In a U-shape pipe, water steadily flows into section 1 and discharges at section 2 and 3. The pipe diameters at sections 1, 2 and 3 are 5 cm, 10 cm and 3 cm, respectively. The pressures (gauge) at sections 1 and 2 are 100 kPa and 50 kPa, while section 3 is open to the atmosphere. Determine the forces to hold the pipe in place. Neglect the weight of pipe and water therein.

In a U-shape pipe, water steadily flows into section 1 and discharges at section 2 and 3. The pipe diameters at sections 1, 2 and 3 are 5 cm, 10 cm and 3 cm, respectively. The pressures (gauge) at sections 1 and 2 are 100 kPa and 50 kPa, while section 3 is open to the atmosphere. Determine the forces to hold the pipe in place. Neglect the weight of pipe and water therein.

Name: In a U-shape pipe, water steadily flows into section 1 and discharges
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: In a U-shape pipe, water steadily flows into section 1 and discharges at section 2 and 3. The pipediameters at sections 1, 2 and 3 are 5 cm, 10 cm and 3 cm, respectively. The pressures (gauge) atsections 1 and 2 are 100 kPa and 50 kPa, while section

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q1/Air at 110 kPa and 50°C flows upward .The pressure change across the reducer is measured by a water manometer. The elevation difference between the two points on the pipe where the two arms of the manometer are attached is 0.2 m. Determine the differential height between the fluid levels of the two arms of the manometer Dia=4cm Dia=6cm Air
(1) The inlet velocity Vi is known. Neglect friction losses and determine the manometer reading h in terms of Vi ( the velocity at position 1), H, L , D, d, and the densities of water and mercury. The left hand branch of the manometer is exposed to the atmosphere as is the nozzle exit (position 2). d 2 L PH:0 D Water H PHg Mercury
An airplane is flying at standard sea level. The measurement obtained from a Pitot tube mounted on the wing tip reads 2190 lb/ft2. What is the velocity of the airplane?
Water flows inside a horizontal pipe so that at the beginning of the pipe it’s velocity v1 is lower than the velocity at the end of the pipe v2. Compare the pressures at the beginning P1 and at the end of the pipe P2: A. P1 > P2 B. Not enough information
A u_tube whose arms are open to the atmosphere. Now equal volumes of water and light oil. (density =49.4kg/m^3)are poured from different arms. A person blows from the oil side of the u_tube until the contact surface of the two fluid moves to the bottom u_tube, and thus the liquid levels in the two arms are the same .if the fluid height in each arm is 30in,Determine the gauge pressure the person exerts on the oil by blowing.
The water level in a tank is 66 ft above the ground.A hose is connected to the bottom of the tank at the groundlevel and the nozzle at the end of the hose is pointed straightup. The tank cover is airtight, but the pressure over the watersurface is unknown. Determine the minimum tank air pressure (gage) that will cause a water stream from the nozzle torise 90 ft from the ground.
What time (in second) is required to fill the circular tank with incompressible water from h= 2 m to H=7.0 m? D=20 cm – H water d1= 4cm d2=3 cm v2=2 m/s v1=5 m/s
b. A differential manometer is attached to pipe (p=10cm) which deposites a volume of 5 drums an hour , lubricant with S= 0.90. if the diameter of the pipe is double with respect to the contriction, determine the following: (1) Q in Ips, (2) Velocity at points A, B and at the contriction, (3) pressure at points A and B and (4) if it will be transporting mango juice with S=1.02, does the system is applicable, why? 100mm - Mercury A в Oil, S= 090
A 60 mm diameter pipe has a discharge of 450 litre/min. At a section the pipe has a sudden expansion to a size of 90 mm diameter. If the pressure just upstream of the expansion is 20 kPa, calculate the pressure just after the expansion. Assume the pipe to be horizontal at the expansion region. :2 d2 2 :2
A certain turbine has a capacity of 45 ft³/s. 3ft³/s is lost during the flow. The tailwater is 14 7 ft from the center of the turbine. The intake measures 35 in and the pressure is measured by mercury u-tube manometer which measures 15.566 ft in the intake and 3.00 ft in the discharge side. The datum of the scale is at 5.62 ft below that of the center of the turbine. The brake power output was 767.8 kw. Losses is measured to be 20.2 KW. Calculate the efficiency of the turbine
Between two sections in a vessel, a fluid moves in a steady flow manner. At entrance: A1=20 cm2, ρ1=1878 kgm/m3. At exit: A2=10 cm2, ʋ2=249.5 cm3/g, ῡ2=3048 cm/min. Determine the following: ḿ1 in g/min ῡ1 in m/min
The Super Soaker XP30 is a marvel of hydraulic dispersion weaponry. By pumping on the handle, you charge the chamber to high pressure. The pressure is maintained until you pull the trigger at which point the water (? = 1000 kg/m3) is released at high velocity.You have charged your pressure chamber to an absolute pressure of P1 = 697500 Pascals, much higher than today's outside air pressure of 101300 Pascals. The pressure chamber is location at a height of y1 = 0.103 meters above the exit point. The exit point has a small opening with radius r = 0.0033 meters.Determine all the following:The velocity at which the water exits the Super Soaker: v2 = m/sThe mass flow rate through the exit: kg/secThe volume flow rate through the exit: m3/secNOTE: You may treat the water chamber as a "tank" and approximate the water velocity there to be zero.