Answered: If Vsu= Vorg, how many times should the…

If Vsu= Vorg, how many times should the extraction process be repeated in order for 1 g of substance with KD= 2.25 to pass 90.5% to the organic phase?

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter15: Principles Of Chemical Reactivity: Equilibria

Section15.6: Disturbing A Chemical Equilibrium

Problem 2.2ACP

See similar textbooks

Related questions

Q: An acid solution containing 2 per cent by mass of NaNO3, and an unknown concentration of HNO3 is…

Q: 9. (a) Derive an expression for Langmuir adsorption isotherm for surface reactions with and without…

A: The answers are given below:

Q: A) Continuing from a pre-deposition of dopants to a substrate with a bulk concentration of 1016/cm³,…

Q: Explain the method of finding martensite fraction during SIM ?

A: Martensite is formed in carbon steels by rapid cooling of the austenite form of iron at such a high…

Q: “…measurements…have determined dissociation times for I and I* channels of 84±12 fs and 94±6 fs,…

A: The objective of the question is to figure out what does the "fs" in the given part of the sentence…

Q: Coprecipitation that involves foreign particles? a. Inclusion b. Mechanical entrapment c. Surface…

A: Co-precipitation :– The concurrent precipitation of more than one compound from an solution.…

Q: For the copolymerization of monomer (M1) with monomer (M2), the reactivity ratio's are r1 = 0.33, r2…

A: Combining the co-polymer equation or Mayo-Lewis equation in polymer chemistry with the equation for…

Q: Is the retention of particles related to the RSS or the relative supersaturation of the solution?…

A: Given: Retention of particles is related to relative supersaturation of solution. To find: whether…

Q: What are the different tetrabasic forms of EDTA? Describe their individual reactivities.

A: The structure of EDTA: EDTA (Ethylenediaminetetraacetic acid) is an amino polycarboxylic acid. The…

Q: Explain the function of the different steps in solid-phase extraction method.

A: Solid-phase extraction also known as SPE is an extraction technique in which compounds either…

Q: By employing a given conductivity cell with 0.1N potassium chloride at 18pC, an observed…

A: Given: Concentration of Potassium chloride = 0.1 N Conductance = 0.025 mho Specific conductance…

Q: Give 3 examples for inorganic binders and write their approximate calcination temperatures.

A: A question based on inorganic binders, which is to be accomplished.

Q: List the advantages and any disadvantages of SFE compared to liquid-liquid extractions.

A: Advantages of SFE(super critical fluid extraction) over liquid-liquid extraction Speedy process…

Q: 6. Below is an extraction scheme in which a mixture of four initial organic compounds is separated,…

A: Given is four different types of compounds, phenol, neutral ,base and carboxylic acid. We can…

Q: 2. Describe the importance of volcano curve in the surface catalysis with suitable examples

A: The answer to the following question is-

Q: kindly answer this problem and follow this format GIVEN REQUIRED SOLUTION and write regibly thank…

A: 1.26 g of substance A is adsorbed in charcoal from the aqueous solution

Q: The temperature-dependent form of the extended Debye-Hückel equation is (-1.825 x 10°) (€T) z² va…

A: Activity coefficient = 0.59

Q: Osmotic pressure of the gold sol with concentration of 4 g/l at 293 K is 8 Pa. Calculate the…

A: Osmotic pressure is given as: π=cRT where, c is the molar concentration of the solution

Q: If 30.0 mL of water that is 0.0500 M in Q is to be extracted with four 10.0 mL portions of an…

A: The final aqueous concentration in solvent extraction method is as shown below: Here, Initial and…

Q: Please define the term distribution coefficient, Kd? 2) How the value of Kd indicates the…

Q: Write the principle behind the following methods of refining :(i) Hydraulic washing(ii) Vapour phase…

A: The principle behind these processes are, (i) Hydraulic Washing: This method is based on the…

Q: 13.43 Octane (C3H18) enters an engine and burns with air to give products with the dry molar…

Q: Order the compound A, B and C from lowest to highest Rr. The sample is spotted on a silica te and…

A: Retardation factor (Rf) is calculated by the distance travelled by solute divided by distance…

Q: The Fe content in a water sample from a well was determined by subjecting an aliquot of 25.00mL of…

A: Number of atoms, ions and molecules present on a given amount can be determined by “Mole Concept”.…

Q: 18. Semi-permanent adsorption of polar analytes will cause: severe tailing of the peaks…

A: Gas chromatography (GC) is basically an analytical technique which can be used for the separation of…

Q: Vhich of these types of coprecipitation happens with greater probability when the ratio of the…

A: The type of coprecipitation happens with greater probability when the ratio of the contaminant…

Q: A student performed the fractional distillation of a cyclohexane/toluene mixture. The refractive…

A: Mole fraction is the ratio of moles of solute to that of total moles of solution. Mole percentage of…

Q: If Vsu= Vorg, how many times should the extraction process be repeated so that 1 g of substance with…

A: Let the required number of extractions be 'n'.

Q: Describe how does the extent of adsorption varies with pressure by freundlich adsorption isotherm?

A: We have to describe the extent of adsorption varies with pressure by freundlich adsorption isotherm…

Q: Write the differences between adsorption and absorption?

A: Adsorption is a surface phenomenon. It is of two types which are physisorption and chemisorption.…

Q: Benzyl alcohol (bp 205°C) was selected by a student to crystallize uorenol (mp 153–154°C) because…

A: To explain why the solvent benzyl alcohol (bp 205°C) is not a good choice for the crystalization of…

Q: Explain how manufacturers inhibit the physical adsorption of polar analyte species on the silicate…

A: Column used in column chromatography is made up of borosilicates. Silica is polar in nature due to…

Q: How efficient is the extraction of caffeine from tea leaves containing 1.0 g caffeine in 80 ml…

A: Caffeine is water soluble but so are some tannins and gallic acid which is formed in the process of…

Q: 5. By a fractional precipitation a polymer A with most probable distribution (I = 2.0) and an…

A: PDI of polymer A = 2. Weight average molecular weight = 2 × 120000 = 240000 g/mol. If mole fraction…

Q: In the beginning of the procedure, you will combine 1g of 3-nitrophthalic acid along with 2 mL of 8%…

Q: (c) Batch adsorption of 900 mg/L phenol was studied at 298 K using 50 mL aliquot at: an optimized…

A: A question based on adsorption that is to be accomplished.

Q: Which of the ff. process occur during co-precipitation? surface adsorption simultaneous…

A: Co precipitation is used for simultaneous precipitation of more than one component. Catalysts based…

Q: (c) Batch adsorption of 900 mg/L phenol was studied at 298 K using 50 mL aliquot at an optimized…

A: A question based on adsorption that is to be accomplished.

Q: The following plot was obtained from the supernatant of a sol after it had been pH adjusted with…

A: Given spectra:

Q: synthesis of Tris(ethylenediamine)nickel(1I) chloride dihydrate The equations of the preparation of…

Q: For the extraction of a metal ion with a metal chelator, by how many units will the pH change if the…

A: Given, Distribution ratio D changes from 0.06 to 100.0 D1= 0.06D2=100.0 [HL]org = constant (given)

Q: You have ZrO2-Nb2O5 composite and HfO2-Ta2O5 composite. Can you distinguish the oxide phases in the…

A: ZrO2 ceramics used in the it is mixed with usef to varous appications. ZrO2 contains Nb2O5 they…

Q: The chlorophyll sample contains Mg2 + ions. Briefly describe the sequencing steps to determine the…

A: Determination of magnesium ion using Erichrome Black-T as indicator: The concentration of Mg2+ ion…

Q: Why are adsorbate particles attracted and retained on the surface ofadsorbent?

A: Adsorption is mainly a consequence of surface energy. Generally, the surface particles which can be…

Q: 4. Give the mathematical equation relating the pressure (P) and the extent of adsorption (x/m) of…

Q: What is the difference between effect of pH and Point of zero charge with regards to Adsorption

A: Adsorption is the adhesion of atoms, ions or molecules from a gas, liquid or dissolved solid to a…

Q: A sample of an iron ore was prepared for Fe3+ analysis as following: 3.4g of the sample was added…

A: Given, Fe3+ in the final solution is 2.3 mg/L Sample taken - 3.4 g

Question

If Vsu= Vorg, how many times should the extraction process be repeated in order for 1 g of substance with KD= 2.25 to pass 90.5% to the organic phase?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

If Vsu= Vorg, how many times should the extraction process be repeated so that 1 g of substance with KD= 2.25 passes 90.5% to the organic phase?
Q: The solubility product of Zn(OH)2 at 25oC is 3.0 x 10-6 M3. Calculate the solubility of Zn(OH)2 in water in gdm-3. [Ar: Zn = 65.5; O = 16; H = 1] The Mr for Zn(OH)2 is 99.5. When I multiply it with Ksp, I didn't get the same answer as the given answer which is 0.904 gdm-3.
why does a change in pressure not affect the colour of a equlibruim mixture
Construct the expression for Ksp for solid Ba3(P04)2 in aqueous solution. Вaз(РОa)2(s) — З Ва" (аq) + 2 РО,3 (aq) 1 Based on your knowledge of how the solid will dissociate in aqueous solution, use the tiles to form the expression. Ksp CRESET [Ba3(PO4)2] 2[Ba3(PO4)2 3[Ba3(PO4)2 [Ba3(PO4)2l [Ba3(PO4)21° [Ba*] 3[Ba*] [Ba*j [Ba"] 3[Ba2*] [PO,?] 2[PO,] [PO,7? [PO,] 2[PO,] [PO4 3[PO,°] [PO,]°
mass Br- = 5.32 * 103* 79.904 = 0.4255 g. Os : What concentration Of Fez(SO4)3 (aq) is required for the olution to have [Fe*3 lag)] = 0.32M ? ) 0.16 M. %3D 0.080 M. 0.32 M.
Which of these types of coprecipitation happens with greater probability when the particle sizes of the precipitate are small? Surface adsorption Occlusion Mixed crystal formation Mechanical entrapment
What part does adsorption play in froth floatation for the concentration of sulphide ores and heterogeneous catalysis?
What wt of magnetite should be taken for analysis in order that after converting to a precipitate of Fe2O3.xH2O, the percentage of Fe3O4 in the sample can be found by multiplying the wt in grams of the ignited precipitate (Fe2O3) by 100.
An acidic solute, HA, has a K₁ of 1.00 X 10-5 and a partition coefficient, Kp, between water and hexane of 5.00. Calculate the extraction efficiency if we extract a 50.00 mL sample of a 0.025 M aqueous solution of HA, buffered to a pH of 8.00, with 100.00 mL of hexane.
The concentration of ammonia in a cleaning product was determined by back titration.Firstly, 10.00 cm3 of the cleaning product was pipetted into a large conical flask,containing 250.00cm3 of 0.50 mol/l HCl to give Solution A.Following a period of reaction and shaking, 50.00cm3 of Solution A was removed anddiluted to 250 cm3 with water in a volumetric flask to give Solution B.20 cm3 samples of Solution B were titrated against 0.05 mol/l Na2CO3 solution, givingan average titre of 12.45 cm3. i) Write equations for the reactions that have taken place.ii) Determine the concentration of NH3 in the original cleaning product in mol/l,g/l, ppm, and % w/v.
Tiame tests, the yello w colour oT sodium lons can mask the coIour of otner lons. Explain why blue glass is used to ldentity ions in the presence of sodium. Saved Normal B|I|U fx | | D E li Delete column
(4) Assume that the change in concentration of N₂O4 is small enough to be neglected in the following problem. (a) Calculate the equilibrium concentration of both species in 1.00 L of a solution prepared from 0.129 mol of N₂O4 with chloroform as the solvent. N₂04 (9) 2 NO₂ (g) Kc = 1.07 x 10-5 in chloroform (b) Show that the change is small enough to be neglected.