Answered: Imagine that in the measurement of 4.6…

Imagine that in the measurement of 4.6 cm long metallic cylinder, your measurements in centimeters are (3.0, 3.5, 4.0, 4.5, 5.0, 5.5,6.0}. What is the standard error of your length measurement.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 11CQ: Significant Figures (a) What is the relationship between the precision and the uncertainty of a...

See similar textbooks

Related questions

Q: Amtrak's 20th-Century Limited is en route from Chicago to New York at 120 km/h when the engineer…

Q: A proton is released from rest in a uniform electric field. Which statement is correct? a. The…

A: When a proton is released from rest in a uniform electric field, understanding its behavior requires…

Q: A baseball player hits a ball straight up into the air. It leaves the bat with a speed of 120 km/h.…

A: The initial speed of the ball moving vertically upward is Let the speed of the ball when the catcher…

Q: نة = 4 hy m= L=1m 2a = L

Q: An object is located at s(0)=1 and is moving along the s-axis with the velocity v(t)=4−2t. What is…

Q: You are working in a cardiac unit and are tasked to determine the percentage of blockage in a…

A: The average blood velocity for a non blocked artery, v1 = 30 cm/sThe blood velocity at the fastest…

Q: An ice block of mass 1.2000000000000002 kg at an initial temperature of –11 ∘C is put into a copper…

A: Mass of ice is Initial temperature of the ice is Mass of copper is Quantity or mass of water is…

Q: A barometer is used to measure air pressure. It is made of a tube of mercury (density of 13 500…

Q: Let B = 4.70 m at 60.0°. C and A have equal magnitudes. The direction angle of C is larger than that…

Q: 6. An L-shaped container is filled with a liquid. The space above the liquid surface at point C is…

Q: Suppose a car is being towed with a force of 1000N. The chain used to pull the car makes a 25 degree…

A: Force F= 1000NDisplacement of car d=5km= 5000mAngle =25° with horizontal

Q: The A-36 steel wire AB has a cross-sectional area of 11 mm² and is unstretched when 0 = 45.0°…

Q: Select all cases where the sum of the vectors is zero. Can you explain how and why you got your…

A: So So

Q: 1. Inspect your Picket Fence. You will be dropping it through a Photogate to measure g. The…

A: Photogates are electronic devices that can determine the time interval during which an opaque object…

Q: Consider the physical quantities m, s, v, a, t, and r with dimensions [m] = M, [s] = L, [v] = LT–1,…

Q: As a racing car zooms by you, its pitch (frequency) decreases by 20%. If the speed of sound is 345…

A: The decrease in the frequency of the source as it moves away is 20%. i.e where,fo =…

Q: 18. A hydraulic lift is made by sealing an ideal fluid inside a container with an input piston of…

Q: What is wrong with the following problems? Explain in full sentences! 0x54x10x4 9) 0.54 x 10 Should…

A: The proper format for scientific notation is A×10b where A is a number or decimal number such that 1…

Q: (a) Use the appropriate Uncertainty Principle to calculate the linewidth uncertainty in units of Hz,…

Q: If d-1.4 mm, L -10.05 cm, and q=4.82 nC, then what is the magnitude of the potential difference, in…

Q: Express the speed of light, 3.00 × 108 m/s, in (a) ft/ns; (b) miles/s; (c) AU/h. I need to show all…

A: The speed of light is

Q: The wood beam has an allowable shear stress of Tallow = 5 MPa. (Figure 1) Figure 50 mm 50 mm 50 mm…

Q: Why do we not put the net force of y equal to ma (mass x acceleration), since the object is…

Q: 10. Two-point charges of Q and 4Q are placed on x respectively. If d- 50 cm, as shown in the figure,…

A: Charge= QCharge= -4QDistance between charges d= 50cm “Since you have posted multiple questions, we…

Q: 2. A piece of thin uniform wire of mass 7m and length 5b is bent into an equilateral triangle. Find…

Q: 3. An explorer in the dense jungles of equatorial Africa leaves his hut. He takes 45 steps…

A: An explorer in the dense jungles of equatorial Africa leaves his hut. He takes 45 steps northeast…

Q: 20. An ideal horizontal spring-mass system oscillates with a period of 0.55 seconds. The mass is 3…

A: Time period of oscillation (T)=0.55 sMass(m)=3 kg

Q: Using figure 4.3 calculate the voltage drop across Load 2, given the following values: (Answer in…

A: Current in load 1 (I1) = 42 A Current in load 2 (I2,) = 42 A Current in load 3 (I3,) = 42 A R1 =…

Q: A 2-cm-tall object is 20 cm to the left of a lens with a focal length of 10 cm. A second lens with a…

Q: When a tuning fork is held over the open end of a very thin tube, as in the figure, the smallest…

A: The smallest length that produces resonance is Let the wavelength of the sound be Let the next…

Q: The pendulum consists of a plate having weight Wp and a slender rod having weight W.. Determine the…

A: The pendulum consists of a plate having weight Wp and a slender rod having weight Wr

Q: A star with a trigonometric parallax of .02 arcseconds has a distance of O 2.0 light years. O 50 pc.…

A: Parallax angle p= 0.02 arcsecounds1 parsec = 3.26 light years

Q: A box Force resolve parallel component in an incline plane with a slope of with respect to 1.3 to…

Q: Three charged particles are located at the corners of an equilateral triangle as shown in the figure…

Q: 4. Holly uses 686 N of force to hold his body in the bottom of a push-up position 25 cm above the…

A: The force is The distance is The holding time of the body is 30 s

Q: What angle does the resultant force on the -8 nC charge at the origin make with the positive a axis?…

A: Charges are given as , and Position coordinates of charge are Position coordinates of charge are…

Q: If a doubly-ionized oxygen atom (O–2) is accelerated from rest by going through a potential…

Q: At a chemical plant where you are an engineer, a tank contains an unknown liquid. You must determine…

Q: Calculate the speed at apogee (Va) in m/s for a satellite in an elliptical orbit with perigee height…

Q: 2. Is the Earth's magnetic field parallel to the ground at all locations? If not, where is it…

Q: What is meant by the term "coherent light" and how is it achieved?

A: Coherent light Coherent sources of light or coherent light are those sources which emit a light…

Q: A 3.7-carat diamond is grown under a high pressure of 58x109 N/m2. One carat is 0.200 g, and you can…

A: The volume change of a 3.7-carat spherical diamond when withdrawn from the chamber and exposed to…

Q: A 6.00 kg box sits halfway up a 13.0 m long ramp that is inclined at an angle of 15.0o. You shove a…

Q: Figure 2 ft 6 ft 31 B 1011

A: Weight of the cylinder W = 740 lb

Q: At 2 pm a car’s speedometer reads 30 mph. At 2:10 pm it reads 50 mph. Show that at some time between…

Q: c) What is the tension in the string, T? Write your answer to two decimal places d) What is the…

Q: 29. The amount of water in reservoirs is often measured in acre-ft. One acre-ft is a volume that…

Q: Problem 1 Find the acceptance angles of the right-angle prism (a) and corner reflector (b) made from…

Q: The position x reached by a particle in terms of its acceleration a and the elapsed time t in the…

A: Dear student,Since both questions are different as per guidelines I can author only first one.…

Q: 1. A mechanic releases a small object with a density of 1.5 g/cm?3? and a volume of 1.0 cm?3? into a…

A: Density of the object Volume of the object Density of oil

Concept explainers

Half Life

The concept of Half Life has numerous practical applications some of them includes figuring out the effective drug dosage to finding out when a radioactive becomes safe to use. If you look for a career in Nuclear Physics you will need this concept.

Question

Imagine that in the measurement of 4.6 cm long metallic cylinder, your
measurements in centimeters are (3.0, 3.5, 4.0, 4.5, 5.0, 5.5,6.0). What is the
standard error of your length measurement.
O 1.08
O 0.022
O 0.22
O 0.41
O2.22

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduce the formula of standard error

VIEW

Step 2: Calculate the value of standard deviation

VIEW

Step 3: Calculate the value of standard error

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) A person's blood pressure is measured to be 1202 mm Hg. What is its percent uncertainty? (b) Assuming the same percent uncertainty, what is the uncertainty in a blood pressure measurement of 80 mm Hg?
(a) How many significant figures are in the numbers 99 and 100? (b) If the uncertainty in each number is 1, what is the percent uncertainty in each? (c) Which is a more meaningful way to express the accuracy of these two numbers, significant figures or percent uncertainties?
A marathon runner completes a 42.188-km course in 2 h, 30 min, and 12s. There is an uncertainty of 25 m in the distance traveled and an uncertainty of 1 s in the elapsed time. (a) Calculate the percent uncertainty in the distance. (b) Calculate the percent uncertainty in the elapsed time. (C) What is the average speed in meters per second? (d) What is the uncertainty in the average speed?
(a) If your speedometer has an uncertainty of 2.0 km/h at a speed of 90 km/h, what is the percent uncertainty? (b) If it has the same percent uncertainty when it reads 60 km/h, what is the range of speeds you could be going?
(a) How many significant figures are in the numbers 99 and 100.? (b) If the uncertainty in each number is 1, what is the percent uncertainty in each? (c) Which is a more meaningful way to express the accuracy of these two numbers: significant figures or percent uncertainties?
State how many significant figures are proper in the results of the following calculations: (a) (106.7)(98.2)/(46.210)(1.01) (b) (18.7)2 (c) (1.601019)(3712)
If you live in the United States, you probably know your height in feet and inches. In other countries, metric units are commonly used for measuring such quantities. First, find your height in inches. Then determine your height in a. centimetens and b. meters
Consider the equation s=s0+v0t+a0t2/2+j0t3/6+s0t4/24+ct5/120 , were s is a length and t is a time. What are the dimensions and SI units of (a) s0 , (b) v0 , (c) a0 , (d) j0 , (e) s0, and (f) c ?
A calculator displays a result as 1.365 218 0 X 107 kg. The estimated uncertainty in the result is 2%. How many digits should be included as significant when the result is written down? (a) zero (b) one (c) two (d) three (e) four
Units and Standards What is the difference between a base unit and a derived unit? (b) What is the difference between a base quantity and a derived quantity? (c) What is the difference between a base quantity and a base unit?
How many cubic centimeters (cm3) are in one cubic meter (m3)?
When nonmetric units we used in the United Kingdom, a unit of mass called the pound-mass (lbm) was used, where 1 lbm = 0.4539 kg. (a) If there is an uncertainty of 0.0001 kg in the pound-mass unit, what is its percent uncertainty? (b) Based on that percent uncertainty, what mass in pound-mass has an uncertainty of 1 kg when converted to kilograms?