In the circuit in the figure below, determine the following. 40.0 V 360 V - 80.0 V 200 N 80.0 Ω Σ 20.0 Ω Σ 70.0 ΩΣ (a) the current in each resistor (Indicate the direction of the current flow through each resistor through the sign of your answer. Take upward current flow as positive.) Resistor (2) Current (A) 200 80.0 20.0 70.0 (b) the potential difference across the 70 2 resistor

In the circuit in the figure below, determine the following. 40.0 V 360 V - 80.0 V 200 N 80.0 Ω Σ 20.0 Ω Σ 70.0 ΩΣ (a) the current in each resistor (Indicate the direction of the current flow through each resistor through the sign of your answer. Take upward current flow as positive.) Resistor (2) Current (A) 200 80.0 20.0 70.0 (b) the potential difference across the 70 2 resistor

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a switch. The switch is placed in position A at time t = 0 and switched to position B at time t = 743 ms. Find the voltage across each of the resistors at time t = 1.17 seconds. Owo DO A R R in in ete SW éte لفظو
What is the difference between the cut-off voltage VGS0 f and the narrowing voltage Vp? Explain this with the diagram
a) Voltage at Node "A" in V is b) Current flowing through R5 in mA is c) Current flowing through R6 in mA is d) Current flowing through R7 in mA is e) Power dissipated by R8 in micro W is
Which of the following statements regarding circuits are true? To find resistance in a parallel circuit, you must sum the individual resitances The direction of conventional current is the direction of positive charge flow. In a circuit, electrons flow from high potential energy (at the negative terminal) to low potential energy (at the positive terminal). When electricity is passed through a lightbulb, the electrons are 'used up' by the bulb. All voltages in a loop sum to 12V The current that flows into a resistor is the same as the current that flows out. To 'short circuit' something means there is an alternate path of less resistance for the current to flow. Switching on a light happens immediately because electrons move from the power source to the bulb incredibly quickly. A 'kilowatt-hour' is a unit of power, not energy.
What is the V0 voltage ?
You have to solve this schematic electric circuit diagram
How do I find the total Ohm's of this in steps? been on it forever now.
The diagram in the figure shows a simple circuit consisting of a battery and a load consisting of two resistors.The battery voltage is UB = 56 V and the value of the resistors is:R1 = 1800R2 = 5400a) The ammeters in the circuit show the following value:A1 shows valueA2 shows valueA3 shows valueb) In the load, the effect developsc) The total resistance of the load is
Determine the total resistance, Rī, and current, I, for the circuit in Figure Q1(b). 30V- RT 50Ω 2002 4092 7092 m Figure Q1(b) 3002 m 6092 [Answer: 22.430, 1.34A]
Three resistors of 5, 10, and 15 ohms respectively are connected in series with a 24V source voltage. What is the current in the 5-ohms resistance? a.0.2 A b. 08 Ac. 0.6 A d. 0.5 A
The conductance of a 9230 resistance is a) 1.08 * 10-3 mho b) 1.08 * 10-4 mho c) 1.02 * 10-3 mho d) 1.02 * 104 mho
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10