Please solve this question queckly H.W4 The diode in the single-phase half wave rectifier has150usec and the source voltage V₁recovery time of t₁ =frequency = 5 kHz. Calculate the average output voltage.F Gall=a reverse200V at

Answered: H.W4 The diode in the single-phase half…

H.W4 The diode in the single-phase half wave rectifier has a reverse recovery time of t₁ = 150µsec and the source voltage V₁ 200V at frequency = 5 kHz. Calculate the average output voltage. =

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: In handout 4, you learned about the principles, operation, and characteristics of the operational…

A: To explain and discuss how to use an op-amp as an integrator and differentiator.

Q: Without Rin, how should I find Rf in a Non-Inverting Amplifier?

A: The question is about finding Rf without Rin. Without Rin means Rin is infinite.Now find Rf.

Q: Figure 1.b shows a Translational Mechanical System. If an external force f(t) is applied mass M₁,…

A: Given Data:A mechanical translational system with,Input Outputs To Find:The differential equation of…

Q: Nonlinear devices can provide useful mathematical functions, consider the circuit shown in figure 9,…

A: In the given questions we need to calculate the output voltage.

Q: 320 V + t=0 = 350 μF V Given: The capacitors have initial voltages as shown in the above circuit. At…

Q: FIK AN 3900

A: define IC and VCE

Q: Determine the power consumed by resistor R₂, given: E₁ = 224 V, R₁ = 180, R₂ = 37, and R3 = 420…

Q: (a) Show that the two copled coils above can be replaced by a single coil having an induc- tance of…

A: The total inductance of the mutually coupled circuit with series aiding and series opposing…

Q: A 12 pole alternator has an armature wound with coils having fractional-pitch. Calculate the pitch…

A: define fraction pitch given fraction pitch= 17/24we know that fraction…

Q: In the circuit given below, R = 80 2. Find the value of io using mesh analysis. 400 V (+1 4 A ↑ The…

A: Mesh analysis uses ohms law and Kirchhoffs voltage law.The detailed solution is provided below.

Q: 6- Find the resistance value of R to receive the maximum power from the circuit it is connected to.…

A: The given circuit is,To determine the value of R to receive the maximum power from the circuit.

Q: A FM wave is represented by the following equation, V=9sin (5 x 10ft +3sin1300t) Find: a) Carrier…

A: FM wave is given as,

Q: Consider the linear de machine shown below. Frinctionless rails Sliding bar R₁=0.12 10 N 0.75 m t=0…

A: For the given linear DC machine arrangement, we need to determine:1) direction of electromagnetic…

Q: Find the convolution x[n]=0.5n|u[n]-u[n-6||, h[n]=2sin(nz/2)[u[n+3|-u|n-4||

Q: 6. In the AC circuit shown, the voltage leads the current by 26.6° and the impedance of the circuit…

Q: 1. Calculate Vx & Vy in the circuit of Fig1. 40 /30° V =j2 Ω 8 Ω 3 Ω j6 Ω 10 Ω Σ΄, 5/0°A

A: Given:a circuit,we need to find:the values of Vx and Vy.

Q: Given a continuous time signal x(t). Sample the signal with a sampling rate of Fs=100 samples/s.…

Q: A balanced 3-phase, 400 V, abc source is supplying power to an unbalanced delta load which consists…

A: The line-to-line voltage of a 3-phase, abc sequence is 400 V.The delta-connected unbalanced loads…

Q: Consider the following FIR filter or order M 1+z¹+ H(z) a) Find the impulse response of this filter.…

A: The transfer function of running average FIR filter of order M-1 is given asTo determine:a) impulse…

Q: Compare between the time-domain and frequency-domain of a sine wave signal. Assume the frequency is…

A: According to the question, we need to compare between time-domain and frequency-domain of a sine…

Q: Q1. Find currents and voltages in the circuit shown in Figure; i 60V +1 16Ω Μ + V - + + U2 13 α-- ἰ…

A: Circuit diagram is given as,

Q: Part A What is the equivalent capacitance for the circuit of the figure? (Figure 1) Express your…

A: Given:a circuit,we need to find:a) Equivalent capacitance of the circuit. b) Amount of charge flows…

Q: Determine the power consumed by R, given: E₁=161 V, R₁ = 33 02, R₂ = 450, R₂ = 1402, and R₁ = 320 Ω…

A: The battery voltage,The resistors,

Q: In the circuit given below, R= 20 Q. Find ₁, 2, and i3 using mesh analysis. 12 V (+ i₁ +51 Vo 292…

Q: What does the circuit work like?

A: The above question is based on the firing circuit of a TRAIC.

Q: 4.38 Apply Thevenin's theorem to find V, in the circuit of Fig. 4.105. 34 Μ 4Ω ww 16 Ω Μ 5Ω 1Ω 12 V…

A: Thevenin's resistance is calculated by deactivating all the active sources and equivalent resistance…

Q: State the difference between type BIT and type STD_ STD_LOGIC have so many values?

A: we need to:state the difference between type BIT and type STD_LOGIC.explain the reason why STD_LOGIC…

Q: Given the following current and voltage phasors, what is the power factor of the power being…

A: here we have to find the power factor.

Q: A 300 Km single circuit 30 transposed TL is composed of 2 conductors per phase, with horizontal…

A: In this question, we need to choose the correct options. What is GMR and total inductance .

Q: The voltage across a 5μF capactior is know to be 500te-2500t V for t≥ 0. (a) Find the current…

Q: Determine the voltage dropped across R₁, given: E₁ = 126 V, R₁ = 25, R₂ = 27, R₂ = 142, and R₁ = 130…

Q: Evaluate the factors that influence the choice of an appropriate cable for a specific connection.

A: When choosing an appropriate cable for a specific connection, several factors should be considered.…

Q: 17. The voltage across a 1 μF capacitor is given. What is the sinusoidal expression for the current?…

A: Capacitance is given

Q: For the circuit calculate the total current, the current in each inductor branch, and the impedance,…

A: Given circuitAsked to find thge,Current in each inductorTotal impedancephase anglereactive powerDraw…

Q: Consider the position control system given below. Determine the value of K such that the steady…

Q: 1. The buck-boost converter, shown in Fig. P1.1, has the following parameters: Vs = 12 V, k = 0.6, R…

A: The source voltage, The inductance,The capacitance, The switching frequency, The duty cycle,

Q: Use the superposition principle to find io and vo in the circuit of Fig. 4. 6 A 40 Ω 1 10 Ω www + vo…

A: In this question, we need to determine the current io and voltage vo by using the superposition…

Q: The AC voltage appearing across a load is 2sin(10^5t) and the AC current through the load is…

A: The voltage across the load, The current flowing through the load,

Q: + Vin Answer: R₁ Check + R₂ What is the voltage gain in V/V for the operational amplifier circuit…

Q: In the circuit given below, R = 4 22. Find the node voltages. 1 A V1 www 410 492 The value of ₁ is…

Q: C. 30 V For the circuit in next Figure, Find the total capacitance. Find the total charge Q (Q = Cv)…

Q: A single circuit 30 transposed TL is composed of 3 ACSR 1272000 cmil conductor per phase, with…

A: The given configuration is shown below,

Q: A variable resistor R, is connected across the terminals a b in the circuit in (Figure 1) The…

A: define maximum power

Q: Question 1: Given the engineering context of an autonomous underwater vehicle (AUV) communication…

A: According to the question, the data signal is represented byThe sampling rate is 30 samples per…

Q: What is the difference between synchronous and asynchronous input to 0-9 and 0-5 counters?

A: We need to explain:the difference between synchronous and asynchronous input to 0-9 and 0-5…

Q: The transistor in the amplifier circuit shown has k = 0.5 mA/V², VTH = -1 V and λ = 0. Construct an…

A: Since you have posted a question with multiple sub parts and part (a) also contains multiple sub…

Q: Discuss the challenges of implementing a hybrid system development model

A: Implementing a hybrid system development model, which combines elements from different software…

Q: What is the answer the number 14 alone

A: Given circuit:Asked to find the all terminal voltages.Note: As mentioned in the question only…

Q: Q5. The bridge circuit in Figure Q5 below is used to monitor temperature using a thermometer. The…

Q: Solve for the voltage across each resistor in the figure below using both Mesh and Nodal Analysis.…

A: The circuit diagram,

Question

Please solve this question queckly

H.W4 The diode in the single-phase half wave rectifier has
150usec and the source voltage V₁
recovery time of t₁ =
frequency = 5 kHz. Calculate the average output voltage.
F Gall
=
a reverse
200V at

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Stating the available information and what we need to find

VIEW

Step 2: Finding the average output voltage

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the difference between a diode and rectifier?
How is a solid-state diode tested? Explain.
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to 220V ams 5OHZ İL-DC =05A RL VL-DC =20V
Draw output waveform for the following circuit. Suppose input is a pure square wave with a positive half at 10 V and negative half at -10 V for ideal diodes. D1 D2 220 R3 R1 1k R2 1k
Power supply circuit is delivering 0.5 A and an average voltage 20 V to the load as shown in the circuit below. The ripple voltage of the half wave rectifier is 0.5 V and the diode is represented using constant voltage model. The smoothing capacitor value is equal to IL-DC =0:5A RL VL-DC =20V 220V omsb O 001 F O 0.02 F O 0.0167F O None of the above Activate
In the figure calculate the output dc level and the required PIV of each diode.
0:- Consider the circuit in Figure a) What type of circuit is this? b) Find and Sketch the voltage waveform across RL, assume the diodes are practical. c) If 100uf capacitor parallel with the resistor, calculate the ripple is connected factor I O o D
Draw the input waveform and output waveform for the circuit given below with proper values marked in the figure. Assume D1 as silicon and D2 as germanium diodes. Input Vpp=20V, V1=4 V and V2=10 V. R www DZ D1 Vin Vout vi V2 Maximum voltage of output waveform Minimum voltage of output waveform
Draw vx and v0 according to the input voltages in the circuit shown in the figure. note = R1 = 10Kohm R2 = 1kohm R3 = 1Kohm, the threshold voltages of diodes will be VE = 0.7V.
Draw the input waveform and output waveform for the circuit given below with proper values marked in the figure. Assume D1 as silicon and D2 as germanium diodes. Input Vpp=20V. V1=5 V and V2=9 V. R www D1 Vin Vout v1 V2 Maximum voltage of output waveform Minimum voltage of output waveform
H.W4 The diode in the single-phase half wave rectifier has a reverse recovery time of t 150μsec and the source voltage V₁ 200V at frequency = 5 kHz. Calculate the average output voltage. = =
In the circuit shown below. Determine the following a. Vs (at the secondary) b. Vout (across RL) c. Vrip (ripple votage) d. VDC e. PIV (Peak Inverse Voltage) 10:1 Output 115 V mis 60 Hz RL 2.2 k) D, 50μF- All diodes are IN4001. Tund AlMannai EENG261 Page 5/11