If you know that the moisture content Y=0.019, and the wet bulb temp. = 28 °C for dry air at 1 atm. Then Find: the dry bulb temp., %relative humidity, V₁, dew point, and the enthalpy Solve using law ?

Q: a) Calculate the heat evolved (in J) when 100.0 g of pure H₂SO4 is added to 100.0 g of H₂O. b)…

A:

Q: Regulations of Contaminant (A) call for PPM less than or = to 20 PPM. is the treatment in spec?…

A:

Q: (b) I wo fluid streams with velocities u₁ and u₂ flow between parallel plates separated by a…

A: Given :u1 =15m/s   u2 = 40 m/sh = 25 m/sw= 3 mU=25 m/s

Q: A stirred-tank blending system initially is full of water and is being fed pure water at a constant…

A: 1% Define the parameters 2V = 2; % Volume (m³) 3q = 0.4; % Flow rate (m³/min) 4Ci =…

Q: An isothermal liquid phase zero order reaction A→B(k = 0.5mol/m³ - s) is carried out in a batch…

A:

Q: 2.10 The separation of isopentane from n-pentane by distillation is difficult (approximately 100…

A: Seperation of isopentene from n-pentane is done by distillation.Extended Antoine vapor pressure…

Q: C. Determine the fraction conversion occurring in the pond & the tank separately & determine the…

A:

Q: One gram of dye is injected into a long, thin tube and instantly mixes across the cross-section, A =…

A:

Q: 4. A feed of 4535 kg/h of a 2.0 wt%. Salt solution at 311°K enters continuously a single effect…

A:

Q: Below is a graph of a T-x-y plot for a non-ideal mixture of A and B where A is the more volatile…

A: The temperatures at points A, B, and C correspond to the following:Point A: The temperature at which…

Q: XA 0.0 mol -TA m³.sec 1 m³.sec -TA mol FAO (m³-sec) -TA mol 0.49 0.1 0.41 0.2 0.34 0.4 0.199…

A: Given, feed flow rate Tabulating data of XA and…

Q: (D) For two PFRs in series where each PFR is 1.6 m^3, determine the conversion after each reactor.

A:

Q: 24. Obtain the equation of motion for a one-dimensional, inviscid, unsteady. compressible flow in a…

A: Area of cross section of pipe is constant.Fluid flowing through the pipe is one dimensional,…

Q: Vapor pressure of benzene can be calculated using the Antoine's Equation: InP= 6.9057- 1211 T+220.8…

A: Please select text to grab.

Q: the amount of N₂ gas released at 37°C

A: At 37C and at a partial pressure, P1= 0.80 atmsolubility of N2 in blood, partial pressure of N2 in…

Q: A steady-flow 100% efficient water power plant has the following inlet and outlet conditions:…

A:

Q: What is the vapor density of this mixture at the following compositions at 405 kPa and 67 degrees…

A: Given the following composition:- Pentane: (0.349)- Butane: - Hexane: The molecular weights (molar…

Q: How long will it take for a non-reactive contaminant to travel a distance of 24 m if Darcy's flux is…

A: Since Darcy's flux is v = 6 cm/day and the porosity of the soil is 0.5, the velocity of the water…

Q: 3.7.* A river has a cross section that is approximately a rectangle 10 ft deep and 50 ft wide. The…

A: Depth of river = 10 ftBreadth of river = 50 ftAverage velocity of water = 1 ft/s

Q: Estimate the diffusion coefficient for methyl phenyl sulfide in water at 25°C.

A: As per the question given , The temperature of the methyl phenyl sulphide is 25 degc = 298 K We need…

Q: 23.18 The following data were obtained in the analysis of an industrial waste: After 5 days of…

A: Given,

Q: Find the mixture enthalpy for an ideal system containing 10 moles of component 1 and 90 moles of…

A: Number of moles of component 1 = 10 moles Number of moles of component 2 = 90 moles Temperature of…

Q: (b) Write the rate law for the reaction 2A + B C if the reaction (1) is second order in B and…

A:

Q: 3 How many lbf are needed to accelerate 2 lbm at 1 ft/² ?

A: given = mass = 2 lbmacceleration = 1 ft/s2to find = how many lbf are needed

Q: 220 kg of CO2 gas at 27oC and 1 atm is compressed adiabatically to 1/5th of its volume. It is then…

A: This problem involves two physical processes.First, the system of CO2​ gas undergoes an adiabatic…

Q: liquid densities. It has a volume of 25 cc, and a mass of 17.24 g when it is full of air. When…

A: i) Considering the mass of air ,Assume that the glassware is at NTP.At NTP:-Temperature T==…

Q: Chemical Engineering Question

A: Colours of the object.

Q: a. What is the boiling point of water? (Ans: 150°F) b. The boiling point elevation? (Ans: 12°F) c.…

A:

Q: Problem 1: Water flows steadily through the piping junction, entering section 1 at 0.0013 m³/s. The…

A:

Q: 1 Convert 2200 Slug R to SI unit 1 Rankine Scale

A: Question 1:We have been asked to convert  to SI units.To convert into SI units, the following…

Q: Consider the heating of a house by a furnace, which serves as a heat-source reservoir at a high…

A:

Q: 9. A troublesome reaction that is responsible in part for acid rain is SO3 + H₂O → H₂SO4 Rate data…

A:

Q: 1. Determine the ratio of diffusion coefficients for the following thre gnificance. Useful diffusion…

A:

Q: Estimate the concentration of ethylbenzene in fish tissue in a lake with a concentration in water of…

A: Ethylbenzene concentration in water = 120 mg/L

Q: A steam engine isentropically expands 5 kg/sec of steam from 0.68 MPa, 220C. The exhaust is dry and…

A:

Q: 2. Using the fugacity coefficient equation obtained from the van der Waals equation of state,…

A:

Q: Determine pressure of CO₂ at 400 °C with a density of 10 mol/l. Using (a) The ideal-gas equation.…

A:

Q: Keadey 3, 3.3. A hypothetical second order reactón A + B according to the rate equation d [C] dt = k…

A:

Q: can you do part B

A: From the solution of a) and b) we get to know…

Q: Mn in groundwater A ground water has the following conditions: {Mn2+ (aq)} = 1.0x10 -5 pH = 7.0…

A:

Q: In petroleum refining, hydrocracking is the catalytic splitting and addition of H₂ to large…

A: Basis    of fresh fuel oilThe mass ratio of H2 to oil is oil.Mass of Hydrogen fed to hydrocracker=…

Q: Q2/ Determine the maximum possible C.O.P for acyclic heat pump that is to pump heat / from an…

A: Initial ambient temperature, TL1 = -15°CTemperature of interior of house, TH = 25°C

Q: The expression for an integral balance on a semibatch process is always "Input = Output". CAI (mol…

A: Semibatch reactors function similarly to batch reactors since everything happens in a single stirred…

Q: The conventional barometer shown in Fig. 2.14 is filled with mercury. (a) How high must it be to…

A: The height of the liquid column in a barometer is determined by the pressure of the atmosphere. In…

Q: A landfill cell is open for 5 years, receiving solid waste of 250,000 tonnes/year. Calculate the…

A: To calculate the methane gas production for each year during the first five years of the landfill…

Q: 1. It is proposed to pump 10,000 kg/h of toluene at 114 °C and 1.1 atm absolute pressure from the…

A: Mass flow rate of toulene = 10000 Kg/hrTemperature of toulene = 114°CPressure of the toulene = 1.1…

Q: A hydrocarbon is burnt with excess air. The Orsat analysis of the flue gas shows 10.81% CO2, 3.78%…

A: When a hydrocarbon, which is composed of carbon (C) and hydrogen (H), is burned in air, it reacts…

Q: 4. The turbines in a hydroelectric plant are fed by water falling from a 125 ft height. Assuming 10%…

A: height from which water is falling = 125 ftsuppose mass flow rate of water is m1final energy needed…

Q: What are the key factors that influence the drying rate of solid particles in a rotary dryer, and…

A: Rotary dryers are widely utilized in various industries for the purpose of drying bulk…

Q: Hw: 1 what is the half-life of a substance that decays to 25% of its original amount in 6 days ?

A: A radioactive substance decays by first-order kinetics. If mo is the initial amount of the…