H.W2: two large plate surfaces are 2.4cm. the space between the surface if filled glycerine.what force is required to drag a very thin plate of surface area 0.5m betweer two large plane surfaces speed of 0.6m/s,if: a) The thin plate is in the middle of the two plate surfaces. b) The thin plate is at a distance of 0.8cm from one of the plane surfaces. Take the dynan viscosity of glycerin = 8.1*10' N s/m². %3D

H.W2: two large plate surfaces are 2.4cm. the space between the surface if filled glycerine.what force is required to drag a very thin plate of surface area 0.5m betweer two large plane surfaces speed of 0.6m/s,if: a) The thin plate is in the middle of the two plate surfaces. b) The thin plate is at a distance of 0.8cm from one of the plane surfaces. Take the dynan viscosity of glycerin = 8.1*10' N s/m². %3D

Name: H.W2: two large plate surfaces are 2.4cm. the space between the surfa
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: H.W2: two large plate surfaces are 2.4cm. the space between the surface if filled vglycerine.what force is required to drag a very thin plate of surface area 0.5m² betweentwo large plane surfaces speed of 0.6m/s,if:a) The thin plate is in the middle

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

bläs 10 Q) A body of dimensions 2.7 m * 2.5 m, weighs 2500 N * .in water.Find its weight in air * 3.8 m 508.25 kN (O 101.65 kN ( 254.12 kN O 127.06 kN (O
A rectangular plate 1.1m x 1.75m is submerged in water and makes an angle of 30° with the horizontal, the 1.1m sides being horizontal. Calculate the magnitude of the force on the plate and the location of the point of application of the force, with reference to the top edge of the plate, when the top edge of the plate is: a) At the water surface. b) 500mm below the water surface
The ice at a certain hockey rink is made by freezing water that is 1.5 inch deep. How many gallons of water does it take? Approximate the rink as a 100 ft. by 85 ft. rectangle. hint: 1 gal = 231 cubic inches and 1 ft = 12 inches
I think the answer is quite simple 10km/hr ,but I'm looking for a diagram.
An open vessel of water accelerates up to a 30ᵒ plane at 2 m/s². a). What is the angle the water surface makes with the horizontal? B). If the angle mage by the water surface to the horizontal is increased to 25.21ᵒ, what will be the depth of water at the rear side of the vessel, if the initial depth of water at the rear side is 4m and the front is 2m before accelerating? The vessel has a length of 4m and 2m width. C). If the vessel’s depth at the rear side is 5m, what will be the volume spilled if the acceleration is increased to 15m/s²?
Q2: A flat plate of area (1.8 m²) is pulled with a speed of (0.6 m/s) relative to another plate located at a distance of (0.18 mm) from it. Find the force and power required to maintain this speed, if the fluid separating them is having viscosity equals (1 poise).
2. A cylindrical container having cross-section area 100.0 m², which is put on the ground, is filled with sea-water to a height of 15.0 m. Then, a small hole, which is located at 1.33 m height from the ground, is caved to the container. If the decreasing speed of sea-water inside the container is 9.00 m/s², a) find the how fast the water remove from this small hole, and b) find the of the cross-section area of the small hole. (Density of sea-water: 1.03 g/cm³) Note: The top of the container is open to atmospheric pressure.
At what distance d, in kilometers, from the surface of the earth on a line fromcenter to center would the gravitational force of the earth on a rocket be threetimes the gravitational force of the moon on the rocket?
A lorry has a mass of 10 tonnes (one tonne equals 1000kg) and a surface area of 6.3m2. Its aerodynamic drag coecient is measured to be 0.530. Assume the drag force is proportional to v2, given by F = 1/2DρAv2 and ignore other sources of resistive force. a) Find the power required to maintain a speed of 60km/h on a flat, straight road. b) Find the power required to maintain a speed of 80km/h on the same flat, straight road. c) If the energy yield of diesel fuel is the same at either speed, how much more in percent does it cost to go one kilometre at 80km/h relative 60km/h? d) Find the power required to maintain a speed of 60 km/h on an incline of 10%.
Let us say that we have a ladder with its own length (L) and its own mass (m) this ladder just so happens to make a (θ) degree angle with a wall. The center of mass of this ladder is 1/3 of the way up from the bottom (it gets narrower towards the top). A person of mass M then decides to climb the ladder until he comes to the halfway point. Wall has no friction but the ground has on the ladder.. a) Draw this situation and label forces so you may set up the statics equations. b) Find the force on the ladder due to the ground (both x and y components) and the force on the ladder due to the wall.
Q3)A tank 6 m long 3 m wide and 2 deep contains oil to depth of 1.75 m .If it accelerated horizontally at 2.5 m/s2 in the direction of its length. How muchı oil would spill out and the acceleration force.
2. A cube with 15 cm sides is submerged in ọil (So = 0.88) and held under the surface by a downward force of 20 What is the density of the cube?