Answered: In a RLC electrical circuit, if…

In a RLC electrical circuit, if resistor is 71 ohms, inductive reactance is 130 ohms and the capacitive reactance is 45 ohms. Calculate the over all impedance, Z. O 110.75 O 17.66 O28.00 O 12266.00

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: Find the following phasors. אלל jue J.1 Vt 2.1 Vz 23 13

Q: For the system in Fig. 14.87, find the sinusoidal expression for the unknown voltage v if ein 60…

A: In the given questions, we need to calculate voltage Va. Va can be calculate by converting the…

Q: Solve for the Vrms (magnitude only) across the capacitive reactance if R2 = 1087 ohms and Xc = 2301…

A: The solution is given below

Q: For the pairs of sinusoids, determine which one LAGS by how much a. e = 10cos(4t – 60°) V and i =…

Q: A 12 V, 1kHz ac voltage source is connected to a parallel RC circuit. Given that R = 220 22 and Xc =…

Q: What is the impedance of a 50uH inductor at f=10,000HZ? jo.5 jo.318 j2 j3.14

Q: Given the voltage v(t) 120 cos (314t + t/4) V, determine the frequeney. E W.: (Answer: 50 Hz; 45 %3!…

A: Given voltge equation = 120cos(314t + pi/4) t

Q: The voltage and current of an ac circuit are as follows: e = 141. sin (377t + 10) V and i = 10 cos…

Q: A 1,000-2 resistor is in series with a 2-mH inductor. An ac voltage source operating at a frequency…

A: Inductive reactance of inductor(XL) =2×3.14×frequency ×inductance =W×L Where W is frequency in…

Q: Express these sinusoids as phasors 1. v = 7 cos (2t + 40) 2. i = -4 sin(10t + 10)

Q: If x(t) = 13cos2t +5sin 5t and y(t) = 15cos(2t – 11.8°) what is the phase difference? (Both must be…

A: According to the question we need to calculate the value of phase difference between x(t) and y(t).

Q: given this AC waves: i=150 sin(300)x(3.142)(t)-3.142/2 Ip=150A, Irms=106A, w=942 rad/sec Find…

A: The given ac rave can be represented as shown below:…

Q: Find the period, frequency, amplitude, time shift, and phase angle of the following sinusoid a)…

A: Period: It is a amount of time in seconds, required to complete one full cycle. Frequency: It is…

Q: Solve for the Vrms (magnitude only) across the capacitive reactance if R2 = 1062 ohms and Xc = 2221…

Q: 1. Given i =-10 sin(31 – 85°) a. Convert to cosine form. p. Transform to phasor c. What is the…

A: Given current equation, i=-10 sin3t-85°

Q: Given the sinusoid, calculate its amplitude, phase. angluar frequency, period and frequency. 4. 5…

Q: A 21.22mH inductance draws a current of i=15cos(377t -15°) from an AC Source. Write the equation of…

Q: A series RL combination in an AC circuit has R = 100 and X = 120. A capacitor is connected across…

Q: Q: v1(t) = -7 sin (1256t + 15°) V

A: To compare the angles between v1(t) and v2(t) , they should be expreesed in same form (either in…

Q: Find the instantaneous frequency in Hz at t=110 sec for 1- Cos(100πt+30) 2- Cos(200πt+160…

A: Given: t=110 sec f(t)=1- Cos(100πt+30) 2- Cos(200πt+160 sin⁡〖(πt/100)〗) Frequency=?

Q: An alternating voltage is given by v 261.03cos341t V. Find the frequency

Q: 13. Given L 32s sin t;L (16s +1) a) sin t. sin b) c) tsin d) tsint

Q: For the circuit shown below, e = 100 (157t + 20°) Calculate the sinusoidal expression for the…

Q: HE R2 Xc GEN V GEN : 15 Vpk-pk 20 kHz

Q: (b) A series RLC circuit with L=160 mH.C= 100 µF, and R = (X+10)N is connected to a sinusoidal…

A: In this question, we will find total impedance , current and phase angle of series RLC circuit...

Q: Find the phase angle in the given alternating quantity: 90sin 400πt V. Kindly provide a CLEAR and…

A: Bsin( wt+ theta) Compare the given signal with the above Signal

Q: For the circuit shown below, e = 100 (157t + 30°) Calculate the sinusoidal expression for the…

A: jXL = j50 ohm = 50 angle 90° Current given by i = V/jXL V= 100 angle 30°

Q: 4. a) Find the equivalent impedance between terminals A and B for the following circuit at a…

Q: 7. What is the capacitance value of the impedance 18.97 cis -18.2° with an angular frequency of w =…

Q: If x(t) = 13cos2t + 50sin 2t and y(t) = 15cos(2t - 11.8°) what is the phase difference? (Both must…

A: We will represent both signal in cosine term . Then represent both signal in one phasor diagram .

Q: which of the ff will maximize magnitude of average power supplied by AC source to simple RLC series…

Q: PRACTICE PROBLEM # 4 Express these sinusoids as phasors: (a) v = 7 cos(2t + 40°) V || (b) i = -4…

Q: If x(t) = 13cos2t +5sin 2t and y(t) (Both must be expressed in cos term) 15cos(2t 11.8°) what is the…

Q: + Va + + Up ein FIG.

Q: Evaluate the following. Show complete solution and your answer must be in simplified form. Your…

A: The solution is given below

Q: Find the time-domain expression correspon- ding to each phasor: 9.2 a) V = 18.6/-54° V. b) I = (20…

Q: 13.) Calculate the inductance or capacitance in series for the impedance 7.52-53.13° ohms. Assume…

A: The solution is given below

Q: O2.75*C 15 Find the phase angle of the given circuit, if V = 70V, 50HZ, R = 2400, X = 4050 and C le…

Q: 3. A sinusoidal voltage is applied to the circuit below. Determine the following: I, Irm, lavg, Ip-…

A: Given that sinusoidal voltage equal to 10V ad R = 1k ohm To find Ip Irms Iavg Ip-p

Q: Solve for the Vrms (magnitude only) across the capacitive reactance if R2 = 1062 ohms and Xc = 2221…

A: The following circuit diagram is given: Also, R2=1062 ohms and Xc=2221 ohms. The magnitude of the…

Q: 2. Determine the period of the following sinusoids: a) 4cos (3t + 33°) b) cos (2t +) + 3 sin (2t –…

A: The solution is given below

Q: Determine which of these sinusoids leads and how much time shift . 8 cos 314t and 9 sin (314t + 75°)

A: The given sinusoids are: A(t)=8cos314tA(t)=8cosωtω=314B(t)=9sin(314t++75o)B(t)=9sin(ωt+75o) Using…

Q: 2.1-3 Find the power of a sinusoid C cos (woł + 6).

A: The power consumed in a DC circuit is just the product of the DC voltage times the DC current,…

Q: Find the impedance of a series RLC circuit if the inductive reactance, capacitive reactance and…

Q: Given that a resistor R=4 Ohms and inductor L=9 Henry are in series with a sinusoidal voltage…

Q: Que A EM Dure is represented by the follosing equation:nivo sin [5x10t +4 sin 12soe) Determine the…

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: Q: v1(t) = -7 sin (1256t + 15°) V v2(t) = 12 cos (1256t - 20°) V Find the frequency and the phase…

A: The solution can be achieved as follows.

Q: The circuit below operates at a frequency of 50 Hz. Determine the value of C in order that the input…

Q: Vs The source Vs=10 sin (ot); R=100 ohms; w=2лf; f=1000 Hz; C = 1 mF. R w +1₁

Question

Solve it quickly please

111/|INMoving Forward
In a RLC electrical circuit, if resistor is 71 ohms, inductive reactance is 130 ohms and the capacitive reactance is
45 ohms. Calculate the over all impedance, Z.
O 110.75
O 17.66
O28.00
O 12266.00

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
R An RC parallel circuit. A 110-V, 60.0-Hz, AC line is connected in parallel to a resistor of 1000 Q and a capacitor of 1.00 μF, as shown in figure above. Find The capacitive reactance is must nearly. 2650 j2 0-2650 j 0-60 j 60jQ
VR. Ve YL 24 Is 6トO°Y Ic IL A,07 01 f: 50 H2 2mfC V Find Is,Ie, I, Ve,, Vez, I-, VRI, VR2, Ye, VL (ANSWER IN RMS)
A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power factor is ________. Hint: Draw the circuit and get Vs and Is
QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
PA.7. Reduce each of the following to rectangular form: a. Za = 5 + j5 + 10/30° b. Zh = 5/45° - j10 10/45° c. Zc 3 + j4 15 d. Za 5/90
2. A series RL circuit has voltage and current equations of e = 141.42 sin 2n30t + 141.42 sin 2n90t volts and i = 9.8 sin (2n30t - 30°) + 5.66 sin (2n90t - 60°) amperes. Determine the inductance L. A. 92.5 mH B. 38.3 mH C. 27.22 mH D. 83.49 mH
find the imaufitetd ciruit covraiuinga open sesistance of capacitor of 100 series inductance 04 D.15H and a connected in 122 ano micron farad ate 100 Vp so Hž supply.caleulate the total inpedance, the cireuits cument and vottage acro a auos each element
When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed frequency, there is a current of 0.332 A in the resistor. When an inductor is connected across the terminals of the same generator, there is a current of 0.365 A in the inductor. When both the resistor and the inductor are connected in series between the terminals of this generator, what is (a) the impedance of the series combination and (b) the phase angle between the current and the voltage of the generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number (b) Number Buda i Vrms R Irms.R Circuit 1 Units Units Vrms. Irms, L Circuit 2 > L Vrms R www Circuit 3
The average value of sinusoidal varying voltage is more than its r.m.s. value. Select one: O True O False Which of the following formula is CORRECT? a. E= - L d0/dt O b. E = - N dl/dt O . L= NI / O O d. W = 0.5 12L In a step down transformer, number of turns in the primary winding is lesser than the number of turns in the secondary winding. Select one: O True O False
A sinusoidal source supplies 20 KVAR reactive power to load Z 250275° Q. Determine the rms voltage. O7.525 kV O 5.725 kV O 2.275 kV O 7.225 kV
QUESTION 4 A resistor, a capacitor, and an inductor are connected in series with a function generator. The resistor has a resistance of 1.5k2, the inductor has a reactance of 1.2kQ, and the capacitor has a reactance of 2002. The circuit has a total current of 172mA RMS. Find the total voltage. O 310V233.7 O 74.5VL-14° 188V273.2 O 44.4VL-25.3°