In what situation would the LTP be complemented by a pile cap?

Q: A solid 45 mm diameter beryllium copper (E = 131 GPa; α = 17.0 × 10−6 /°C) rod is stress free when…

A:

Q: 400 N 40 35 300 N 25 20

A:

Q: The circular shaft of constant cross - section carries three pulleys and belts which are vertical .…

A:

Q: Find the depreciation for the 1ª year using

A: This question has been taken from estimation, costing and evaluation.

Q: The vekaty of a particle traveling along a straight line is (3- ) It s, where is in seconds. If s4…

A:

Q: is there any FBD for this?

A: As expert has already solved this question and Student has asked to  draw a Free body diagram for…

Q: Problem I. For the beam shown, a) Compute for the reaction at all supports b) Draw the shear and…

A:

Q: 35KN 10KN/m 30KN.m 5kN/m 1.5m 1.5m 2.5 3.5 Cs Scanned with CamScanner 2. 3.

A: SFD:  Point load : rectangle  Udl : triangle  Uvl : 2 degree parabola    bMD:  Point load ; triangle…

Q: H.W Find the distance between Pins of type O and@ and the numbers of these Pins that Can be used in…

A:

Q: Problem 2 G. 0.75 m6 Given: t0.4 m Mass of car: 1400 kg D B H m- 1.5 m- Mass of trailer: 800 kg -2…

A: Given data: Mass of car = 1400kg Mass of trailer = 800kg

Q: 1.12 The frame shown consists of four wooden members, ABC, DEF, BE, and CF. Knowing that each member…

A:

Q: Research the manifesto/ethos of two current design practices and present your findings including a…

A: SACI INGENIERIE is a Consulting Engineering Agency founded in 2019 by Abdellah Saci, engineer with…

Q: Give two environmental considerations needed for material production and elaborate.

A: Environmental considerations needed for material production are very important nowadays. Because the…

Q: 5. In preliminary design studies for a sun- powered car, it is estimated that the mass of the car…

A:

Q: ffee is draiming frod a conical filter Into a eyli o ffee pot at the rate of l0 m3/B46. How is the…

A:

Q: 1. Draw the shear-force and bending-moment diagrams for the simply supported beam shown. Determine…

A:

Q: The water tank in the figure below is being filled thru section 1 at v1 = 7 m/s and thru section 3…

A: Velocity of water through tank 1, v1=7msDischarge through pipe 3, Q3=0.012m3sThe velocity of water…

Q: A closed tank with equilateral triangle base and with a capacity of 300 m^3, is to be constructed.…

A:

Q: A 25 kN point load acts on the surface of an infinite elastic medium. The vertical pressure…

A:

Q: e conveyor belt delivers crate each of mass M to the locity is vA, directed down along the ramp. If…

A:

Q: HURREVAC is the model run by NHC to estimate storm surge potential. True False

A: True Hurrevac is storm tracking tool used by NHC to estimate storm surge potential.

Q: The centerline of two parallel tracks are connected by a reversed curve. The angle of intersection…

A: Angle of intersection of first curve = 15° Distance between the parallel tracks = 30m Radius of…

Q: 7. The 450-kg ram of a pile driver falls 1.4 m from rest and strikes the top of a 240-kg pile…

A:

Q: 1. A rectangular reinforced concrete beam has the follawing properties: Beam Span, L 6 m Beam width,…

A:

Q: A surveving transcript of a closed traverse is defined by the vertices ABCDEFGHIJKL. Enor Ace is…

A: Given -

Q: A truck load with three axle loads of 40 kN, 40 kN and 40 kN (separated by 2m between each…

A: Figure is as shown

Q: a. The in-situ effective vertical stress in the middle of the clay layer is psf. b. If a uniform…

A: The values and diagram given in the question are as follows: Initial groundwater depth=5 ft (below…

Q: Fluid flows past the two dimensional bar shown in figure. The pressures on the ends of the bar are…

A: Figure is as shown

Q: lo05/ A timber beam bomm by 250mms rein forced at the botton only by a steel Plate, es Skonn infig-…

A: From the Given Data:

Q: A viscous liquid (p = 1.2x103kg/m³, µ = 0.0048 Pa.s) flows at a rate of 10ml/s through a horizontal,…

A:

Q: 2-14: A soil has a void ratio of 0.70, degree of saturation 50% and G =2.7. Find the water content,…

A:

Q: vil Engineering THREE MOMENT EQUATION Analvze the given beam using the method of Three-Moment…

A:

Q: The total water supply of the world is about 326 million cubic miles. Express this supply in:…

A:

Q: Part A The box girder is subjected to a shear of V = 16.6 kN. (Eigure 1) Determine the shear flow at…

A: Given:- The magnitude of the shear force on the box girder = V = 16.6 kN To determine:- a) The shear…

Q: 3. The 180 lb man climbs up the ladder and stops at the position shown after he senses that the…

A: Free body diagram of given question

Q: 18 21 32 F mm mm mm E A В D G F

A:

Q: A rectangular beam is to carrt a factored moment of 272 kN-m with a width of 250 mm and its…

A:

Q: A porous layer between channel 1 and channel 2 has a coefficient of permeability of 10-3 m/s and is…

A: Answer: We are given Water elevation head at channel 1 is H1 = 6.1 m Water elevation head at channel…

Q: Use the manning's equation above to find the streamflow rate (Q) under the following conditions: a.…

A: From Manning's Equation  Q=knAR23S12 K= 1 m/s For Earth winding and vegetation  n= 0.030 Top width…

Q: Three full-size 50 x 100-mm boards are nailed together to form a beam that is subjected to a…

A:

Q: 6. The 5-kg spring-loaded gun rests on the smooth surface. It fires a ball having a mass of 1 kg…

A:

Q: Water flows through at a velocity of 9.64 m/s. What is the velocity head in meters? Round off…

A:

Q: Question 7: Which equation represents the horizontal y-direction component of the linear momentum?…

A: 6) X - component of linear momentum (In section 1 only x-direction) Rx=P1A1+V1ρQ1=P1πD124+V1ρQ1 7) Y…

Q: The area of a lake is 52.2 cm2 on a 1:7500 vertical photograph. Find the ground area of the lake in…

A: step 1-

Q: A 25 kN point load acts on the surface of an infinite elastic medium. The vertical pressure…

A: Point load acting = 25kN It has been asked in the question to determine the vertical pressure…

Q: 12. Find the depth of compression block. а. 112.86 mm c. 111.89 mm b. 122.87 mm d. 143.56 mm 13.…

A: Width of beam(b)=350 mm Depth of beam(D)=475 mm Compression steel=4-20 mmϕ Tension steel=4-25 mmϕ…

Q: t planning process

A: Highway engineering is a civil engineering subject that entails the planning, design, building,…

Q: Fluid flows past the two dimensional bar shown in figure. The pressures on the ends of the bar are…

A: Figure is as shown

Q: 30KN 10KN/m 40KN.m 5KN/m Int Hngn B 2.5 3.5 CS eanned with Candovver

A:

Q: A ball of mass 1 kg moving with a velocity of 2 m/sec collides a stationary ball of mass 2 kg and…

A:

Pricing Excavation and Backfill

Backfill, in construction, is the activity of returning the soil and gravel that are removed during building construction or using them again to toughen and support the foundation of the building or any other structural component.