Answered: If value of voltage Vs is 20kv and VR…

If value of voltage Vs is 20kv and VR is 15 kv with load angle of 20 degrees. Value of line reactance is 5(ohm) Find value of active power and reactive power at receiving end of line.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter14: Power Distribution

Section: Chapter Questions

Problem 14.6P

See similar textbooks

Related questions

Q: estimate the distance over which the load of 15000 KW at 0.85 power factor can be delivered by a…

A: Given information: The value of the line current is determined as follows:

Q: What is load line and what is duty cycle?

Q: A 3-0, three wire CBA system, with an effective line voltage 200 V, has a balanced A. Connected load…

A: In this question we need to find a line and phase current of given three phase system.

Q: A 3-phase load of 10 MVA, 22 kV, 0.8 pf lagging, is served by 3-phase transmission line which has a…

A: First calculate receiving end current. Per phase sending end voltage = per phase receiving end…

Q: In a short paragraph, explain the need to use bundled phase conductors in HV, EHV, and UHV 3-phase…

A: Bundled conductors are made up of two or more stranded conductors that have been bundled together to…

Q: The one-line diagram of a three-phase power system is shown in the above figure. The line impedances…

A: Given One line diagram of a three phase system

Q: What is the percentage voltage regulation of short transmission line if its sending end and reciving…

Q: Evaluate the voltage reflection coefficient in terms of its load impedance and the characteristic…

Q: The impedance seen from the relay side in a distance relay is 10 ohms. Given that the CT ratio is…

A: Given: CT ratio is 1000 : 1 PT ratio is 100,000 : 110 Line has a resistance of 1 milliohm per km and…

Q: Determine the %Vdrop at the Main Distribution Panel (MDP) and at the end of the Service Panel (SP)…

A: We have to find total voltage drop so we will determine voltage drop in transformers and cables

Q: For a transmission line, the value of the open circuit and short circuit impedance are 100 ohm and…

A: If ZOC is the open circuit input impedance and ZSC is the short circuit input impedance of a…

Q: A three phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure…

A: expression for the transposed line for the inductance. Given line is double circuit. Assume…

Q: please write introduction about Analysis of 3 Phase star connected circuit Note:please write details…

Q: 2. A three-phase, three wire, CBA system with an a line voltage of 100 Volt, has three impedances of…

A: It is given that: VL=100Z=5∠30° Ω

Q: The value of value of voltage measured in residential convenience outlet is average voltage. True…

A: Average value is the average of the signal over the period of time. Where as rms value of the signal…

Q: The open circuit and short circuit impedance of a transmission line are 200 ohm and 50 ohm…

A: Given data:

Q: À three phase 220KV, 50HZ transmission line supplies a power of 100MW at a power factor of 0.8 lag…

Q: The impedance per phase of a 3-phase transmission line on a base of 100 MVA and 100 kV is 2 p.u. The…

A: Given, MVAold=100 MVAKVold=100 kVZpuold=2 p.u.MVAnew=400 MVAKVnew=400 kV

Q: Derive an expression of per unit impedance of a given base MVA and base KV in term of new base MVA…

A: To derive the expression of per unit impedance at a given base MVA and base KV in term of new base…

Q: Example: A 3-phase overhead transmission line has a total series impedance per phase of 200 280°…

Q: PRE 1997- B) Sketch the phasor diagram and the circuit of medium transmission line using nominal- T…

A: Kirchoff's voltage states that the sum of net voltage around a closed loop is equal to zero. It is…

Q: 3. A three-phase, three wire, CBA system with an a line voltage of 150 Volt, has three impedances of…

Q: A 45-km, 220-kV, 60-Hz three-phase overhead transmission line has a per-phase resistance of 0.2…

A: Transmission lines- Transmission lines are basically a part of an electrical system, through which…

Q: transmission line with an impedance of 35 Ω is connected to a load of impedance of 300 Ω, then the…

Q: A short, three-phase subtransmission line has an impedance of 1.5 + j2.4 ohms/conductor. If the line…

Q: A 69-kV, three-phase short transmission line is 16 km long. The line has a per phase series…

Q: Determine the current in the neutral conductor and the current in each line conductor (i.e., IR, IB…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: A high voltage DC transmission line delivers 1000 MW at 500 kV to an aggregate load over a distance…

Q: A 4.16 kV three-phase feeder is supplying a purely resistive load of 5400 kVA. It has been deter-…

A: The solution can be achieved as follows.

Q: A 69-kV, three phase short transmission line is 16km long. The line has a per phase series impedance…

A: We need to determine the sending end voltage, voltage regulation, the sending end power, and…

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: A short 3- line with an impedance of (6 + j8) N per line has sending and receiving end line voltages…

A: Given a short 3-φ line with, Impedance per line, Z = (6 + j8) Ω Resistance, R = 6 Ω Reactance, X = 8…

Q: A load of 120 MW at a power factor of 0.8 lagging can be delivered by a 3-phase transmission line.…

A: Solution:- Given, PL-3ϕ =120 MW PL-1ϕ = 40 MW Pf = 0.8 lagging VR-1ϕ = 45 × 1033= 25.9807 KV Single…

Q: The base current and base voltage of a 345-kV system are chosen to be 3000 A and 300 kV,…

A: Given: Base current =3000 A Base Voltage=300 KV Actual value =345 KV

Q: The three conductors of a 3-Φ transmission line are arranged in a horizantal plane and are 5m…

A: Consider that the phase inductance of phase conductor R,Y and B are LA, LB and LC respectively,…

Q: Example: A 3-phase overhead transmission line has a total series impedance per phase of 200 80° ohms…

Q: ii) A 10% voltage drop occurs in 2 km of a uniformly loaded transmission line terminated by its…

Q: A short 3-phase transmission line connected to a 33kV, 50 Hz generating station at the sending end…

A: The performance of a power system depends mainly on the performance of transmission lines in the…

Q: A transmission line section shows an input impedance of 36 2 and 64 respectively, when short…

A: Given a transmission line has, Short circuit input impedance, Zsc=36 Ω Open circuit input impedance,…

Q: 3.) Identical series capacitors are installed in each phase at both ends of the line in #1 and…

A: Series compensation is used to improve the power transmitted through transmission lines. it…

Q: Apply the knowledge of per unit system on above network and draw an impedance diagram showing all…

A: For the given data impedance diagram is drawn as shown below

Q: A transmission line has a per unit impedance of 0.5 pu at 500 MVA and 132 kV base. The per unit…

Q: True or false? With symmetrical components, the conversion from phase to sequence components…

A: In this question we will find that given statement is true or false which is that With symmetrical…

Q: For a given short transmission line of impedance R+jX ohms/phase, the sending end and receiving end…

A: Short transmission line Impedance Z=R+jX ohm/phase Sending end voltage Vs Receiving end voltages VR…

Q: The per unit impedance of s circuit element of 0.15. If the base kV and base MVA are halved, then…

A: Given, The per unit impedance of a circuit element of 0.15, Zpuold=0.15 Base kV is halved,…

Q: one circuit of a sinlge phase transmission line is composed of three solid 0.5 cm radius wires. the…

A: Let us consider the arrangement as : Inductance | phase | m L=2×10-7 lnDmDs H/m So, the GMD for…

Q: 2. A three-phase, three wire, CBA system with an a line voltage of 100 Volt, has three impedances of…

A: In this question three phase star connection is given....We have to find out line current , power…

Q: Using a test equipment, Vmax was found to be 5V while Vmin is 1V. The distance between voltage…

A: Given : Note : Please note that for the proper understanding here we have used two methods to…

Q: In a transmission line system, the three-phase lines supported by using three identical string…

A: Insulator-Each conductor is provided with a sufficient thickness of insulation depending upon the…

Q: At low power factor, the feeders have to carry more current for the same power to be transmitted.…

A: We know that active power is VIcosphi . As cosphi is very low, it has to draw more current to…

Concept explainers

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.

Question

If value of voltage Vs is 20kv and VR is 15 kv with load angle of 20 degrees. Value of line reactance is 5(ohm)

Find value of active power and reactive power at receiving end of line.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter (T-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an insulator string having two identical porcelain insulators. The self-capacitance of the insulator is 5 times the shunt capacitance between link and ground. Find the voltages across two insulators.
Determine the flow of active and reactive powers at the ends of the line: (Figure below)
Which of the following statements is/are true? A In purely resistive circuit, the current lags voltage. (B In purely capacitive circuit, the voltage lags current. In purely resistive circuit, the current is in phase with voltage. D In purely inductive circuit, the current leads voltage.
Power in a three phase delta system with balanced load is equal to (Sqrt (3)) (VL) (IL) (p.f.) (Sqrt (3)) (Vph) (Iph) (p.f.) (Sqrt (3)) (VL) (Iph) (p.f.) O (Sqrt (3)) (Vph) (IL) (p.f.)
What is load curve
In the Transmission Line Simulator, the Transmission Line is composed of which parameter/s? O A. The Shunt Conductance Only O B. The Series Impedance and Shunt Capacitance O C. The Shunt Capacitance Only O D. The Series Impedance Only
In a string of suspension insulator with three units, the line unit has 20kV and k=0.35. The voltage across tower unit is........ and across middle unit is.......
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
Discuss the principles and benefits of High Voltage Direct Current (HVDC) transmission in power systems.
Define percentage line and load regulation