Input voltage is 120 v, solve the output current

Q: Find the value of i1. 12 and 13.

A:

Q: A 1-MHz carrier with an amplitude of 1 volt peak is modulated by a 1-kHz signal with m=0.5. Sketch…

A:

Q: Circuit Diagram R1 L1 50Q 10mH V1 220 Vrms C1 10uF ~60 Hz 0° Computed Values Compute the expected…

A: Capacitor: This is an energy storage device that store the energy in the form of the electric field.…

Q: Find v(t) in the circuit of Fig. 16.7. Assume v(0) = 5 V. 10Ω 10e *u(r) v (Ε) % (1) 0.1 F 28(1) A 10…

A:

Q: 1. Determine the values of Vs and Pvs. (if current through R₂ = 10 mA and R³ = 25 mA). Note: Use…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Apply KCL at node Vc(S) ve(s)-/+ vess+ 60)/2 = 1 vc(s)-¹% Vc(S) vc(s)-/s 5S 10 10 3 $5 S vc (S) 1₁ +…

A: All we need is manipulation  Just replace the terms, we will get desired terms at both terms.

Q: 2.3) The one side of a coaxial cable is connected to a signal generator. On the other side of the…

A: Given information, Coaxial cable output impedance is R1=46 Ω. Horn antenna resistance is R2=82 Ω. We…

Q: + P is Vo 0.8 pf lagging For the circuit shown above, what is the input power factor angle? Assume…

A: Power factor is measured in kilowatt. Power factor show the relation between the current and voltage…

Q: Two self-excited shunt generators operate in parallel to supply a total common load of 250 kw @ VT =…

A: In this question we need to find a armature current and induced emf of generator - 1 and generator-2

Q: For the system of Figure P5.16, find the values of K₁ and K₂ to yield a peak time of 1.5 second and…

A:

Q: 3.6 Use nodalalysis to obtain u, in the circuit of Fig. 3.5

A:

Q: can you convert the final answer to statcoulomb?

A:

Q: NOTE: YOU MUST USE THE STANDARD PHASE DIAGRAM TO A THREE-PHASE SYSTEM WITH LINE VOLTAGE OF 230 VAC…

A:

Q: The input to a 220 V DC shunt motor is 11 KW. Calculate, (I) the torque developed.  (II) The…

A: The current in the shunt winding is,  Ish=220110Ish=2 A The no-load current of the motor is known,…

Q: An FM signal has a deviation of 3 kHz and a modulating frequency of 1 kHz. Its total power is 5 W,…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Two shunt generators operate in parallel to supply a total common load of 250 kw @ 250 V. Each…

A:

Q: The phase angle of 12cos(5t - 30-) O 12°, lagging O 12°, leading 30°, lagging O 30°, leading

A: given that 12cos(5t-30) convert it into polar form 12<-30°

Q: A 1-MHz carrier with an amplitude of 1 volt peak is modulated by a 1-kHz signal with m=0.5. Sketch…

A:

Q: Two metallic plates separated by 6.9 cm. If a plastic material is inserted between the plates of the…

A: given two metallic plates are separated by 6.9 cm. after inserting the plastic material capacitance…

Q: A differential amplifier has a common-mode gain of 0.2 and a common-mode rejection ratio of 3250.…

A: Given, Common mode gain Ac = 0.2, Common Mode Rejection Ratio = 3250 Input Voltage Vi = 7 mVrms, To…

Q: 1. The independent current source generates 0 current for t 0. + • 100 mH a. Sketch the current…

A: NOTE: as per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly re-post…

Q: An averaging amplifier has five inputs with RF = 30 kohms, what should be the value of each input…

A:

Q: Given the current rating of each winding is increased, can the open-delta configuration work as well…

A: The utility simply needs to install two transformers for open-delta. The capacity of the system may…

Q: R1 L1 ww 50Q 10mH V1 C1 220 Vrms 10uF 60 Hz 0° Computed Values Compute the expected power factor of…

A:

Q: 4.41 Find the Thevenin and Norton equivalents at term nals a-b of the circuit shown in Fig. 4.108.…

A: In this question,  We need to determine the Thevenin equivalent and norton equivalent circuit across…

Q: Find the power supplied and average power absorbed or supplied by each element. Identify if the…

A: Power is delivered by current or voltage source and power is absorbed by resistance  power =…

Q: A half wave rectifier, operated from a 50Hz supply uses a 1000μF capacitance connected in parallel…

A: We need to find out the resistance for given ripple

Q: The transfer function is, s(s² +5+2) G(s)H(s) = 5² +35³ +5² +55 +10 Calculate the angle of departure…

A: Angle of departure in the control system is explained by a formula. θdeparture=180°+sum(Angle to…

Q: Q.2 Consider system described by A B N-G 30+A- Hu 3 C y = [10] [x₂] G(s) Obtain the transfer…

A: Brief description: For the above given state space analysis we need to calculate transfer function…

Q: 1. Determine the impedance of the circuit of Figure 4.1 at frequencies of 100 Hz, 10 kHz and 1 MHz.…

A:

Q: 1) Given the circuit, find v, ii and i2. 6 Ω 3 Ω Μ 12V Π Ο ΡΑ Μ ΤΩ 9 A iz 8 Ω

A: In the above given question they have mentioned an electrical circuit which consists of independent…

Q: investigate how offset and performance varies as you change the scalar controller gain ??. Give some…

A: Offset and performance varies as we change the scalar controller gain Kp . The maximum offset is…

Q: Use Simulink, you can set the symbol rate as 1 kHz. a) Plot the spectrums of the BFSK, 4FSK, 8FSK,…

A: To Plot the spectrums of the BFSK, 4FSK, 8FSK, 16FSK system

Q: A 220 V self-excited shunt motor has armature and field resistances of 0.2 Ω and 220 Ω respectively.…

A: In this question we need to find a new speed in rpm (rev/min) if an external armature resistance of…

Q: Q6.) Identify whether the following statement are true(T) or false (F) 1- Persistence is the…

A: Here we check about whether the given statement is correct or not.   NOTE :- As per our company…

Q: Question 21 Solve for the sinusoidal voltage and currents, v(t) and i(t), on the given circuit. v(t)…

A:

Q: R₁ a =₁₂₁ >1 13 b с R₂ ww 125 R3 d =E₂

A:

Q: For the circuit given, obtain vi and v2. 2 Ω για 10 Ω 3A www www 5Ω 64 4Ω A) v = 0 V, va = -12 V = 0…

A: Nodal Analysis- The mathematical method for calculating the distribution of voltage between the…

Q: 6. Determine the impedance of the circuit of Figure 4.6. 82 -j 25 100 -j 50 j 180 Figure 4.6

A:

Q: An AC bridge is supplied with a source of 10 kHz as shown in figure 1. If Z, is a paralle…

A: An AC bridge circuit is used for measuring quantities like resistance, inductance, capacitance in a…

Q: 4) Use Mesh Analysis and KCL to find i₁, 12, and is in the circuit. 12 3 Ω 7Ω Vo 9 V www 2Ω 2 A نها…

A:

Q: Determine the total response of the DT LTI system described by the following: y[n] – y[n – 2] =…

A: given here a discrete time LTI system and asked to find the total response.

Q: in a series Ri. circuit voltage across the resistor is 100 V and the voltage across inductor is 50…

A: Given data, In a series RL circuit VR=100 VVL=50 V

Q: Q3/A/ A3-phase, 5.5kW, 440V, 501 Iz, cylindrical rotor S.M has synchronous reactance of (0+j2)…

A: Given data : Output power  Pout=5.5 kW=5500W Synchronous reactance,Xs=j2Ω/ph Full-load…

Q: (c.) Determine the core loss when the transformer is connected to a 4700 (primary) volt 60 cycle…

A: Given: A 60 kVA 4800/460 volt, 60 cycles, distribution transformer has the following resistance and…

Q: Match he following phases of power supply in terms of the components being assembled Coupling of…

A: We need to match the given statement .

Q: 53 1.9.3 Obtain the state-space model of the single-input- single-output network system of Figure…

A: State space model: It is a mathematical model for representing the physical system. The physical…

Q: Calculate the transistor currents and Vce-Let Vbe(on) =0.6V and B=100 and vcc= 12v

A:

Q: A balanced delta-connected load with impedance per phase of 30/30° 2 is connected to an abc-sequence…

A: According to given question ,Given :

Q: Μ 3 R4 1ΜΩ V1 4 18V R2 2ΚΩ Q1 F 2 1 R3 Ο 0.51kΩ

A:

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.