Nitrogen gas flows through a compressor and a heat exchanger as shown in the figure below. All theprovided properties at the inlets and outlets of both devices are shown. Nitrogen is modeled as anideal gas. A separate cooling stream of Helium, also modeled as ideal gas, flows through the heatexchanger to lower the temperature of nitrogen. Assume that both devices are perfectly insulatedand both gasses have constant specific heat values:Cpo of nitrogen = 1.042 kJ/kg. K) and Cpo of helium = 5.193 kJ/kg.K)A. Identify the systems, the process that each system goes through, and the assumptions you needto make for each process.B. Find the temperature of nitrogen at the exit of the compressor (T2)C. Determine the mass flow rate of the helium.50 kWCompressorN₂P₁ = 100 kPaT₁ = 280 Km₁ = 0.25 kg/sT₁ = 175°C +5Helium4+T4=4+T4=25°Cwwwwww.T3 = 350 KHeat exchanger

Answered: Image /qna-images/answer/137217cd-a572-4d08-8b75-0d851d747863.jpg

Answered: lower the temperature of nitrogen.…

lower the temperature of nitrogen. Assume that ses have constant specific heat values: gen 1.042 kJ/kg. K) and Cpo of helium = 5.1 =

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In a condenser test, the following observations were made:Vacuum = 69 cm of HgBarometer = 75 cm of HgMean temperature of condenser = 35°CHot well temperature = 28°CAmount of cooling water = – 50,000 kg/hrInlet temperature = 17°COutlet temperature = 30°CAmount of condensate per hour = 1250 kgFind(a) the amount of air present per m3 of condenser volume.(b) the state of steam entering the condenser.(c) the vacuum efficiency .R for air = 287 J/kgK
Air at 90 degree C and 1.0 atm contains 10 mol% water. A continuous stream of this air enters a compressor-condenser, in which the temperature is lowered to 15.6 degree C and the pressure is raised to 3.0 atm. The air leaving the condenser is then heated isobarically to 100 degree C. Make a detailed flowchart with the unknowns and Degree of Freedom.
Consider the steady-state counterflow heat exchanger shown below. There are separate streams of air and water, and each stream experiences no noticeable change in pressure. Stray heat transfer with the surroundings and changes in kinetic and potential energy can be ignored. For the air, the ideal gas model can be applied and Rair = 0.287- For the operating conditions provided on kg-K the figure, determine: a. The temperature of the air at the outlet of the heat exchanger, T4, in [K] b. The rate of heat transfer between the air and the water, in [kW; , c. The rate of entropy production for the heat exchanger, in [kW/K] kg msteam = 12 P1 = 3 bar X1 = 1 P2 = P1 T2 = 200 P3 = 1 bar T3 = 1100 K P4 = P3 T, =? mair kg = 3.29
O Falge QUESTION 2 The refrigerant undergoes a change of phase during the heat-transfer process, the pressure of the retrigerant is the saturation pressure during the low supply and low rejection processes. True False QUESTION 3 Frequently, the vapor of the liquid leaving the condenser is lower than the saturation temperature. O True False QUESTION & The pressure of the iquid leaveng the condenser we be less than the pressure of the vapor entarng, wd etempernd the retigerant in the condenser. O Te QUESTION S Are many situations in which it is desirable to combine three cycles in series, either power systems or refigertion sytems, to take advantage of a very wide temperature range or to utilize what would otherwise be waste heat to improve etficiency O true O False QUESTION 6 A cycle can't be made very efficient, since the temperature differences between the two fluid streams can be controlled through careful design of the combined system. True
4. GoBrownsite is an obscure element with a molar mass of 126.2 grams per mol. Below is the cooling curve for GoBrownsite. How much energy needs to be removed from a 250.0 g sample of GoBrownsite knowing the following. Heat of Condensation AH = -165 kJ/°C • Specific heat of liquid GoBrownsite = 197 kJ/g-°C Heat of Freezing AH = - 231 kJ/°C Cooling Curve 80 e) to (1) 60 40 20 -20 Temperature 40 -60 -80 -100 (1) to (s) -120 Time
How much heat is needed to completely vaporized 100 kg of ice at -10 C if the pressure held constant 200kPa. latent heat of fusion at 200 kpa is 320 kj/kg latent heat of vaporization at 200 kpa is 2 202 kjkg. show t.s Diagram and all units.
A resistance heater is to raise the air temperature in the room (dimensions 4 m x 5 m x 6 m) from 5°C to 25°C within 11 min. Calculate the required power of the resistance heater. 4x5x6 m³ 5°C AIR We Assume that air is an ideal gas and the room is air-tight (no air can leak out or into the room). The initial pressure of the air is 100 kPa. The gas constant of air is R = 0.287 kPa m³/(kg K). Also, cy = 0.718 kJ/(kg K) for air at room temperature (assume the specific heat is constant in the considered range of temperatures).
N = 0 An insulated tank of volume 10+(10+N)/25 m and with a valve was filled with perfect tri- atomic gas at pressure 10 bar, where N is equal to the last two digitals in your student's ID number. Initially the valve was closed. A paddle wheel was mounted inside the tank and was run by 20 kW engine. The paddle wheel was turn on and at the same time the exit valve was opened. The gas temperature was constant though the whole process (due to very slow flow) and equal to 300 K. Calculate the time needed to decrease the pressure in the tank to 5 bar.
1. Condensation streams through an outlet at a mass movement rate of m=0.2kg/s with a heat loss of 5kW. The enthalpies at creek and exit are 2500kJ/kg and 2350kJ/kg respectively. Assuming negligible velocity at inlet (c1 = 0, the velocity (C2) of team (in m/s) at nozzle exit is
Octane is heated in a heat exchanger under constant pressure of 10 bar from 200 K to 400 K. Use the SRK equation to calculate the heat added to the system. Report your answer in units of kJ/mol using three decimal places. The ideal gas heat capacity of octane may be assumed constant and CPig/R=23.174. Under these conditions octane is a liquid.
V. W. Th To %3D Room temperature T = 293 K V V. Vp The gas volume changes from Vp to Va at constant temperature T. The cartoon on the right shows a piston of gas undergoing this compression while submerged in a container of room temperature water, which acts as a reservoir. The initial state of this process is a piston containing 2 moles of a monatomic gas at Tc = 293 K (room temperature water) and volume V = a 1.0 m. The gas is compressed until V, = 0.2 m. During the compression, the heat bath of room temperature water maintains the temperature of the gas at T 293 K. Calculate the work done in joules by the gas during this process. Do not include units in your answer. Be careful to use the standard sign convention for work done by the gas. Write your numerical answer in normal form as described above in the instructions to this worksheet.
3.) An ammonia compressor operates at evaporator pressure of 316.02 kPa and a condenser pressure of 1557 kPa. A twin-cylinder compressor with bore to stroke ratio of 0.85 is to used at 1200 rpm. The actual volumetric efficiency is 92% and compression and mechanical efficiency is 78% and 80% respectively. For a cooling capacity of 25 TR, (a) the sketch the p-h diagram labeling the evaporating and condensing temperature and pressures (b) define the all properties of ammonia taken from saturation table. Determine (c) the quantity of cooling water in the condenser in kg/min if the increase in temperature is 8°C, (d) the bore and stroke expressed in cm and (e) the size of the driving motor in hp. Given: h2 = h at 1557 kPa and s2 = s1 1695 kJ/kg