In the figure, horizontal scaffold 2, with uniform mass m₂ = 34 kg and length L₂-2.2 m, hangs from horizontal scaffold 1, with uniformmass m₁-45 kg. A 18 kg box of nails lies on scaffold 2, centered at distance d-0.50 m from the left end.What is the tension T in the cable indicated?Number iUnits2T=7

Horizontal scaffold 2, has mass m2=34 kg and length L2=2.2 m Horizontal scaffold 1, has mass m1=45…

In the figure, horizontal scaffold 2, with uniform mass m₂- 34 kg and length L₂-2.2 m, hangs from horizontal scaffold 1, with uniform mass m,- 45 kg. A 18 kg box of nails lies on scaffold 2, centered at distance d-0.50 m from the left end. What is the tension T in the cable indicated? Number Units 2 T=>

In the figure, horizontal scaffold 2, with uniform mass m₂- 34 kg and length L₂-2.2 m, hangs from horizontal scaffold 1, with uniform mass m,- 45 kg. A 18 kg box of nails lies on scaffold 2, centered at distance d-0.50 m from the left end. What is the tension T in the cable indicated? Number Units 2 T=>

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Similar questions

The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91
Find the tension T in the cable and the magnitude and direction of the force exerted on the strut by the pivot in the figure. Let w be the weight of the suspended crate full of priceless art objects. The strut is uniform and also has weight w. 30.0° 45.0° Fy Т. 45° Tcos 30° 30° W 15% FH 45° Tsin 30° W
A 200 N sign hangs from the middle of a cable between two buildings. The ends of each cable are attached to each building at the same height. The cable cannot exceed 1500 N without breaking. Find the minimum angle that the cable can make from the horizontal.
atics 0.4 m. B 15 m L0.4 m 0.8 m 1.5 m 15m Three vertical wires are used to support a rectangular plate which weighs 500 N. Determine the tension in the wires.
An 88 kg person stands on a uniform ladder 4.0 m long, that weighs 100 N, as shown in the figure(Figure 1). The floor is rough; hence, it exerts both a normal force, f1, and a frictional force, f2, on the ladder. The wall, on the other hand, is frictionless; it exerts only a normal force, f3. Figure f₁ mg f3 a-3.8 m 1 of 1 Part A Using the dimensions given in the figure, find the forces exerted on the ladder when the person is halfway up the ladder. Express your answers using two significant figures separated by commas. fi, f2, f3 962.4,157.17,157.17 Submit ΓΨΠ ΑΣΦ Part B Previous Answers Request Answer X Incorrect; Try Again; 9 attempts remaining f1, f2, f3 = w Find the forces exerted on the ladder when the person is three-fourths of the way up the ladder. Express your answers using two significant figures separated by commas. VE ΑΣΦ kN ≈ ? kN
The box B weighs 50 lb. The coefficients of friction between the cable and the fixed round supports are μs= 0.40 and μk= 0.30. What is the minimum force F required to support the box? What force F is required to move the box upward at a constant rate?
A 4 kg watermelon is placed at one end of a 3.5 m, 271 N scaffolding supported by two cables. One supporting cable is at the opposite end of the scaffolding, and the other is 0.65 m from the watermelon. a) How much tension is in the cable at the end of the scaffolding? The acceleration of gravity is 9.8 m/s 2 . Answer in units of N. b) How much tension is in the cable closest to the watermelon?
F, y mg AF f.y F, fx e Axis The ladder in the picture has a mass of 39 kilograms and a length 3 meters. What is the normal force pushing the ladder up from the floor? This force is labeled Ff y in the picture. FN N. %D Assume that the ladder's weight is evenly distributed, so it can be treated as a single force through the middle. If the ladder is at a 69° angle from the ground, what is the torque exerted by the weight (using the floor as the pivot point)? N.m The torque from the ladder must be balanced by the torque caused by the normal force on the wall, labeled Fw in the picture. Calculate this force. Fw - N. The normal force from the wall must be balanced by the friction force from the floor, labeled Ff x.in the picture. Determine the minimum coefficient of friction to keep the
Problem # 4: A uniform 30.0-kg scaffold of length 5.0 m is supported by two light cables, as shown below. A 75.0-kg painter stands 1.2 m from the left end of the scaffold, and his painting equipment is 2.0 m from the right end. a. If the tension in the left cable is twice that in the right cable, find the tensions in the cables and the mass of the equipment.
A 10.9 m, 265 N uniformly constructed ladder rests against a frictionless wall, making an angle of 58.3 degrees with the horizontal. A 593 N man climbs 8.8 m up the ladder. If the ladder is just on the verge of slipping. what is the coefficient of static friction between the ladder and the ground? H₂ =
A sign is held by the following beam and cable. The sign has a mass of 11 kg. The beam has a length of 1.11 m and a total mass of 1.1 kg. What is the tension in the cable, if theta; = 60 degrees? Express the tension in Newtons. Ꮎ L Sign
The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB is 8.2 kN. Determine the required tension Tin cable AC such that the net effect of the two cables is a downward force at point A. Determine the magnitude R of this downward force. Assume a -41 m, b - 52 m, c-22 m, and d - 29 m. L B Answers: T- i KN R- i KN XXXI