hi, can you help me with this whole question.thank you (b)Use one's complement method to perform the binary subtraction111100 – 010110.(ii)The truth table of a logic circuit is given in Table 1.1.AВF1111111Table 1.1(а)Write down the Boolean expression for output F with respect toinputs A and B.(b) Draw the logic circuit to implement the Boolean expression youobtained using only NAND or NOR gates, or both.(iii)A logic circuit is given in Figure 1.1.ABFCFigure 1.1(a)Draw and fill in the truth table for output F with respect to inputsА, В and C.(b)Write down the Boolean expression for output F with respect toinputs A, B and C. Present your result in a simplified form.

Answered: Image /qna-images/answer/9797dfbf-68ac-4b94-bc4d-a5f6a0fbcee3.jpg

Answered: hi, can you help me with this whole…

Engineering

Electrical Engineering

hi, can you help me with this whole question. thank you

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Related questions

Q: parameters if IE =

A: BJT (bipolar junction transistor)- A transistor having a three terminal made up of semiconductor…

Q: write a rePort on gateway Connectivity

Q: hi, can you help me with all parts of this question. thank you

A: According to question: a) The voltage 'Vout' is calculated as Now looking from the characteristic…

Q: Please answer fully

A: Given circuit is of frequency division multiplexing technique. given f2>f1ϕt=3m1t.…

Q: * what ---- their phone number?( are, is, does, have) are is O does O have O

A: It is given that: What -------- their phone number?

Q: equations

A: The circuit of FSM shown below.

Q: hi please answer. thanks

A: 3) a) Break even point=Total fixed costRevenue per unit-Variable cost per unit Revenue per unit,…

Q: Hello, Not sure if this is possible but am i able to delete his answer from the system?

A: The solution is provided in the following section.

Q: please tell me last part answer

A: let Z = a+jb then a is called real part and b is called imaginary part .

Q: please help me in this question

A: i) Vs=10V

Q: 1) Speech level for normal conversation with little background noise would be at what level? a) 65…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What is the answer please ?????

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: need the answer as

Q: Can you solve the question step by step clearly

A: In this question we will find active power of long three phase transmission line.....

Q: Obtain the IX by the loop method. PLEASE DO THEN EXPLAIN TO ME THANKS

Q: need the answer as soon as po

Q: are you able to do the question in the photo ?

A: “Since you have posted a question with multiple sub-parts, we will solve three subparts for you. To…

Q: answer quickly

Q: please do "a)"

A: Given: A dc circuit. According to question: The current through 2ohm when 5A is active and 12V is…

Q: Please answer clearly

A: The explanation is as follows.

Q: Please help me understand what this question is asking

A: MMF - (Magneto-motive force) , It is generally denoted by Fm. Mathematically it is equal to product…

Q: please help me which options is correct ?

A: In this answer we will try to answer the value of the given definite integration as shown below.

Q: Can you fill this table with the data in the given?

A: Given the circuit : We need to fill up the table as given below:

Q: Calculate I, and Iz.

Q: can you do this question for me?

A: According to question: The charge particle in the question will be a 'proton' because a 'proton' is…

Q: PLEASE ANSWER ASAP PLEASE

Q: Fill in the blanks. I would love to see how to get the correct answers.

Q: Solve all questions, please.

A: In this answer let us try to answer the given questions as shown below.

Q: 1. Convert from decimal number to binary number (-20.75)10 (----) Your answer

Q: please use program

A: Since in the question, use of the program is instructed, the problem has been solved using MATLAB in…

Q: Can you solve the question step by step clearly?

Q: When ALE is high, address information is transferred through one of the system bus. Select one: True…

A: ALE (Address Enable Latch) :- It is a control signal in which a positive going pulse generated when…

Q: Please answer the question correctly and state the explaination.

A: In this question , we will find output voltage waveform and average output voltage for given…

Q: which ones are the answers??????

Q: I do not get the explanation you gave me. How did you get those numbers?

Q: answer all in short explanation

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Please answer with explanation...

A: The low tension leads carry only 6 or 12 volts. It includes the battery cables, the coil…

Q: please solve this question immediately.

A: Circuit is given as,

Q: Please answer quickly

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: hi, can you solve this question, please ?

A: According to question: Since S1 and S2 is opened for long time so initial voltage across capacitor…

Q: The best preferred method of communication within the public switched telephone Network (PSTN) is ;…

A: In this question , we have to tell about which method of communication within the public switched…

Q: How does a 1-∅ system differ from a 3-∅ system?

A: Single phase system has only one sine wave voltage where as 3 phase system has 3 sine waves with a…

Q: Answer 1st question please

A: Given, Weight of red cabbage, M = 1438 g As density of methanol is, D = 793 g/L

Q: answer as soon as possible

Q: Please answer very soon will give rating surely

A: Let the current flow according to the given rating be i.

Q: 1]

Q: Grateful some help with this question thanks.

Concept explainers

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors. The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.

Question

100%

hi, can you help me with this whole question.

thank you

(b)
Use one's complement method to perform the binary subtraction
111100 – 010110.
(ii)
The truth table of a logic circuit is given in Table 1.1.
A
В
F
1
1
1
1
1
1
1
Table 1.1
(а)
Write down the Boolean expression for output F with respect to
inputs A and B.
(b) Draw the logic circuit to implement the Boolean expression you
obtained using only NAND or NOR gates, or both.
(iii)
A logic circuit is given in Figure 1.1.
A
B
F
C
Figure 1.1
(a)
Draw and fill in the truth table for output F with respect to inputs
А, В and C.
(b)
Write down the Boolean expression for output F with respect to
inputs A, B and C. Present your result in a simplified form.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

T: Answer thne f. questions: 1) The hexadecimal number ´Al' has the decimal value equivalent to (A) 80 (B) 161 (C) 100 (D) 101 2) The output of a logic gate is 0 when all its inputs are logic 1. The logic is either (A) a NAND or an EX-OR (B) an OR or an EX-NOR (C) an AND or an EX-OR (D) an NOR or an EX-NOR 3) The Gray code of the Binary number 1100111 is (A) 1011011 (B) 1010100 (C) 1001001 (D) 101101 4) When simplified with Boollean Algebra (a+b)(a+c) simplifies to (A) a (B) a+a(b+c) (C) a(1+bc) (D) a+bc 5) -31 is represented as a sign Binary number ( using Sign-magnitude form ) equal to (A) 00011111 (B) 10101001 (C) 01110010 (D) 00101101 6) The Binary number 110111 is equivalent to decimal number (A) 25 (B) 55 (C) 26 (D) 34 7) With 4 bit, what the range of decimal values if the number is 2's complement signed number. (A) -32 to +31 (B) -2 to +1 (C) -8 to +7 (D) None of these
4. Design a circuit for 3-bit binary addition using logic gates and write the truth table and expression for sum and carry outputs. 5.Draw a block schematic arrangement of a Two bit parallel binary adder
A combinational logic circuit that compares between two 2-bit numbers A (A1 A0) and B(B1 B0) is designed. Output F is high when ? > ? and low when ? < ?. 1) Are there any undefined outputs? If there are any undefined outputs what are the inputs?
Design a 4-bit arithmetic circuit, with two selection variables S1 and S0, that generates the arithmetic operations in the following table. Draw the logic diagram for a single bit stage. Note that B’ represents “Not B”. Draw the logic diagram for a single bit stag
Boolean expression of a logic operation is given below: (a) Simplify the Boolean expression using Boolean algebra and De Morgan’s Theorems (b) Draw the circuit to implement the expression you obtain using NAND or NOR gates on
8. Subtract the following 16-bit binary numbers. a. 11001011 00101000, - 10011110 01011011, b. 10111100 10111000; - 10011000 11110011,
1.Perform the binary division 1001010.111 + 101 2. Draw a symbol and write the property of (i)NOT and (ii) EX-OR logic gates 3. Using K- map, simplify the following Boolean expression. Y = Em ( 1, 3, 4, 5, 6, 9, 11, 12, 14, 15)
We want to design a circuit to detect prime numbers.The input of the circuit is a 4-bit binary number and the output is a single bit and should show one when the number is prime and zero otherwise.B. Implement the circuit using a 4× 1 multiplexer and combinational logic gates.C. Implement the circuit using only one decoder and one OR gate. What is the size of the decoder you use?
Kindly design a Master-slave J-K flip-flop using NAND gates only and staterace-around condition, and how it can be eliminated in a Master-slave J-K flipflop? A multiplexer (MUX) also known as data selector, is a logic circuit which allowsthe digital information from multi-inputs to a single output line
4. A combinational logic circuit that compares between two 2-bit numbers A (AI A0) and B (B1 B0) is designed. Output F is high when A > B and low when A < B. a. Are there any conditions which cause none of the outputs to be asserted? If the conditions exist, what are the inputs? b. Derive the truth table and obtain the maxterm notation for the output. c. Obtain the minimized POS expression of the logic circuit. d. Draw the logic circuit using basic gates.
3 - Assume that a five-bit binary counter starts in state 00000b. What will your count be after 157 input pulses? a. 11111b b. 10101b c. 10001b d. 11101b e. 11011b
The input to a combinational logic circuit is 4-bit binary number (A, B, C, D). Design the circuit strictly using NAND gate with two outputs (Y1 and Y2) for the following conditions: Output Y1 is low when the input binary number is less than or equal to 7. Output Y2 is high when the input binary number is less than or equal to 7.