LA J Z₁ lc Three-phase source Feeder lines Balanced load the above circuit diagram, we have source impedance Zg = 0.05+j0.15 ohm, Z, = 0.1+j0.2 ohm and per phase impedance in the alanced Delta connected load, Z₁ = 12+j9 ohm. RMS value of source voltage is 200 volt. Phase sequence is as shown in the diagra EMS value of current lc = ampere Phase angle of lc = degree RMS value of line voltage VCA = V₁4-120 V4120 volt Inc ICA

LA J Z₁ lc Three-phase source Feeder lines Balanced load the above circuit diagram, we have source impedance Zg = 0.05+j0.15 ohm, Z, = 0.1+j0.2 ohm and per phase impedance in the alanced Delta connected load, Z₁ = 12+j9 ohm. RMS value of source voltage is 200 volt. Phase sequence is as shown in the diagra EMS value of current lc = ampere Phase angle of lc = degree RMS value of line voltage VCA = V₁4-120 V4120 volt Inc ICA

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.5MCQ

See similar textbooks

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
Please help with this balanced three-phase circuit problem.
128, An equipment has an impedance 0.9 p.u. to a base of 20 MVA, 33 kV. To the base of 50 MVA, 11 kV, the p.u. impedance will be (a) 4.7 (c) 0.9 (b) 20.25 (d) 6.75
The total reactive power consumed by the three-phase load(in VAr) is??
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit.
about Three-phase Circuits
Power in a three phase delta system with balanced load is equal to (Sqrt (3)) (VL) (IL) (p.f.) (Sqrt (3)) (Vph) (Iph) (p.f.) (Sqrt (3)) (VL) (Iph) (p.f.) O (Sqrt (3)) (Vph) (IL) (p.f.)
A 50 cycles, 3 phase alternator with grounded neutral has inductance of 1.6 mH per phase and is connected to busbar through a circuit breaker. The capacitance to earth between the alternator and circuit breaker is 0.003 uF per phase. The circuit breaker opens when rms value of current is 7500 A. Determine the following: i) Maximum rate of rise of restriking voltage. 1) Time for maximum rate of rise of restriking voltage. in) Frequency of oscillations
Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams of all three cases.
What is minimum and non minimum phase system. Draw its phase characteristic curve.
A 3 phase 200 MVA capacitor bank is to be switched off (disconnected) the grid that operates at 13.8kV (3-phase) at 60 Hz. The capacitor is connected in a WYE configuration, therefore the voltage across each phase is VLN=7.97KV. A restrike occurs at the zero crossing of the current. Determine the magnitude of voltage across the capacitor after the restrike. b. 0.05 mSec after the first restrike the arc extinguishes, which leaves a 1st charge trapped. Another restrike occurs again 3/8 of a cycle after the first restrike and is quickly extinguished. Identify the magnitude of voltage trapped across the capacitor after the а. second restrike.