linear network has a current input 4cos (@t+20°)A and a voltage output 100 cos(@ t+10°) V. What is 24.6-4.34j 25-10j None of the answers 0.039+4.94mj

Q: H.W E = 12 V For the network determine the sinusoidal Expression for the voltage V; using…

A:

Q: 2 the system has reached steady state. The source is is an AC source with w = 2 rad/s. Its phasor…

A:

Q: rad If w = 2n · 60 = 377aa, find the time-domain functions for the following phasor voltage and…

A:

Q: Find the current flowing through the RLC circuit connected through an AC source of 240 V as given…

A:

Q: Q5: Covert the following phaser domains to time domains and vise versa 食 V= 50 sin V= 30 sin V=…

A: in  time  domain  Vt=Vm↑  cos  cot+θ   ↙this  can be  sine  or  cosine  value       voltage  here…

Q: 20) 20) With an input sinusoid as shown, determine the yvo(t). Another way of saying this is what is…

A:

Q: Solve for the total impedance of the circuit at 60 Hz. R1=5ohms L1=21.22mH C3=132.63 microF…

A: This question belongs to circuit theory . It is based on the concept of series and parallel…

Q: ELECTRICAL CIRCUIT: Solve the problem and show your complete solution. The maximum values of the…

A:

Q: An alternating current is given by the expression i = 200 sin (314t + T/6) amperes. The maximum…

A: Given: Expression for alternating current i=200sin314t+π/6 amperes

Q: The below circuit is operated with driven angular frequency of wd = 120 (rad/s). The circuit has…

A:

Q: Find the phasor representation of an independent sinusoidal current source given as follows: i(t) =…

A:

Q: Given į =-10 sin(3t-85degree) e. Find the Frequency of the current f. Calculate at i at t= 2 ms.

A:

Q: Given v1 = 20 sin (ωt + 60˚)V and v2 = 60 cos (ωt - 10˚)V, determine the phase angle between the two…

A:

Q: Q1 Choose the corect answer for ALL of the following questions. (a) Which of the following is not a…

A:

Q: 9.3 Express the following functions in cosine form: (a) 10 sin(wt + 30°) (b) –9 sin (8t) (c) – 20…

A:

Q: 1. Transform these sinusoids in to phasors. (a) v = 7 cos(2t + 40°) V (b) i = -4 sin(10t + 10°) A 2.…

A:

Q: Consider the sinusoidal voltage ) = 48 cos(32t+ 10) V. NOTE: This is a multi-part question. Once an…

A:

Q: Consider a sinusoidal current i=Icos(15[rad/s] -t). Its current phasor makes an angle 135⁰ with the…

A: The sinusoidal phasor starts at t=0. It has maximum value at t=0. Then it starts to decrease and…

Q: Q2) Assuming a sinusoidal source and uniform load flow. Analyze the following circuits and draw…

A: 1) The transformer is 1:1 transformer so the secondary voltage will be equal to primary voltage. For…

Q: Ex. 681. Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal frequency is…

A: In this question series RLC circuit is given....we have to find current and voltage across R,L,C...

Q: Reduce 5 sin(ωt)+5 cos(ωt+30°)+5 cos(ωt+150°) to the form Vm cos(ωt+θ)..

A: = 5 sin(ωt)+5 cos(ωt+30°)+5 cos(ωt+150°)=5(cos ωt+90°+cos(ωt+30°))+5 cos(ωt+150°)=5(2cos…

Q: Use CTFT table and properties to find the numerical value of x(t) at t=0.75 if x(t)= 3 sinc (2t) *…

A:

Q: Find the phasor representations of the following sinusoidal voltages and currents. a. v(t) = 10…

A: The given voltage and current expression should be converted as similar to the general expression of…

Q: 10 30 50 Wa (1000 rad/s) In an alternating current circuit, the current amplitude versus the driving…

A:

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

A: Given, e=20+15sin1000t+10sin3000t+5sin4000tThe RMS value of the voltage…

Q: If w = 2n · 60 = 377 find the time-domain functions for the following phasor voltage and currents.…

A: Given, Two problems in phasor domain. We have to find time domain. Please find the below attachments…

Q: Q.NO.3 In an ac circuit two loads of impedances 100x + 0j N and 10x + j20 N are connected in…

A:

Q: a) CONSTRUCT THE FREQ. DOMAIN EQUIV. CKT. CAL CULA TE THE STEADY VTATE CURRENT į by PHASOR. METHOD.…

A: In this question we need to construct the given circuit in frequency domain and we need to find…

Q: 13. For the following pairs of sinusoids, determine which one leads and by how much. (a) v(1) = 10…

A: In this question,  Which signal is lead to other and how much leading?  We know sin(90+@) = cos@…

Q: 2. A voltage waveform, v(t) = 200 V sin ( 250 rad/s t ), is connected across a series combination…

A: In this question series RL circuit is given...We have to find out total impedance , source current ,…

Q: Obtain the sinusoids corresponding to each of the following phasors: a. V1 = 60415°, w = 1 b. V2 =…

A: There are two questions. Since you have not mentioned which question you are looking for, so we are…

Q: For the following pairs of sinusoids, determine which one leads and by how much. (a) v(1) = 10…

A: Given, We have a, b and c. We have to solve. Please find the below attachments for the clear…

Q: The equation of two currents in parallel connected in electric devices are i = 12 sin ( 377t +T/4)…

A: Two equation of currents are given  Both current in parallel connected in electric devices  Find the…

Q: A sinusoid v, =V m1 cos (ot + 35") leads another sinusoid V2= V, sin (ot + p) by 120 degrees. What…

A:

Q: Consider the sinusoidal voltage v = 48 cos(32t + 10°) V. NOTE: This is a multi-part question. Once…

A: Given: Vt=48 cos 32t+10°V

Q: 3. A sinusoidal voltage is applied to the circuit below. Determine the following: I, Irm, lavg, Ip-…

A: Given that sinusoidal voltage equal to 10V ad R = 1k ohm To find Ip Irms Iavg Ip-p

Q: + va Up ein + + +

A: Apply kvl in outer loop and add all the voltages as a phasor .

Q: For the circuit shown, what value of capacitance when placed in parallel with the load will change…

A: Given Load voltage VL=380∠0° rmsLoad KVA SL=70 KVALoad power factor P.F=0.8 Lagω=377 rad/sec The…

Q: e = 80 cos (400t + 30°), R, =60 ohms, R,= 30 ohms, and C=62.5 µF. Sketch/draw the phasor equivalent

A:

Q: 3-Phase mult, - Cunctuctor's has hes firrent dencity find the inductance Per pinus. pe km leny th of…

A:

Q: 4) For the following pairs of sinusoids, determine which one leads and by how much. a) v(t) = 10…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: For the circuit below with a sinusoidal voltage source, determine the average power supplied be the…

A:

Q: 1. For the following sinusoids, draw the phasor diagram and determine which one leads and by how…

A: Part a:  Given that…

Q: 10A P C) 130 μT d) 160 μΤ Pitch of the path is 2B 2nmv cos0 a) 2πην sinθ b) 2Tmv cos 0 d) 2B 2Tmv…

A: Solve the problem

Q: A series RLC circuit with L=160 mH, C= 100 micro F and R=40 ohm is connected to a sinusoidal voltage…

A:

Q: The voltage across a 100 resistor is 40 sin (377t-20). Find the sinusoidal expression for the…

A:

Q: What is the result of the following in time domain? 20 sin 400t + 10 cos(400t + 60) – 5sin(400t –…

A:

Q: (p) Suppose for some arbitrary system: 1 20.97 s+2 - j2 ' s+ 2+ j2 12-0.97 H(s) = = + Write down…

A: For finding h(t) we have to take invese Laplace transform and given h(t) is causal so take only…

Q: Given the following voltage and current: i(t) = 5 sin(377t - 40°) A v(t) = 10 cos(377t + 90°) V…

A: Given it =5 sin377t-40° Avt =10 cos377t+90° V

Q: v1(t) = 5 sin ( 150t + V 6 v2(t) = 2 sin ( 150t V

A:

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).