Listed below are total and suspended solids data.( answer 4-7) Weight of empty dish =85.325 gm. Weight of empty dish plus dry solids -85.521 gm. Weight of empty dish pluignitedsolids -85.375 gm. Volume of wastewater sample =75ml Weight of glass-fiber filter disk=0.1400 gm. Weight of glass-fiber filter disk plus dry solids = 0.1495 gm. Weight of glass-fiber filter disk plus ignited solids 0.1418gm geR bns lein 4) Total solids in sample is 196mg/1 3527 mg/ 2613 ing 567mg/l olme 5) Total volatile solids 1946 mg/ 2735mg/1 589mg/1 1933mg/ 6) Total, suspended solids 127mg/1 365mg/ 1266mg/ 1872mg/ 7) Volatile suspended solide 208mgT 103ng/ 34mg/l 672mg/l

Q: Practice # 1 Find the specific volume, WBT, moisture content and specific enthalpy of air at 35 °C D...

A: Hello Subscriber! There are multiple questions posted.. As per our policy, we have solved the first ...

Q: Distillation is used to separate pentane from hexane. The feed amounts 700 mol/s and has amole ratio...

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved th...

Q: A food is initially at a moisture content of 90% dry basis. Calculate the moisture content in wet ba...

A: Given:  Moisture Content in Dry Basis = MCdb = 90% = 0.9  Moisture Content in Wet Basis = MCwb we k...

Q: Oxygen undergoes a thermodynamic cycle comprising the following three processes consecutively: a. Co...

A:

Q: A reaction and separator, are configured as shown in the diagram, to produce pure streams of compone...

A: As per bartleby guidelines only first 4 parts can be answered. for remaining parts please resubmit q...

Q: Calculate the volume of air, in excess of 20%, required for the complete combustion of 1 L of a gase...

A: Given Details: 1 L of gaseous fuel with volumetric composition CH4=60%=0.6 LC2H6=15%=0.15 LC3H8=15%=...

Q: Question 1 Air in a certain area has the following molar composition: N2 74.1% O2 15.3% H20 3.2% CO2...

A:

Q: 2) A burner uses Pittsburgh coal analyzing 14.1% ash, 2.1%N and 4.3% S. Excess air is supplied dry a...

A: Given Details: A burner uses Pittsburgh coal analyzing 14.1% ash, 2.1% N and 4.3% S. The stack gases...

Q: boling point boling poin vapourcompositon pune iquid omposition Bptel pure 8 DA 1DB 10 moe ractons C...

A: T, xy diagram of a binary mixture represent the variation in composition of components in liquid and...

Q: Find : a. minmum Water flow rate b. recovery of S02 if actual water flow rate is used 6. Using actua...

A:

Q: A 20 wt % sucrose (sugar) solution having a density of 1074 kg/m³ is flowing through the same piping...

A: Given that :Q1 =1.892 m3hr =1.8923600m3s=5.255 x 10-4 m3sρ =1074 kgm3D1 = 2 inch =0.0508 mD2 =3 in =...

Q: A mixture of gases contains 40 % of CO2, 30 % of CO, and 30 % of N2 by volume. Calculate the amount ...

A:

Q: Che calculator on excel. But what are the equations for those two? Can you help me? Thank you. I wil...

A:

Q: Solve for the volume using Newton-Raphson Method. Show table of each iteration from 1 to 3 and the l...

A: The volume of gas is obtained from the ideal gas equation. The product of pressure and volume of a g...

Q: A gas cylinder with a volume of 2.50 m' contains 1.00 kmol of carbon dioxide at T= 300 K. Use the SR...

A: Given: Volume=2.5 m3 Temperature T=300K Tc=304.2 Pc=72.9 atm ω=0.225 Required to find: The gas press...

Q: Differentiate crystal structure, crystal system, and crystal form. How to find what a materials crys...

A: Given data: Structure of copper = FCC Number of unit = 1

Q: the isomer with the chloride on same * sides of the double bond is called DI Cis Tri Trans When remo...

A: Given data The isomer with the chloride on same sides of the double bond is called_

Q: Coal fired in a furnace analyzes 16.6% CM,16% ash, 61.4% 6% M, 1.2%N and 1.8%S with a calorific valu...

A: The coal's combustion gives residue and stack gas. The combustion occurs due to air. The combustion ...

Q: A thin plastic membrane is used to separate helium from a gas stream. Under steady-state conditions ...

A: L

Q: 1. Take the general reaction rate equation [ - (dCA/dt) = k ( CA ] and change it till linear equatio...

A: Given, The general reaction rate equation We know that , log(ab)= loga + logb    

Q: Q8/ A turbine that uses steam drives an electric generator. The inlet steam flows through a 10-cm-di...

A:  A turbine is an open system with unsteady-state conditions. The change in internal energy is neglig...

Q: 10 mol of an ideal gas with Cy = 20.8 J/mol · K at T, = 300 K and p. = 0.3 MPa occupy the left half ...

A:

Q: A single step differential batch still processes a mixture if two compounds having a volatility of 4...

A: Given data: Initial amount of A = 600 mol Initial amount of B = 400 mol Relative volatility = 4

Q: Two tanks are connected by a valve. A tank contains 2 kg of carbon monoxide gas at 77°C and 0.7 bar....

A:

Q: Hot air at atmospheric pressure and 80°C enters an 8-m-long uninsulated square duct of cross section...

A: Given Hot air Ti=80℃ Uninsulated square L=8 m Cross section=0.2m×0.2m V=0.15 m3/s Ts=60℃ Te=71℃ Fi...

Q: Aqueous A at a concentration C,, = 1 mollliter is introduced into a batch reactor where it reacts aw...

A: Given Details: For initial concentration , CA0=500 mol/m3 determine the conversion of reactant after...

Q: Calculate the heat of formation of H20 (I) at 90°C from the heat of formation at 25°C. H2(g) + ½ O2(...

A: The heat required or produced for one mole of product compound formation is called the heat of forma...

Q: 1. A spherical balloon contains air at P1 = 120 kPa and is placed in a vacuum. It has an initial dia...

A: Given thatP1 =120 KPaD1 =0.3 mD2 =0.4 m

Q: Q. Hot oil at 120°C with a flow rate of 95 kg/min is used in a shell and tube heat exchanger with on...

A: Given that :For Hot fluid Thin =120 Cmh =95 kgminFor cold fluid Tcin  = 30 C mcin = 55 kgminU = 250 ...

Q: Example 2.3-3 - A gas cylinder with a volume of 2.50 m' contains 1.00 kmol of carbon dioxide at T= 3...

A: Given Data Volume of the gas cylinder (V) = 2.50 m3The moles of CO2 gas present (n) = 1 Kmol The tem...

Q: Solve the value of delta H.

A: Given that, Reaction 1: Cs + O2g → CO2g                     ∆H1 = -393.51 kJReaction 2: H2g + 12O2g ...

Q: 2. The Henry's Law constant for hydrogen sulphide (H,S) in water (H,O) at 25 °C is 5.5 x 10ʻ kPa. a....

A:

Q: With N the number of moles, a, b two positive constants and S, U, V entropy, internal energy and vol...

A:

Q: 1 mole of carbon monoxide (CO) is burned with 10 moles of air in an atmospheric adiabatic reactor. C...

A: Given that, The number of moles of CO burned nCO,f = 1 mol The number of moles of air fed nair = 10 ...

Q: Calculate the pH of the following: 500 ml of pure water 10.0 ml of 0.3 F hydrochloric acid added to ...

A:

Q: Cylindrical surface multilayer Problem: A steam pipe line with inside diameter of 150 mm and outside...

A: From the given diameter we will obtain three radii and name them accordingly. The temperatures are c...

Q: a) Using the given data for air, determine the values and units of C and S. b) How do the values cha...

A:

Q: A gas mixture containing 25% mol CO2 and 75% NH3 is being scrubbed byan acid solution to remove the ...

A: Given data: Composition of gas mixture entering the tower is, CO2= 25 mol % NH3= 75 mol % Compositio...

Q: Air enters the base of a cooling tower at 1 atm. and 18ºC. The relative humidity is 60% and the flow...

A:

Q: The sludge removed from the sludge zone of the settling tank in Example 6.14 has a solids concentrat...

A: The flow rate is obtained from the ratio of mass and density of sludge. The vacuum filter efficiency...

Q: Determine the approximate density of a high-leaded brass that has a composition of 625 wt% Cu. 30.5 ...

A:

Q: 7. In cation exchange reaction, how many grams of K+ will replace 2 meq of Ca2+ if K+ has a atomic w...

A: no. of meq = milligram/ eqivalent weight equivalent weight =  molecular weight/Valence

Q: AH QI: CalculateAHRx AC, and RK (400) (T in K) for the reaction A→ 2B + C There are inerts I present...

A:

Q: Example (H.W): A mixture of 50% mole normal heptane and 50% normal octane at 30°C is continuously fl...

A:

Q: An enol has a carbon-carbon double bond and an OH group bonded to * one of the (SP) carbons False tr...

A:

Q: assessment. Question 7 The average molecular weight of a mixture that contains 30 mol% CO2 (MW = 44 ...

A: Supposed that- Total moles of mixture = 100 mol Then, CO2 = 30 mol % = 30 mol O2= 30 mol % = 30 mol ...

Q: Feed line 0.9 0.8 0.7 R.O.L 0.6 y 0.5 S.O.L 0.4 0.3 0.2 0.1 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1 Fr...

A: Given data: Molar flow rate of feed = 100 kmol/h The McCabe Thiele diagram of the binary mixture is ...

Q: Using the Peng-Robinson equation of state develop a compression factor and molar volume chart for ca...

A: Write the general expression for Z as follows: Z = 1+ β-qβZ-βZ+εβZ+σβZ3-AZ2+B+qβZ = C              ....

Q: Chemical Engineering Question

A:

Q: 18. From the following reacțions and thermal data at 25°C 3 2 Fe(s) + O2(g) = Fe,O1(s) ΔΗ- -196,500 ...

A: According to the hess law overall  enthalpy change for a reaction is equal to sum of enthalpy change...