In the concentration of fruit juices, a portion of the feed is redirected to bypass the evaporator and then mixed with the concentrated product to reintroduce flavor compounds that would have been lost by evaporation. The feed (433 kg/h) contains 13.27% solids, and the desired final product should have 35.72% solids. The outlet to the evaporator contains 61.75% solids. What is the flow rate of the evaporator outlet?-

Q: non ideal mixture of acetone(1) and chloroform(2)

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which…

Q: Predict the value of DAB for the system CO-CO₂ at 296.1K and 1.0 atm total pressure.

A:

Q: 4. Let us consider a process flow diagram describing the water conditioning setup for a salt- water…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: What are the independent equations used and the volume of the second

A:

Q: W 4540 W/m²K. The fuel material has k= 33.9 W/m K. For the situation described, evaluate the…

A:

Q: gauge pressure readings

A:

Q: A cylindrical pressure vessel of radius r = 10.2 in is filled with a gas at a pressure of 455.0 psi…

A: As given  Maximum force on bolt that can withstand = 32505lbf Net force exerted on each bolt holding…

Q: I am trying to decide thesis topic for chemical engineering. Any suggestions? Thanks.

A: There are many thesis topic for Chemical Engineering. As we know that Chemical Engineer are always…

Q: The decanted sludge of 20,000 kg/h contains 5 weight % water, 10 weight % zinc sulfate and the…

A: INTRODUCTION - Target compounds in a solid raw material are leached by solvents in a process known…

Q: CAi, Ti Fe, Tai- 8 .FC₂ Tco >CA, T The exothermic AB reaction occurs in the CSTR. The reactor is…

A: An exothermic reaction is carried out in a jacketed CSTR.

Q: saturated steam is needed in kg per min to heat up

A:

Q: Chemical compounds composed of carbon and hydrogen atoms bonded to one of the inorganic atoms are…

A: ASKED Chemical compounds composed of carbon and hydrogen atoms bonded to one of the inorganic atoms…

Q: whats the condition make this equation is True! (du/ dv )= = ( du/dp) + = (dH/dv)) = 19 Adole gu…

A:

Q: Steam enters an adiabatic turbine at 1.2 MPa and 451 °C and leaves at 129 °C with a quality of 44…

A: Given  Adiabatic turbine with Intel pressure P = 1.2MPa Intel temperature of turbine T = 451 oC At…

Q: A mixture of 2.00 g of H2 and 14 g of O2 is placed in a 1.8 L flask at 35.5°C. Assuming each gas…

A: Given data: Mass of H2 = 2 g Mass of O2 = 14 g Volume of flask = 1.8 L Temperature = 35.5 0C

Q: as The Reynolds number is a dimensionless group defined for a fluid flowing in a pipe Re = Dup/μ

A: Giventhe relevant data for liquid MEK to find the Reynols numberTo findwhether the flow of MEK  is…

Q: A liquid film of constant thickness L flows down an inclined wall that makes an angle with the…

A: Given, The liquid film has thickness= L Make necessary assumptions and then do the shell momentum…

Q: Can you please show the complete solution for these

A: The atmospheric pressure is considered to be entering from the right side pipe. The pressure can be…

Q: 1. What height of milk would give a gauge pressure of 40.0 kPa? In meters! 2.

A:

Q: Provide basis, find, Process flow diagram and show step-by-step solution for the process. Topic:…

A: Sodium hydroxide is produced by the electrolysis of an aqueous solution of NaCl.

Q: feed rate required for 40% conversion of A to the reactor

A:

Q: A stream of water from a fire hose with a flow rate of 320 gallons per minute and a speed of 35 m/s…

A:

Q: A BALANCE FROM STOICHIOMETRY Consider a feed CAO = 100, Cao = 200, C= 100 to a steady-flow reactor.…

A:

Q: We desire to produce two ethyl alcohol-water mixtures each containing 90% and 50% alcohol by mole…

A:

Q: Assuming the validity of Raoult's law, do the calculations for the acetone(1)/tert-butanol (2)…

A:

Q: please solve part c

A: Bulk density is totally different from absolute density. Bulk density is more inclined to solid…

Q: 1) 2.035 g H₂ produces a pressure of 1.015 atm in a 5.00 L container at -211.76 °C. What will the…

A:

Q: For the circuit below : RL =) Determine the range of R₂ and I that will result in VR being…

A:

Q: Number of carbon atoms per molecule in Fuel oil is

A:

Q: a. 1. For the reaction: C(s) + CO2(g) →2CO(g) .Drive the relationship between Kp and Kc. b.…

A: Since we only answer up to 3 sub-parts, we'll answer the first 3. Please resubmit the question and…

Q: QH The following data represents -a Poly merization of styrene (3.34 mol/L $) after afix benzene at…

A: The initial speed of polymerization is calculated from the concentration of styrene, the…

Q: Benzene is to be absorbed from coal gas by means of a wash-oil. The inlet gas contains 3 per cent by…

A: Benzene is absorbed from coal gas by wash-oil solvent. Given data are as follows: Volume percent of…

Q: 4. The turbines in a hydroelectric plant are fed by water falling from a 150 ft height. Assuming 15%…

A: For a detailed solution, please see the attached files.

Q: Txy diagram for acetone/ethanol system at 1.01 bar: T (°C) 80 75 70 65 60 55 0.0 0.1 Txy Plot for…

A: As given  Mole of feed F = 75  Composition of ethanol = 40%  Composition of acetone = 60% Mole…

Q: Help me think thesis topic for chemical engineering that is related to extraction of fruit. 3 topic…

A:

Q: 7.6. A gas enters a converging nozzle at pressure P₁ with negligible velocity, expands…

A: A conduit that is most suitable for the isentropic flow can be termed the nozzle. There are two main…

Q: A fuel gas mixture of 10500 lbmol/hr 35 mol% ethane, 25 mol% propane, and the balance butane is fed…

A: Given, The molar feed rate of fuel, n = 10500 lbmol/hr The mole % of the components in the feed are…

Q: B:- Calculate Dp, Mw, My, for polystyrene, if a-1, Then Show practical method to determine molecular…

A:

Q: An open test tube at 293K is filled at the bottom with 12.1 cm of Hg and 5.6 cm of water is placed…

A: Given height of Hg (h1) = 12.1 cm Height of water in tube (h2  )  = 5.6 cm  Density of Hg (dhg)  =…

Q: The incinerator system shown in Figure P2.4 can be equipped with a catalyst bed and the same degree…

A: Given data are as follows: The catalyst and installation cost = $250,000 Service life = 3 years,…

Q: Oxygen is contained in a cylinder at a pressure of 95 bar and a temperature of 185.52 K. Estimate…

A:

Q: Consider the complex manometer of the figure below Water, SG-1.0 Mercury, SG-13.56 e for PB-PA 55 cm…

A: Introduction  Manometer A manometer is a pressure-measuring tool. A glass tube in the shape of a U…

Q: A homeowner uses 4795 m³ of natural gas in a year to heat a home. Assume that natural gas is all…

A: Given that, Volume of natural gas V = 4795 m3 Pressure P = 1 atm Temperature T = 15oC = 15 + 273.15…

Q: What is specific objective for Sewage Water Treatment to produce electricity

A:

Q: Raw sulfur containing 83% pure S is burned together with 30% excess air (S to SO2). An analysis of…

A: Purity of aw sulfur = 83 % % excess air = 30 % Temperature of air = 30 0C Pressure = 750 mmHg

Q: 5. A quantity of 1.435 g of naphthalene (C₁0H³), a pungent-smelling substance used in moth…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: Consider the equilibrium reaction H2O H2 + 0.5 O2, at 1 atm and 298K. The mass fractions of H2O. H2…

A:

Q: A second-order. irreversible reaction with rate constant k = 1.8 L mol- 1 s-1 takes place in a…

A: Here in this system, flux to the surface will equal the reaction rate. The reaction rate must be at…

Q: Final purification stage in the preparation of a pharmaceutical product A from natural sources…

A: Given that,  The mass flow rate of feed F = 100 kg/h The composition of feed = 0.2 kg of A/kg of…

Q: Consider a 1000 mL chemostat (continuous reactor) operating with cellular recycling. The bioreactor…

A: Volume of chemostat = 1000 mL Volumetric flow rate = 100 mL/h µmax = 0.2 h-1 kS = 1 g/L…