If you have a closed system that is filled with water on 2bar, the pump is selected for pressure losses due friction of the pipes(1bar) 1/ why don't we have to take pressure losses due height in account? 2/ what is the pressure at 100 m height inside the system? When the pump stops? And when the pump is circulating, prove your answer

Q: An air bubble rises from the bottom of the well where the temperature is 27°C. Find the percentage…

A:

Q: A pitot tube directed into a water stream having a velocity o 2.7 m/sec. It has gauge difference of…

A: Given:v=2.7 m/sx=30 mm =0.03 m

Q: A decorative fountain for a casino is designed to shoot a stream of water straight up in the air.…

A:

Q: A factory's pressure tank rests on the upper base of a vertical pipe whose inside diameter is 1 ft.…

A: Pipe is a cylinder, so its volume can be found as where d = inner diameter of cylinder, L =its…

Q: If the piston and water (p = 62.4 Ibm/ft) are accelerated upward at a rate of 0.4g, what will be the…

A: Given dataa=0.4gρ=62.4 lbmft3Z=2ftTo find pressure

Q: Estimate the time required to fill with water a cone shaped container (see the figure below) 4 ft…

A: Given Data  Filling rate, Q=21gal/min Height, h=4ft Radius, r=2ft

Q: Given a system as shown in the following figure. Calculate the water level difference between two…

A:

Q: The tank on the truck shown in Figure 1 is completely filled with gasoline,which has a specific…

A:

Q: A 1.5 m high tank is filled with water. A hole is punched at the side of the tank 0.25 m from the…

A: Given   Total height, H = 1.5 m   Hole height, h = 0.25 m           Gravity, g = 9.81 m/s2 Find…

Q: Find the pressure head at entry of the pipe, when the pressure of flowing water is 200 N/cm2 The…

A: It is required to determine pressure head at entry of pipe in Pa

Q: An open cylindrical tank is 1.3 m in diameter and 2.1 m high, is 3/5 full of water If the tank is…

A: Given Diameter of the cylinder = 1.3 m Height of the cylinder = 2.1 m Water filled = 3/5 of the…

Q: Given a system as shown in the following figure. Calculate the water level difference between two…

A: Given data as per question p1=7.35 psi=50676.47 pap2=0.5 atm=50662.5 paz1=?z2=0Q=1 m3h =13600…

Q: 92 is 2m above the orifice. If there is a pressure of 15kpa at the top of the oil surface inside the…

A: given:s.g=0.92diameter d=70mmp1=15kpap2=0atmZ1=2m

Q: Given a system as shown in the following figure. Calculate the water level difference between two…

A:

Q: 15! A closed rectangular tank full of water is 3m long, 2m wide and 2m deep. The pressure at the top…

A:

Q: An oil of specific gravity 0.78 is flowing through the pipe of diameter 30cm. one end of the simple…

A:

Q: An open tank contains 5.6m of water covered with 3.4m of kerosene (S.G=0.80). Find the pressure at…

A:

Q: A cylindrical tank of radius 5 ft and height 9 ft is two-thirds filled with a liquid of weight…

A: Given   Radius, R = 5 ft   Height, h = 9 ft      Density = 62.4 lbs/ft3 Find  Work required, W

Q: A Triangular gate having a horizontal base of 1.30 m and an altitude of 2 m is inclined 45o from the…

A:

Q: The pressure in the air space above the gasoline surface SG = 0.60 in a tank is 120 kPa absolute.…

A:

Q: Oil with S.G. = 0.86 is being transported in a pipe. Calculate the pressure if a U-tube manometer…

A:

Q: b- The right limb of a simple U tube manometer containing mercury is open to the atmosphere while…

A:

Q: A tank containing water moving horizontally with a constant linear acceleration (3.5m/sec2), and…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: height of fluid in the right limb is 6.95 cm. Find the pressure difference between these two pipes…

A:

Q: ( liquid of (u = 1.25 Pa s.) fills the space of (Sum) shown in figure below. Calcalate Hthe torque…

A:

Q: Shown below is the water jet flow from a pressurized closed tank. The vertical distance between free…

A: Given data:- h1 =13 m h2 = 15 m Y=9.81 kN/m^3 Find the pressure at 1.

Q: Find the pressure head at entry of the pipe, when the pressure of flowing water is 275 N/cm² The…

A: Given data:

Q: An open vessel of  water accelerates up to a 30ᵒ plane at 2 m/s². a). What is the angle the water…

A: Whenever a tank containing a liquid and the tank is moving on a inclined plane and is subjected to…

Q: Given the manometer set up, find the pressure difference between m and n in meter of oil and KPa oil…

A: Given: Specific gravity of oil (So)=0.90Specific gravity of mercury (Sm)=13.6

Q: Q47: In Figure below find the total pressure force on the gate ABCD. Assu gate has a unit width. 3.8…

A: Givenwidth of the gate w=1cm

Q: Q4: A simple manometer containing mercury is connected to pipe in which an oil of specific gravity…

A: Drawing the manometer as shown below –

Q: Q2: Calculate the depth H ofwater in Fig. below at which the conical valve starts moving. Take the…

A:

Q: 4. Using the figure below, find the time it takes for tank 2 to increase water level by 2m. (C =…

A: Given data: Area of tank 1 = π a b = π x 2 x 3 = 6πArea of tank 2 = π4 x 42 = 4πInitial height…

Q: A decorative fountain for a casino is designed to shoot a stream of water straight up in the air.…

A: given: inlet diameter of nozzle=4in outlet diameter of nozzle=2in height of stream=43 feet

Q: Parts A-C and Label them Question : Water flows downward in a pipe at 45°, as shown in figure below.…

A: Given Data:-

Q: The swing-check valve in Fig.  covers a 22.86-cmdiameter opening in the slanted wall. The hinge is…

A: Given: The value of the diameter of the opening is d=22.86 cm=0.2286 m. The value of the hinge from…

Q: best fits between the options of the graph A, B, C, D and F,

A: Given:- Static head= 85 Capacity= 195   To Find:- Best impeller & Expected Power consumption

Q: An inverted differential manometer is connected to two pipes A and B which convey water. The fluid…

A:

Q: A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open…

A: As per Question Pipe diameter =10cm Discharge =35 L/s We have to find the total energy at the…

Q: A constant area pipe filled with running water runs downhill then back up hill: Why would anybody…

A: When a constant area pipe that is filled with running water runs downhill then back uphill. In this,…

Q: An oil drop with the diameter of 1mm, is in the contact with the air with the pressure of 80 KN/m2.…

A: Basics of Fluid mechanics are used.

Q: An airplane is flying at standard sea level. The measurement obtained from a Pitot tube mounted on…

A: Given: The pressure read by Pitot tube is P1=2190 lb/ft2.

Q: A car is traveling on a highway at 28 m/s. a) What is the pressure at the bottom of a car's gas…

A:

Q: The power 491 W is required to transmit 3 x 103 m2/s of water. Find the loss of head due to friction…

A:

Q: If the pressure in a tank is 348 kPa, find the equivalent pressure head (in meters) of a liquid…

A: To find: The equivalent pressure head (in meters) of a liquid having a specific gravity equal to…

Q: Given: diameter of pipe in point 1 = 3.9in diameter of pipe in point 2 = 2.5in specific gravity of…

A: Given data, Diameter of the pipe at point 1, d1 = 3.9 in Diameter of the pipe at point 2, d2 = 2.5…

Q: The pump in figure below draws water from a reservoir at point A. In the suction pipe an open…

A:

Q: The power 365 W is required to transmit 6 x 10- m/s of water. Find the loss of head due to friction…

A: P=ρQgH

Q: Is the tank in the figure filling or emptying? At what rate is the water level rising or falling in…

A: Tank diameter = 6 ft V1 = 10 ft/s V2 = 4 ft/s V3 = 7 ft/s

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.