I want answer in 15 minutes if you provide i will give like else dislike (ii): In residential house, the following are the loads connected;(1) 55W fluorescent tubes - 4 Nos., switched on for 4 hours in a day60W incandescent lamps-2 Nos., switched on for 2 hours in a day,70W ceiling fan - 3 Nos., switched on for 12 hours a day(iv) 225W refrigerator, switched on for 10 hours a day,(iii)(v) 200W washing machine, switched on for 1 hours a day,(vi) 150W T.V. switched on for 6 hours a day,If the cost of electricity is Rs. 4/unit, what will be the monthly charges ?2015

We have an load connection of residential house as given in the question We have to determine the…

: In residential house, the following are the loads connected; 55W fluorescent tubes - 4 Nos., switched on for 4 hours in a day 60W incandescent lamps-2 Nos., switched on for 2 hours in a day, (iii) 70W ceiling fan - 3 Nos., switched on for 12 hours a day (iv) 225W refrigerator, switched on for 10 hours a day, (v) 200W washing machine, switched on for 1 hours a day, (vi) 150W T.V. switched on for 6 hours a day, If the cost of electricity is Rs. 4/unit, what will be the monthly charges ? (1)

: In residential house, the following are the loads connected; 55W fluorescent tubes - 4 Nos., switched on for 4 hours in a day 60W incandescent lamps-2 Nos., switched on for 2 hours in a day, (iii) 70W ceiling fan - 3 Nos., switched on for 12 hours a day (iv) 225W refrigerator, switched on for 10 hours a day, (v) 200W washing machine, switched on for 1 hours a day, (vi) 150W T.V. switched on for 6 hours a day, If the cost of electricity is Rs. 4/unit, what will be the monthly charges ? (1)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter8: Combination Circuits

Section: Chapter Questions

Problem 4PA: The hot water for the heating system for a small factory is supplied by a single boiler. The bolier...

See similar textbooks

Similar questions

c) Based on the Figure 1 (c), a 240V circuit supplies power to an electrical appliance. Based on the figure, briefly interpret the scenarios if: i. Fault is detected on hot/live wire ii. Ground wire disconnected Fault breaker Hot wire Service panel The resistor symbol represents all the internal components of an appliance like a washing machine. Neutral Neutral to supply transformer Ground wire Figure 1 (c)
SITUATIONAL SETTING: Setting the voltage amount to 50 and the number of winds/turns to 20. Afterwards, increase the wind/turns to 50. Explain what happened and what the difference occurred.
Load in Figure 1 needs to be connected to Mains Switch Board (MSB) using multicore PVC cable. As a maintenance engineer, you need to proposed cable size for the load, Determine the following issues. 1) Calculate current demand for the circuit. 1) Detemine suitable MCCB (Model and nominal current rating) should be used to protect the load against over-current. im Propose suitable cable size for the load in Figure 1. iv) Calculate voltage drop of the proposed cable WITHOUT consider the cable reactance and voltage drop correction due to higher cable operating temperature v) Calculate voltage drop of the proposed cable BY consider the cable reactance and voltage drop correction due to higher cable operatıng temperature vi) If the multicore PVC eable is change into 3 single core PVC cables, what the suitable cable size. All other multicore cables not available. (25 + variable x) m (A) 30 m (B) (15 + variable b) m (C) Multicore PVC cable MCCB 95 kW. (400 + variable y) V. 0.85 p.f. Load MSB…
explain outdoor substation
Figure 6 shows a DC resistive circuit.(a) When the switch SW is opened, calculate the current IS. (b) When the switch SW is closed, calculate the current IS and the voltage Va.
2. A facility manager replaces all the TS lights in an office when they have reached 80% of their rated life of 20,000 hours. The lights operate for 12 hours each day, 5 days per week for 52 weeks of the year. What is the group re-lamping interval for these lights? a. 3.7 years b. 4.6 years c. 5.1 years d. 6.4 years
c) Based on the Figure 1 (c), a 240V circuit supplies power to an electrical appliance. Based on the figure, briefly interpret the scenarios if: 1. Fault is detected on hot/live wire 11. Ground wire disconnected Fault breaker Hot wire Service panel The resistor symbol Neutral represents all the internal components of an appliance like a washing machine. Neutral to supply Ground transformer wire D Focus ions: On
TRUE or FALSE: During open-circuit test, the current in the high-voltage winding is equal to zero.
Electric Powers System for Nonelectrical Professional Can you Identify and describe the operations of all major equipment used in substations
Question: How do the secondary voltage and current react to the different types of load and how do they behave within the secondary load circuits? Answer:
How would you describ the flow of Alternating Circuit (AC) and Direct Current?
b) The general function of the circuit breaker (CB) is to close and open the circuit to be able to remove faults and connect/disconnect objects and parts of electricity network. Describe the failures of circuit breaker and purpose of circuit breaker testing at the substations. c) Figure 3 (c) shows the overview of the high voltage components in the power network. Based on the power network, the 33/11kV power transformer tripped due to high winding temperature above 120 °C. The maintenance personnel are planning to carry out the electrical testing on tripped transformer before proceeding with further remedial action. Using your own words, describe THREE (3) types of electrical testing need to be carried out with technical explanation to verify the condition of tripped transfomer in the power network. Disconnecto Protective elays HV cit Breer Crert aome Caret banslormers HV oirtut breaar Aulary Votage vansformer Daconnector power Figure 3 (c) 卡月