In a refrigeration system there are 30 gallon per minute of water enters the evaporator at 25 degree C and leaves at 5 degree C. Find the tons of refrigeration is required. A. 45.07 TR B. 50.07 TR C. 55.07 TR D. 60.07 TR

In a refrigeration system there are 30 gallon per minute of water enters the evaporator at 25 degree C and leaves at 5 degree C. Find the tons of refrigeration is required. A. 45.07 TR B. 50.07 TR C. 55.07 TR D. 60.07 TR

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter21: Evaporators And The Refrigeration System

Section: Chapter Questions

Problem 5RQ: A refrigerant system's evaporator typically runs about ______degrees of superheat.

See similar textbooks

Related questions

Q: Turnbuckle T1 is tightened to a tension of 229 lb and turnbuckle T2 is tightened to 123 lb.…

A: According to the given data Co-ordinates the point- C=(32,0,60) ft D=(0,24,36) ft E=(-18,24,0) ft…

Q: . Consider a vertical cylinder with surface temperature at 500K. Both ends are insulated. The…

A: Given data: Surface temperature of the cylinder, Tcylinder = 500 K Diameter of the cylinder, D = 1 m…

Q: The 400-kg uniform beam is subjected to the three external loads shown. Compute the reactions at the…

Q: A closed cylindrical vessel 5 ft in diameter and 6 ft high is 3/4 filled with molasses (SG = 1.24)…

A: Given data: Diameter of cylindrical vessel = 5 ft Height of cylindrical vessel = 6 ft The vessel is…

Q: s (m) 2 2. Draw the a-t and v-t graphs. V= ds dt s=−2+2 1 d(-21+2) dt -1 (5) =-2m/s

Q: 6. In a steam power plant operating on ideal Rankine cycle, steam enters enthalpy of 2789.9 kJ/kg…

Q: How to get the moment of Inertia. Explain with examples

A: The moment of inertia is a measure of an object's resistance to rotational motion around a specific…

Q: The bell-crank mechanism is in equilibrium for an applied load of P = 47 kN. Assume that a = 300 mm,…

Q: A spark ignition cycle having a compression ratio of 9. The air intake is at 100kPa and 20°C, the…

Q: K I velocity 2 = 30 the Vo -R * x was projectte launched with range No = 20m/s, determine sto to =…

Q: 20016 Create a Shear & Moment Diagram of the following: w=50lb/ft IF+ 2Ft 91001 |w=1001b|ft| WH *…

Q: 2040 180 720 1080 0 Dimensions in millimeters The three feller cuts off large trees near ground…

Q: A 100 MW coal-fired power plant has an average heat rate of 9500 BTU per kW-hr. The plant factor is…

A: Maximum capacity of the coal fired power plant = 100 MW = 100×106 kW Average heat rate = 9500…

Q: The drive shaft AB of an automobile is made of a steel having an allowable shear stress of Tallow =…

Q: For methane at 1500 psia and 168F, determine: (A) z-factor (B) isothermal compressibility

A: To determine the z-factor and isothermal compressibility of methane at 1500 psia and 168°F, we can…

Q: The slope of the 6.2 kN force F is specified as shown in the figure. Express F as a vector in terms…

A: Given, Slope = 6.2 KN, a=8, b=3 It is asked to find force vector in terms of i and j

Q: Steam enters a turbine at 3 MPa and 600 C and leaves at 100 kPa and 100 C. In the process, it losses…

A: Given At turbine inlet P1=3MPaT1=600oCAt turbine outletP2=100 kPaT2=100oCQ=-150 kWm˙=2 kg/s

Q: The force F has a magnitude of 680 N. Express F as a vector in terms of the unit vectors i and j.…

Q: Instruction: Draw the Temperature & compute the LMTD for CO-CURRENT & COUNTER-CURRENT flow heat…

A: Givenwater evaporatorP1=125 kPa abs vapor pressuresteam available P2=1MPax=90% vapor content Find…

Q: ow through a converging nozzle can be approximated by a one-dimensional velocity stribution uvo…

A: Given: The equation for velocity, u=vo1+2xL The velocity at entrance =vo The velocity at exit =3vo…

Q: 1 - An aluminum plate is subjected to uniform stress along its boundaries, as shown in the figure.…

A: The given information in the problem is shown in the following attached image:

Q: 5. Hinged Plate The rectangular plate shown has a mass of 15 kg and is held in the position shown by…

Q: 4 - A rectangular block is loaded with a 180 kN axial force and a moment M, as shown in the figure.…

A: Given data:- Axial force =180 kN the maximum allowable tensile stress = 50 MPa To find:- the…

Q: For the problem shown, determine the magnitude of the force in member EF given that x = 2.3 m, y =…

Q: 6 - A circular bar is subjected to a lateral load and axial torque, as shown in the figure. If the…

A: Givenτ=100 MPa

Q: Solve the following problems on displacement, velocity, and acceleration. (1) The position of a…

Q: The system of three particles has the indicated particle masses, velocities, and external forces.…

A: To Find : The HG and dHGdt, Given : The mass of particle 1 is m1=1.2kg The velocity of particle 1 is…

Q: A car strikes a rigid post at the centre of its bumper. The car is moving at a speed of v-0.63 m/s…

A: Given: To find: 2nd moment of inertia Deflection

Q: Carbon dioxide enters an adiabatic nozzle at 1400 K with a velocity of 60 m/s and leaves at 600 K.…

Q: An experimental device imparts a force of magnitude F = 57 lb to the front edge of the rim at A to…

Q: 5.15 Carbon steel (AISI 1010) shafts of 0.1-m diameter are heat treated in a gas-fired furnace whose…

Q: 14.64 Tree limbs and branches are being fed at A at the rate of 10 lb/s into a shredder which spews…

Q: The pipe assembly in is secured on the wall by the two brackets. 60° 4 ft 4 ft 3 ft 30⁰ 3 ft B Part…

Q: Project Theme 6: Mixing container 2 A mixing container has A liters of saline solution that contains…

A: Let's denote the quantity of salt in the container at time t by Q(t) kg. Initially, the container…

Q: Project Theme 5: Parachutist Free fall can be estimated by the following differential equation: dv…

Q: Determine the scalar components Ra and Rp of the force R along the nonrectangular axes a and b. Also…

Q: 5 - A thin-walled pressure vessel is subjected to internal pressure p = 1 MPa. What is the maximum…

A: To find: The maximum allowable torque. Given: The internal pressure is p=1 MPa. The maximum…

Q: The 56-kg cylinder is suspended from a clamping collar at C which can be positioned at any…

A: Given Data: Find: Determine and plot the tensions in cable segments AC and BC as functions of x…

Q: 6-50. Determine the force in each member of the three-member space truss and state if the members…

Q: Neatly draw the required principal views for this part. Please determine which views are most…

A: I am using solid works to draw three projection views.

Q: Determine the scalar components Ra and R₂ of the force R along the nonrectangular axes a and b. Also…

Q: 430 N | لا 290 N A B 60° 480 N 60° 30⁰ 520 N D G 9.5 m 550 N 30° E 30° 280 N x

A: Triangle AFC- Triangle ACG- Triangle ABG-

Q: The purpose of the regenerative heat exchanger is to essentially recycle the heat rejected in step…

A: Stirling Cycle consists of following processes: A-B: isothermal expansion at hot reservoir…

Q: Please answer within 1 hour, thank you Determine the outer diameter (mm) of a tubular rod subjected…

A: let the outer diameter (mm) of a tubular rod=doGiventhe inner diameter, di=4do6the axial force on…

Q: Q.2) Member ABC is supported by arm BD (pin connections at B and D) and a pin support at A. Member…

Q: Get representation in State Variables

A: Given: To find: State space representation

Q: What is Brake horsepower and where did the name come from?

A: Brake horsepower (bhp) is a term used to describe the power output of an engine or motor. It is…

Q: For the truss loaded as shown, determine the equation for the line of action of the stand-alone…

Q: Consider the frame shown in Figure 1 that extends from A to D, and that is made up of three members…

A: Solution: Given Data: To Find:

Q: A 70 cm diameter centrifugal pump which is dynamically similar to the tested pump tabulated above,…

Question

In a refrigeration system there are 30 gallon per minute of water enters the
evaporator at 25 degree C and leaves at 5 degree C. Find the tons of refrigeration is required.
A. 45.07 TR B. 50.07 TR C. 55.07 TR D. 60.07 TR

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

pr and temperature decrease while the volume increase Which of the following does not help in collecting results in the mechanical heat pump? Select one: O a. Pressure gage O b. Flowmeter O c. Wattmeter O d. Receiver
C, The air pressure and temperature increase while the volume decrease O d. The air pressure and temperature decrease while the volume increase Which of the following does not help in collecting results in the mechanical heat pump? Select one: O a. Pressure gage b. Flowmeter C. Wattmeter O d. Receiver
17. One ton of refrigeration effect is equal to how many Btu/hr.?
n 13 "Heat and work are not mutually convertable in the system" it states ed out of O a. Clausius ststement b. Kelvin statement uestion O c. Boyle's law O d. First law of thermodynamics 14 type of compressor have more noise but high efficient system to used in industrial refrigeration system ut of O a. screw O b. scroll estion O c. centrifugal O d. Rotary
A 73 W freezer has an EER of 10.0. How much heat is exhausted to the room in 2.9 hours? (include units with answer)
What is the static air powering watts of a fan designed to deliver 800m3/hr of air with static pressure of 5cm of water column on full delivery.a. 155.3 b. 95.7 c. 105.8 d. 122.6
1 MT/h CH4 (liq) is heated to 44.85 deg C from 31.85 deg C, 400 kPa. What is the duty of the heater in kW? a.413.50 b.394.24 c.402.37 d.428.16
A tankless water-heating system gets its heat from thesystem's_______.
A refrigerant system's evaporator typically runs about ______degrees of superheat.
Two methods used to power refrigeration compressors on a ship are _____and ____.
The condensing pressure for a Rankine engine is 0.001325 MPavac. Calculate the following for steam flow rate = 1 kg/sec of steam when the steam at the beginning of expansion is at 119.6 deg SH and 4.0 Mpaa. Draw the TS and equipment diagrams for the ideal and actual case and find for the following for the ideal case: Pump work in KW. Ans. Ideal heat rate in KJ/KW-hr. Ans. Rankine engine efficiency (%). Ans. Cycle thermal efficiency ( %). Ans
Q.2: A refrigeration system using refrigerant 22 is to have a refrigerating capacity of 80 kW. The cycle is a standard vapor-compression cycle in which the evaporating temperature 42°C. -8°C and the condensing temperature (a) Determine the volume flow of refrigerant measured in cubic is meters inlet at the to the compressor. second per (b) Calculate the power required by the compressor. (c) At the entrance to the evaporator what is the fraction of vapor in the mixture.