. a. What is the tension in the support rope? b. What are the magnitude and direction of the force exerted by the hinge A on the robotic arm to keep the arm in the horizontal position? FIGURE P14.32
A person carries a plank of wood 2.00 m long with one hand pushing it down at one end with a force F1 and the other hand holding it up with a force F2 at a distance of 0.500 m from the same end of the plank. If the plank has mass 20.0 kg and the center of mass of the plank is in the middle of the plank, what are the magnitudes of the forces F1 and F2? a. F1 = 392.4 N, F2 = 196.2 N b. F1 = 392.4 N, F2 = 392.4 N c. F1 = 196.2 N, F2 = 392.4 N d. F1 = 196.2 N, F2 = 196.2 N
A beam of negligible mass and a length of 1.00 m balances two masses m₁ 16 kg and m₂ = 8 kg. The distance of m₁ from the fulcrum is 20 cm. Let the distance of m₂ from the fulcrum be d2. Assume all quantities are correct to 3 significant figures. m2 m2g (a) For first condition equilibrium is m₁g-m₂g. N=0. N O N-m₁g-m₂g-0. N+m₁g-m₂g=0. N-m₁g+m₂g=0. mi mig (b) Match the directions of rotations induced by the forces about the fulcrum: A. N no rotation B. mg clockwise C. m₂g counter-clockwise
A rod of length 24.00 cm has linear density (mass per length) given by 50.0 + 19.0x where x is the distance from one end, and Ï is measured in grams/meter. What is its mass? How far from the x end is its center of mass? Need Help? Read Needs Complete typed solution with 100 % accuracy.
In exercise physiology studies, it is sometimes important to determine the location of a person’s center of mass. This determination can be done with the arrangement as shown. A light plank rests on two scales, which read Fg1 = 380 N and Fg2 = 320 N. A distance of 1.65 m separates the scales. How far from the woman’s feet is her center of mass?
Problem 3: A large airplane typically has three sets of wheels: one at the front and two farther back, one on each side under the wings. Consider the Boeing 787 "Dreamliner", with a mass of 189000 kg. In this particular model, the distance from the front wheels to the rear set of wheels is 21 m. Part (a) If the center of mass of the airplane is along a line through the center and 3.00 m in front of the rear wheels, how much force, in meganewtons, does the ground exert on each set of rear wheels when the plane is at rest on the runway? F, = sin() cos() tan() 8 9 HOME cotan() asin() acos() E 5 6 atan() acotan() sinh() 2 3 cosh() tanh() cotanh() END ODegrees O Radians Vol BACKSPACE DEL CLEAR Submit Feedback I give up! Hint Part (b) How much force, in meganewtons, does the ground exert on the front set of wheels?
A person carries a plank of wood 2.00 m long with one hand pushing it down at one end with a force F, and the other hand holding it up with a force F, at a distance of 0.500 m from the same end of the plank. If the plank has mass 20.0 kg and the center of mass of the plank is in the middle of the plank, what are the magnitudes of the forces F and F,? F, = 196.2 N, E, = 392.4 N F2 F, = 392.4 N, F, = 392.4 N %3D F, = 196.2 N, F, = 196.2 N %3D 3 4 F, = 392.4 N, F, = 196.2 N || %3D
Fred Flintstone’s club–ax is made up of two parts: an uniform 4.0 kg stick and a symmetrical 7 kg stone attached to the end of the stick. The dimensions of the club-ax are shown in the figure. How far is the center of mass from the handle end of the club-ax? Express your answer in cm.
A large airplane typically has three sets of wheels: one at the front and two farther back, one on each side under the wings. Consider the Boeing 787 "Dreamliner", with a mass of 198000 kg. In this particular model, the distance from the front wheels to the rear set of wheels is 23.8 m. a) If the center of mass of the airplane is along a line through the center and 3.00 m in front of the rear wheels, how much force, in meganewtons, does the ground exert on each set of rear wheels when the plane is at rest on the runway? b) How much force, in meganewtons, does the ground exert on the front set of wheels?
In exercise physiology studies, it is sometimes important to determine the location of a person's center of mass. This determination can be done with the arrangement shown in the figure below. A light plank rests on two scales, which read F, = 395 N and F, gi = 340 N. A distance of 1.65 m separates the scales. How far from the woman's feet is her center of mass? g2 1.65 m F 18. F 82