Is the heat anticipator in series or parallel with the thermostatcontacts?

Q: in diameter. The bomb drains through a horizontal pipe 10 cm in diameter, located 3.20 m above the…

A:

Q: Magnitude of AL = 275 pounds Find: TAG= 0 = 5 0 Pounds A Jø B D = 450 pounds

A:

Q: Beam ABC is loaded by a uniform load q andpoint load P at joint C. Using the method of…

A: Given data as per question  L = 4 m, a = 2 m , q = 15 kN/m, P = 7.5 kN,E = 200 GPa,  I = 70.8 X106…

Q: 250N crate is pulled up a ramp that is angled at 20 degrees above the horizontal. If the coefficient…

A: Given:W=250 Nθ=20°μ=0.25

Q: Water at 10°C is flowing from point A to point B through the fabricated section shown below at the…

A: Given that: Volume flow rate = 0.37 m3/s Diameter at A = 300 mm = 0.3 m Diameter at B = 600 mm = 0.6…

Q: A household freezer operates in a room at 20°C. Heat must be transferred from the cold space at a…

A: Room temperature, TH=20oC=20+273=293 KCold space temperature, TL=-20oC=-20+273=253 KHeat transferred…

Q: 8. A spherical balloon is being filled at a rate of 3 cm³ per 4 second. The Volume of a sphere is…

A:

Q: Describe a direct-expansion versus a flooded evaporator.

A: Flooded Type Evaporator: Compared to a dry type, a flooded type evaporator transfers heat more…

Q: Fuel pump __ is a statement of the volume of the fuelflow from the pump.

A: Fuel pump is a device in the vehicle which is used to send the fuel from the tank to the engine…

Q: What could be the problem when the vehicle’s domelight dims when a power seat is moved?

A: Circuit and fuses are impacted. The vehicles have three different types of dome lights. a. Door dome…

Q: 43. What effect does Ackerman's principle have on steering operation? a. It allows for caster…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: Find FA and FB.

A:

Q: Establish the Shear & Moment Equation and Diagram of the loaded beam shown. Consider the Left Body…

A:

Q: 1.Locate the Processes of the given P-v indicator diagram and area under the process when computing…

A: Given questions: 1.Locate the Processes of the given P-v indicator diagram and area under the…

Q: A hydro-electric dam uses turbines to generate electricity as reservoir over the turbine blades. A…

A: GIVEN DATA- Fill in the blank and True and false question given we have to choose correct option

Q: To change from psig to psia, you must add _____ to psig.

A:

Q: The strain rosette shown was used to obtain normal strain data at a point on the free surface of a…

A:

Q: Which of the following is not part of the starter motorcircuit?a. Batteryb. Starting safety switchc.…

A: given; Which of the following is not part of the starter motor circuit?

Q: Find the Cross sectional area Stress=20 N/mm2 Force 5 N

A: Given data : Force F=5 N Stress σ=20 N/mm2   Required : Cross sectional area

Q: A 1-Spindle Threshold In Figure (2), calculate the reactions in datums A, F and E, 450 N +15+ 2.5m…

A:

Q: Which of the following is a good definition of SAI?a. Forward tilt of the top of the steering…

A: Given Data : SAI

Q: What is the kinetic energy of an 1800 kg car moving at 25 m/s?

A:

Q: As shown on the above figure, the component of F in terms of the unit vectors and scalar is Blank 1…

A: Given:MN=88FN=88SN=47

Q: A digital speedometer constantly reads 0 mph : TechnicianA says that the problem may be the…

A: Given Speedometer To find Which technician is correct

Q: The steel shaft DF consists of three concentric tubes and is supported by smooth bearings at D and…

A:

Q: Compute the Cross sectional area of Pipe Discahrge=0.8 m3/s Velocity=2 m/s

A:

Q: Mechanical Engineering At approximately what temperature (in Kelvin) would a specimen of an alloy…

A: Answer: The temperature at which a specimen of an alloy to be carburized for 1.3 hr: T = 1180.877 K

Q: Calculate the minimum wall thickness for a cylindrical vessel that is to carry a gas at a pressure…

A: Pressure of a gas, P=5.75 MN/m2=5.75*106 N/m2Diameter of vessel, D=400 mm=0.4 mMaximum stress in the…

Q: An Otto cycle engine operates with the cycle shown below. The air in the engine can be considered a…

A:

Q: The moment of force P about point A show in the figure is equal to............... P= 5N 2 O 10 O 0 5

A:

Q: Gear A has an angular acceleration of 2t3 rads/s², where t is in seconds. The gear is initially…

A:

Q: The cable AB prevents bar OA from rotating clockwise about the pivot O. If the cable tension is 760…

A:

Q: The number of equilibrium equations that are used to analyze the kinematics using the joint method…

A: The number of equilibrium equations that are used to analyse the kinematics using the joint method…

Q: Is truss stable m=12 R=4 J=8

A: Given data : Number of member m=12 Number of Joint J=8 Number of external support reaction R=4   To…

Q: a fluid undergoes the fallowing process  1. heated reveresible at a constant pressure of 1.05 bar…

A: Introduction: A thermodynamic cycle is made up of a sequence of thermodynamic events that occur in a…

Q: What is the best way to lift a vehicle when preparingto remove an engine?a. Frame contact hoistb.…

A: Given Vehicle is lifted to remove an engine To find Best process for lifting vehicle

Q: Question 1 E₁ = 70 GPa L₁ = 500 mm A₁ = 420 mm² (1) Rigid bar 380 mm B (2) 380 mm A₂ = 320 mm² L₂ =…

A:

Q: Consider wind blowing past a house with 10 windows of 1 m wide each as shown in the following…

A:

Q: Composite headlights are being discussed: TechnicianA says that they have replaceable bulbs.…

A: Given Composite headlights To find Correct technician

Q: A garage door is mounted  on an overhead rail (Fig. P11.81).  The wheels at A and B have rusted  so…

A:

Q: A venturi meter has air flowing through it. The diameter at the entrance is 2.5 in and at the throat…

A:

Q: ycle thermal ef

A: Givnen as,T=390°CP=9MPa

Q: 30 kN 60% 1.0 m Find the reactions in datums A and B for the threshold shown in Figure 3. 3.0 m 125…

A:

Q: Petrol of specific gravity 0.85 is to be pumped through a 1.2 km pipeline to a petrol  station. The…

A: Given: The specific gravity of fluid, γ = 0.85 The length of the pipe, L = 1.2 km = 1200 m The…

Q: A pitot tube is inserted into an air flow to measure the flow speed to measure flow speed. The Pitot…

A:

Q: 1. A toe adjustment of 1/8 inch outside of specifications will have little effect on tire life. a.…

A: Hii, thanks for the question but we are authorized to answer three parts at a time. Here you did not…

Q: Blocked suction cylinder unloading is accomplished byA. keeping the suction valve closed.B. closing…

A: given; Blocked suction cylinder unloading is accomplished by

Q: Find the Cross sectional area Stress=20 N/mm2 Force=5 N

A: Stress is defined as a resistance force offered by a loaded body against deformation.  Stress =…

Q: Compute the discharge through rectangular section having cross sectional area 10 m2 and flow…

A: Given data : Cross sectional area A=10 m2 Flow velocity V=2 m/s   Required : Discharge

Q: The equation of this best-fit line will have the familiar form y = mx + b, where m represents the…

A: given;   a. how will you calculate the value of the slope of this best-fit line? b. How will the…

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.