In a long-shunt compound generator, the terminal voltage is 220 V when generator delivers 110 A. Determine (a) induced emf and (b) total power generated. Given that shunt field, series field, diverter and armature resistances are 90 2, 0.025 2, 0.04 2 and 0.03 o respectively.

In a long-shunt compound generator, the terminal voltage is 220 V when generator delivers 110 A. Determine (a) induced emf and (b) total power generated. Given that shunt field, series field, diverter and armature resistances are 90 2, 0.025 2, 0.04 2 and 0.03 o respectively.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Q1/(a) At the network below, „Find Av 18 V 3.6KN C2 110 ΜΩ Ipss = 6 mA Vp=-3 V Yos = 10 µs Z. 150 2 ...

A: GIVEN: a circuit diagram with IDSS=6mAVP=-3Vy0S=10μs FIND: AV

Q: An 8-pole, 3-phase, 50 Hz induction motor is operating at a speed of 720 rpm. The frequency of the r...

A: Given, A 3-phase induction motor is having P=8f=50 HzNr=720 rpm

Q: Determine Vo for the following two circuits 12 V 2.2 ka 10 k2 -12V (a)

Q: How many ampere turns are required to set up a flux density of 80,000 lines per sq inch in a 15 in. ...

Q: Three point charges are located as shown in the figure. q1 =-9 x 10-12 [C] and d = 5 (cm] 92 =1 x 10...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: Ps: The differente equation of the Rillowing. dingram. is 3. -4

A: Block deduction- In control system, the whole system is represented in block form which are deduced ...

Q: 2- Explain the effect of increasing the filter capacitance on the output voltage.

A: 2. When the capacitor size is increased then the peak current in the diode and the dc voltage will a...

Q: What will be the value of V, in the given circuit? 32 ww 20A 102v, 252

A: We have to find the value of voltage VA

Q: For the series-parallel magnetic circuit shown in Figure 1, draw the equivalent magnetic circuit and...

A: The given circuit is shown below: ϕg=2×10-4 Wb

Q: An alternating current of frequency 50Hz has a maximum value of 200 2A Reckoning the time from the ...

A: Given, An alternating current Frequency, f=50 Hz Maximum current, Im=200 A

Q: rotary variable transformer has following spec +-70degree linearity Error+-2.0% of full range. sens...

Q: A capacitor is connected in parallel with a coil having L = 5. 52 mH and R = 10 ohms to a 100 V, 50 ...

Q: SV D9 D8 D7 20 26 28 32 19 25 27 31 35 DO D3 D5 D6 GND 30 8's cohumn L 'KH CND OPIO 26 IZ OlaD : 2 o...

A: The solution is given below

Q: calculate the magnitude of the current through the j3.3k ohm inductor. jl k2 1.2 k2 -j4.7 k2 j2.2 k2...

Q: An object is launched at a velocity of 20 m/s in a direction making an angle of 25° upward with the ...

Q: A long wire carrying a certain current produces a magnetic field of 0.8 Tesla at a distance 0.5 cm. ...

Q: Whas is the circuit diagram of linear voltage regulator for fixed output voltage using IC78xx and IC...

A: Voltage regulator- Voltage regulator is a device which provide a fixed voltage as an output for fluc...

Q: a 3 IV it, 9.

A: The solution is given below

Q: + Vx 2 kl 1 kn 12 v+ RL 2Vx Figure: Power supply system Using Thevenin's or Norton's analysis, answe...

Q: Which of the following has no units? A. Permeability B. Moment of a magnet C. Magnetic susceptibilit...

Q: Three point charges are located as shown in the figure. 9=-5 x 10-12 (C) and di =6 (cm] 92=-4 x 10-2...

Q: 2) While selecting the casing for switch, refer Termination options dimensions PCB layout dimensions...

A: It is asked to choose the correct option is to be referred while selecting the casing for switch.

Q: Example-3: Determine the transfer function C/R for the block diagram Ha R G2 G3 H a G4

Q: #8)- FIND VO of Vo

A: For the given circuit we have to find the value of voltage vo

Q: KHZ 2. 4) How to determene Cutoff froy. ond whih Crlut has Hhis characterestics ond why Vout Vaut

Q: Compute the Thevenin equivalent seen by the inductor. 10 k2 3V 50 mH 47 k2 The value of VThis V and ...

Q: Compare the result of using a VIRTUAL DIODE vs 1N4001. Please explain.

A: The characteristics of a virtual diode and a 1N4001 diode is shown in the question. The values of re...

Q: 10.4: For the circuit shown: 1. Find the Z-Parameters? 2. Find the Y-Parameters? 52 ww 2012 202 502 ...

Q: Vr. R, E=72V R 2

Q: A system G(s) = 3(s+4)/[(s(s+2)] is connected with unity negative feedback. Which transfer function ...

A: Given, Unity feedback system with negative feedback, Hs=1 Forward path transfer function, Gs=3s+4ss+...

Q: What does the word "azure domain" mean?

A: Given term Azure domain is explained below:

Q: An inductive circuit of resistance of 2 ohms and inductance 0.01 H is connected to a 250 V, 50 Hz su...

Q: (2) ylbäi :The current I in the circuit shown is 16 V 5.6 k2 V. Si -4 V 1.95 mA 5.73 mA O 3.44 mA 8....

A: Given circuit,

Q: #7.7 An amplifier has a voltage transfer function 10° s T(s) = (s+10)(s+1000) Convert this to the fo...

Q: A 4 pole, long-shunt lap wound generator supplies 20 kW at a terminal voltage of 300 V. The armature...

A: This question belongs to electrical machine . It is based on the concept of induced e.m.f. in long s...

Q: vt) (V) 320 :1 F 10 v;(t) 10 1 1(s) (a) (b) Şekil 3

Q: Compare the results of static or dc resistance of the diodes obtained from different values of rever...

A: The characteristics of a virtual diode and a 1N4001 diode is shown in the question. The values of re...

Q: ) Find the current (1) in the circuit below using the superposition principle. ww ww 16V 4 A 12 V

Q: Q2 : Suppose you have the following modulated signal with the output wave changes of ± 5.5 Vp: Va ) ...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: /10 V 12 V 62 22 36

Q: Series Diode Configuration 4. Ge Si 4. Vo and Ip +12 Vo- Love Ip 5.6KQ

Q: F2(ABC) = (AÅB)C + (A’+B’)’ 1. Convert the expression into Standard Sum of product (SSOP) form using...

A: Brief description : SOP : Sum of product terms. POS : Product of sum terms. SOP : Minterms. POS : Ma...

Q: Q/ Calculate the value of the aurrent shown in the cirauit below, given that the value of the resist...

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per ...

Q: The percent values of the voltage, current, impedance, and volt-amperes for a given power system are...

Q: Convert this to the form convenient for constructing Bode plots. That is, place the denominator fact...

Q: An ac voltage of peak value 20v is connected in series with a silicon diode and load resistance of 5...

A: This question belongs to analog electronics . It is based on the concept of analysis of silicon dio...

Q: What is the circuit time constant? 1 kQ i(1) I mH ll

A: For RL series circuit time constant =Inductance/resistance I.e. time constant = L/R.

Q: Q2) The loop shown in Figure below is inside a uniform magnetic field B = 50ay mWb/m2. If side DC of...

A: It is given that: B=50aymWb/m2f=50Hzρ=6cm

Q: 04 By using maxwells method cal late: 1. I, and I, in the below circt. (all resistors values are in ...

A: This question belongs to electrical circuit theory . It is about calculation of current in the circu...

Q: What voltage would you recommend to allow a 25 kW, 550 V, 60 Hz, 3-phase, 4-pole, 1750 rev/min induc...

A: Given induction motor have, Power, P1=25 kWVoltage V1=550 vFrequency f1=60 HzPoles, P=4Speed N1=1750...

Question

2. In a long-shunt compound generator, the terminal voltage is 220 v
when generator delivers 110 A. Determine (a) induced emf and (b)
total
power generated. Given that shunt field,
series field,
diverter and armature resistances are 90 2, 0.025 2, 0.04 2 and
0.03 2 respectively.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then line current is a. 2A b. 1A c. 9A d. 10A
Two 30 AC generators are such that one has twice the linear dimensions of the other. The field windings of each are excited to give identical sinusoidal air gap flux density waveform. Both have the same number of stator slots and identical winding patterns. The conductors per slot in big generator in K times that of the smaller one. The value of K to get equal no-load voltage at same frequency is (a)8 (b) 8 1 (d) 7 (c) 4
The terminal voltage of a 150 kW series generator is 600 V at rated load. The armature resistance is 0.06 ohms and the series field resistance is 0.04 ohms. Find generated emf.
What are the conditions in paralleling of these DC Generators:a. Shuntb. Seriesc. Compound
A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216 slots, each containing 5 conductors arranged in a full-pitched winding for 3-phase star connection. All the conductors of each phase are in series and the flux per pole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emf induced in each phase winding and the terminal voltage.
(use 2-decimal digits for solutions) A synchronous generator runs at 250 rpm and generates at 50-Hz. There are 216slots, each containing 5 conductors arranged in a full-pitched winding for 3-phasestar connection. All the conductors of each phase are in series and the flux perpole at no-load sinusoidally distributed over the pole pitch is 30 mWb. Find the emfinduced in each phase winding and the terminal voltage.
2.2 A three-phase synchronous generator has a reactance of 1.5 p.. and negligible resistance. It supplies a rated current of 1.0 p.. at 1.0 p.u. terminal voltage to a lagging load of 0.9 power factor. Determine the rated excitation voltage in p.u. and the internal load angle. Construct the performance chart of the generator in 2.1 (above) assuming its rating is 450 MVA.
A short shunt compound generator delivers 150A at a terminal voltage is 230V. The shunt field current is 2.5A. The resistances of the armature, series field and diverter are 0.032-ohm, 0.015 ohm and 0.03 ohm, respectively. Calculate the electrical efficiency of the generator at this load.
The standard practice of synchronous generator construction now a days is to have Cylindrical field Rotating armature Either of the above Rotating field In an alternator, the armature reaction influences the magnitude of No load loss Wave form of generated voltage. Speed of the machine Flux Terminal voltage per phase
Q2: A three phase alternator is rated at 120 mva,13.2 kv,0.8 pf lagging, and 60 Hz. its direct axis reactance is 0.62 N and its quadrature axis reactance is 0.4 N.all rotational losses may be neglected . 1-What is the voltage of this generator at the rated condition? 2- what is the voltage regulation of this generator at the rated conditions?
3.A single phase AC generator has an armature winding resistance and reactance of 0.25 ohm and 2.5 ohms respectively. At rated load, the current delivered is 50 A at 500 V. Determine the generated emf when the load power factor is a. unity b. 0.819 lagging c. 0.766 leading
The terminal voltage of a 150kW series generator is 600V at rated load. Determine the efficiency if the armature and series field resistances are 0.04 and 0.06 ohms respectively.