K, cm/min Water 0.0025 NaCl 0.021 HCI 0.055 dn; = K;(ci, - Cip)d AM

Q: Outside air must be processed before entering the ventilation system of a sauna. Air always exits th...

A: Given information:   Exit air specifications: Temperature, T2­ = 25°C Pressure, P2 = 1 atm Relative ...

Q: Aluminum oxide was prepared by heating 225 g of chromium (II) oxide with 125 g of aluminum. Calculat...

A: The percentage yield in the given reaction if 100 g of aluminum oxide were obtained is to be determi...

Q: Fuel used as the main energy source for incineration contains M% of carbon. The amount of carbon dio...

A:

Q: Consider diffusion with a Homogeneous, First-Order Chemical Reaction:Rewrite the work for spherical ...

A: Diffusion is the process of mass transfer in which the molecules is transferred from the higher conc...

Q: a. Calculate the porosity of the core

A: Given data: The density of the oil = 0.85 g/cc Weight of dry sample in air = 42.4 g Weight of the sa...

Q: Air at 15 psia and 200°F is flowing through a 3-in steel pipe( 3.50-in OD,3.067-in ID) which is cove...

A:

Q: 29.14 An absorption tower, operating at 20°C and 1.0 atm, is used to absorb sulfur dioxide from an a...

A: Operating temperature and pressure of an absorption tower to absorb SO2 (A) from air mixture into H2...

Q: A meat processing factory’s raw effluent has a five day BOD at 20 degrees Celcius of 1760 mg/l. If t...

A: Given information:   The temperature of the effluent is 20°C.   5 day BOD of this effluent is, L(5) ...

Q: Assume that the tank volume is 25.0 m3, the temperature 25.0°C and the gauge pressure 15.0 bar.Calcu...

A:

Q: What is the difference between an equilibrium-based and a rate-based calculation method?

A: The equilibrium-based method and rate-based method are to be differentiated.

Q: How do pressure-swing and thermal-swing adsorption differ? What are inert-purge swing and displaceme...

A: The difference between pressure swing adsorption and thermal swing adsorption is to be mentioned. Th...

Q: Consider the reactionPure A is fed to a 1.0-dm3 CSTR where it reacts to form a desired product (D), ...

A: (a)   The given reaction is:   Volume of CSTR, V = 1 dm3 Feed is pure A, cA0 = 1 mol/dm3 Molar flow...

Q: Air is contained in a piston cylinder arrangement as undergoes a cycle as shown in the figure. The i...

A:

Q: Coconut milk was extracted from fresh coconut flesh. The rheological behavior of coconut milk contai...

A: Note: Since we only answer 1 question, we’ll answer the first one. Please resubmit another question ...

Q: Studies have revealedextremely high deposits of heavy metals and particulate matter in rivers, makin...

A: Extremely high deposits of heavy metals and other particulates makes the drinking water unfit. The s...

Q: A spiral-wound module made from a flat sheet of membrane material is 0.3 m in diameter and 3 m long....

A: Given information:   Dimensions of the spiral-wound module:   Packing density is given as membrane ...

Q: Porous silica gel of 1.0 mm particle diameter, with a particle density of 1.13 g/cm3 , an inclusion ...

A: Porous silica gel is used to adsorb the propane from helium by the adsorption separation operation. ...

Q: CaCO3 filter cake in a tray is to be dried by cross-circulation from the top surface. Each tray is 2...

A: Tray specifications: Height, h = 2.5 cm Area, A = 1.5 m2 Mass of wet filter cake filled in each tray...

Q: What happens if more than the maximum solvent rate is used?

A: The situation where more than the maximum solvent rate is to be used in extraction process is to be ...

Q: 28.21 A1 × 10-2 m spherical pellet is sprayed with a very thin coat of paint. The paint contains a v...

A:

Q: What is a stripping factor?

A: The definition of the stripping factor is to be mentioned.

Q: Chemical Engineering Question

A: Question b ):

Q: Why is an effective diffusivity that is obtained by experiment preferred for estimating the rate of ...

A: In food materials, the leaching is slow and the calculations must be done on rate basis.

Q: What is the difference between slurry adsorption (contact filtration) and fixed-bed adsorption (perc...

A: Slurry adsorption or contact filtration is a type of adsorption method in which solute or an impurit...

Q: A stream with a flow of 1.7 m3/s and BOD 3.4 mg/l is saturated with DO (9.27 mg/l at 20oC). It recei...

A:

Q: Draw the steam distillation apparatus and indicate the names of the each part of the apparatus

A: Steam distillation is a separation process used to separate organic compounds by using the thermal e...

Q: The reservoir core sample shown in Figure 1 has a permeability of 1 Darcy. What does this mean? Figu...

A: From the given figure the explanation of permeability of 1 Darcy is to be mentioned.

Q: Wet lumber of the type in Figure is slowly dried from an initial total moisture content of 50 wt% to...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: BaCO3, which is water insoluble, is to be made by precipitation from a solution containing 120,000 k...

A:  

Q: Maynilad supplies water that is fluoridated by adding NaF (FM = 41.988g/mol). The desired concentrat...

A: Given data:   Maynilad supplies water which is fluoridated by adding NaF. The desired concentration ...

Q: A process produces toluene at 1 atm and 30 °C that must be condensed to avoid releasing it to the at...

A:

Q: Consider a 2-ft * 2-ft thin square plate in a room at 75°F. One side of the plate is maintained at a...

A: Given data: Dimension of square plate = 2 ft × 2 ft Temperature of room = 75 0F The temperature at t...

Q: The angular position of a particle is given by the equation θ(t) = sin 3t + 3t2, Determine the angul...

A:

Q: Estimate the theoretical production of landfill gases (CH4, NH3 and CO2) from the degradation of 80 ...

A:

Q: For a car weighing 980 kg, how much work must be done to move the car 24 miles? Ignore factors such ...

A: The work that is required by the car to move a certain distance given in the question is to be deter...

Q: Consider the interphase mass-transfer process for the chlorine dioxide, ClO2–air–water system. ClO2 ...

A: Given information:   Interface mass transfer for ClO2 – air-water system   ClO2 gas is species A whi...

Q: What is the mass flowrate, in lbm/h, of1,100 SCFH of air?

A: The volumetric flow rate of air is given as V = 1100 SCFH   SCFH refers to Standard Cubic Feet per H...

Q: To determine the amount of magnetite, Fe3O4 (231.54 g/mol), in an impure ore, a 1.5419-g sample is d...

A: Given data: Magnetite in am impure ore sample is dissolved in concentrated HCl which reeults in a mi...

Q: Hot oil at 150°C is used to preheat a cold fluid at 30°C in a I:I shell and tube heat exchanger. The...

A: Counter-current 1:1 shell and tube heat exchanger.   The temperature of the inlet hot oil, TH1 = 150...

Q: The property of a fluid that quantifies fluid friction is   a. coefficient of friction.   ...

A: The property of a fluid that quantifies fluid friction is to be mentioned.

Q: List as many differences between (1) absorption and distillation and (2) stripping and distillation ...

A: The difference between absorption and distillation is to be mentioned. Also stripping and distillati...

Q: The air freshener shown in the figure below is used to deliver a pleasant vanilla fragrance in a roo...

A:

Q: A thin wira with L- 22.13 cm has a uniform linear charge density of X = 5.635 · 1c/m. This wire is c...

A:

Q: The fact that polymer’s physical properties depend on its atomic composition is very important in ma...

A: Physical properties of a polymer include its toughness, elasticity, viscoelasticity, and its tendenc...

Q: What is a trayed tower?

A: The definition of the trayed tower is to be mentioned.

Q: Does a solid have a vapor pressure?

A: The existence of vapor pressure for solid is to be mentioned.

Q: Calculate The solubility of Ba(IO3)2 in a solution prepared by mixing 200 mL of 0.0100 M Ba(NO3)2 wi...

A:

Q: Why is it easy to measure the amount of adsorption of a pure gas, but difficult to measure adsorptio...

A: The reason for adsorption is easily measurable in gases but not in liquids is to be mentioned.

Q: ) Calculate the thermal conductivity for Ne at 300K and 15 mbar pressure. The gas iscontained in cub...

A: Given data: Temperature = 300 K Pressure = 15 mbar The edge of a cubic vessel = 15 cm The temperatur...

Q: To what type of separation operations Kremser method is applicable?

A: The separations where the Kremser method of separation is used is to be stated.