Please provide full soloution thank you Ks(s+2)(s² +8s +80)Given unity feedback system forward transfer function, determine:The root locus sketch●●G(s) ==The asymptotesThe imaginary axis crossing pointsThe value K at imaginary crossing pointsThe angle of departureThe break out point

Given data: The transfer function of the unity feedback system, Gs=Kss+2s2+8s+80 We need to…

G(s) = K s(s+2)(s² +8s +80) Given unity feedback system forward transfer function, determine: The root locus sketch The asymptotes The imaginary axis crossing points The value K at imaginary crossing points The angle of departure The break out point

G(s) = K s(s+2)(s² +8s +80) Given unity feedback system forward transfer function, determine: The root locus sketch The asymptotes The imaginary axis crossing points The value K at imaginary crossing points The angle of departure The break out point

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Series-Parallel Circuit Problem #7 Using the following series-parallel circuit, calculate the total…

A: The required parameters can be calculated by using resistance reduction techniques and also by using…

Q: 1. Calculate the total resistance in the figure given below. Use Delta-Wye transformation. 8Ω, 120…

Q: 9 (s+3)²+(1)² s[(s+1)²+(1)²] Let G[s] = = pole at s=1+j. (a) +0° (b) -45° (c) +45° (d) +90° (e) -90°…

A: The question is from root locus concept. In that angle of departure .

Q: Refer to ,Voltage on the inverting (-) terminal is: y 1 ΚΩ + 1 ΚΩ ww X

A: Given, The circuit diagram,

Q: Given: VDD=2.5V R=100k k=0.5 mA/V² VTH = -1V λ=0 What is vo and v; if the mode is transitioning from…

Q: Find the inverse transforms of the following functions a) F(z) = 1 + 3z-¹ +42-2 b) F(z) = 5z-¹ +42-5…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: In the circuit below, Solve the indicated currents using the following laws & Theorems: Ic – Use…

A: The norton's equivalent circuit can be obtained by short circuit the 2ohms resistance to find…

Q: Consider a three-phase 13.8 kV, 25-MVA, Y-connected synchronous generator whose three-phase…

A: Given data The value of the line voltage, VL=13.8 kV Rating of the synchronous generator, S=25 MVA…

Q: An RC series circuit has a power factor of 72%. How many degrees are the voltage and current out of…

A: Given, Series RC circuit is having Power factor (pf) = 72% We need to determine the angle of Voltage…

Q: R(s) G G H Y(s)

Q: When a silicon p*-n junction is reverse-biased to 30 V, the depletion-layer capacitance is 1.75…

A: Given data: The maximum electric field, E=3.1×105 V/cm The depletion-layer capacitance, Cδ=1.75…

Q: Consider the transistor circuit shown below:- R₂ A B C Howw If the transistor has ß = 19 and VẼ = 4V…

Q: Problem 1. Under dc conditions, find the energy stored in the capacitors in Figure 1. 10 V 1kQ www…

A: The given problem is from circuits. Under dc source, the capacitor behaves as an open circuits The…

Q: c. Why is Important the TIME relay in electrical Power.

A: Time relays are used in high voltage applications These are used for time delayed switching…

Q: The resistance and reactance of the main winding of a 50 Hz single phase induction motor are √3 and…

A: Given data: The given resistance, R=3 Ω The given reactance, XR=1 Ω

Q: 1. What type of natural response occurs in the circuit below if R = 42502? Assume that the initial…

A: Given:

Q: Provide the following expressions or values as required: ) Expression for the maximum gain/magnitude…

A: We convert the circuit element in the s-domain as shown in the figure below.…

Q: 4. The switch in the circuit below has been closed for a long time and is opened at t = 0. Obtain an…

Q: + ei L elle R + eo

A: The time constant is defined as the time required by output to reach 63.2% of final value during…

Q: ax(t) 1 8+2 8-3 $+5 s+1 y(t)

A: We need to find out the transfer function and we need to check whether the given system is stable or…

Q: A 4-bit DAC can be produced with a R-2R ladder method. a) Draw the circuit. b) Write down an…

A: sgddddddddddddddddddddddddallllllllllllllllllllllllllllllllllvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv…

Q: Problem 4: What is the impedance of a 100 mH inductor at 150 rads/sec? Express the impedance in both…

A: The given problem is from inductor. The detailed solution is given in the next step

Q: Assume the following block diagram for the entire exam. 1. R[0] + If G[s] the root locus. +…

Q: The rotor speed of a permanent magnet motor is O Inversely proportional to the field current O…

Q: 7. (a) 0 (b) 1 (c) 2 (d) 3 (e) 4 ) Let G[s] = go off to infinity? (s+2) s(s+10) (s²+10s+24) and…

A: We need to select correct option for given system .

Q: 6.48 Under steady-state dc conditions, find i and v in the circuit in Fig. 6.71. 5 mA Figure 6.71…

Q: We assume that your microcontroller is clocked at 10 MHz and has a 16-bit free-running counter. The…

A: What is a Microcontroller? An embedded system's microcontroller is a tiny integrated circuit that…

Q: 5. Using nodal analysis, find V₁, V₂ and V₂ 6A ↑ V₁ M 92 M 452 8A 352 V2 42 62 W √3 782 9 v

A: In this question we need to find the voltage V1 , V2 and V3 .

Q: 11.18 An abc-sequence set of voltages feeds a balanced three- phase wye-wye system. If the line…

A: Given data: Line current in the phase a,Ia=16.78∠20.98° A Line impedance,Zline=1.2+j1.8 Ω Input…

Q: 11. Let G[s] = = loop pole at s= -1. (a) K = 0.1 (b) K = 0.2 (c) K = (d) K = (s+3)²+(1)²…

A: The given problem is from control system. The detailed solution is given in the next steps.

Q: Determine the product LC in terms of permittivity and permeability for both the two-wire line and…

A: product LC in terms of permittivity and permeability can be find out as shown below

Q: Q7. You acquire a 20 Hz analog signal from sensor. Now you need to digitalize it to process it on an…

A: Relation between Sampling Frequency and Maximum analog Frequency Outcomes after digitalization of…

Q: 6. The switch in the circuit below has been open for a long time before it closes at t = 0. Obtain…

A: Given: Required: Current through the inductor.

Q: A loss less power system has to serve a load of 250 MW. There are tow generation (G₁ and G₂) in the…

A: In this question we need to find the value of power generated by generator G1 and G2 for economic…

Q: 1. Before the TRIAC is triggered on, the voltage across its ma in terminals is equal to the ___volta…

Q: R(S) G(s) G(s) Figure 2.1 Figure 2.1 shows the closed-loop control system of a forklift with…

Q: Sketch the time domain waveform r(t) and find the Laplace transform X(s) for the following signals.…

A: Given data The signals xt are given as, (a) xt=4e3tsin6πt+π4ut (b) xt=3e-2tut+5e3tu-t (c) xt=t2e-tut…

Q: Question No.8 answered correctly The cylindrical coordinates of a point P are (10, 60°, 5) The…

A: Given- The cylindrical coordinates of a point P ρ,φ,z→10,60°,5 To find- The rectangular…

Q: Design an inverting AC amplifier that has a mid-band gain of AV = −2 and with a low cut-off…

A: Given: An inverting AC amplifier that has a mid-band gain of AV = −2 and a low cut-off frequency of…

Q: 1. Calculate the currents through all the resistors using mesh analysis method and find vo 0.5% www…

A: Given, The circuit diagram,

Q: 3. A 10 Q and a 200 resistance are connected in parallel and a 50 is connected in series with the…

Q: In the circuit shown below, there is no initial energy stored in the capacitor or the inductor…

A: Given, The initial energy storage in the capacitor and inductor are zero. i.e The initial voltage…

Q: 5.20 The current gain for each transistor in the circuits shown in Figure P5.20 is B = 120. For each…

Q: FOR THE CIRCUIT BELOW DRAW THE VO OUTPUT. Va Vb Vc Va 1,0 -1.0 -2.0 66 -1.0 2.0 1,0 -1.0 -2.0 10k Y…

Q: 4) For the circuit shown below, find: a. the Thévenin's equivalent circuit between A and B. Use…

A: The thevenin's equivalent circuit can be calculated by using the open circuit voltage for a and b…

Q: 'o VI VDD RD Ţ w vo

Q: Figure 3.1 shows a Bode sketch of Gain (dB) versus frequency. Estimate the transfer function of the…

Q: G(s)=(s+2)/(s+1)^2 Find K such that ζwn= 2. Use Root Locus.

A: In this question, We need to determine the value of K using the root locus. We know…

Q: Use the phasor concept to find the steady-state expression for i, (t) in the circuit below. vs (t) =…

A: The given problem is from circuits. Lets take cosine as a reference signal. The detailed solution is…

Q: 40 Ohms 40 Ohms a. 529.00 W What is the total power consumer by the heater? b. 721.69 W c. 440.83 W…

A: We need to find out the total power for given circuit .

Question

Please provide full soloution thank you

K
s(s+2)(s² +8s +80)
Given unity feedback system forward transfer function, determine:
The root locus sketch
●
●
G(s) =
=
The asymptotes
The imaginary axis crossing points
The value K at imaginary crossing points
The angle of departure
The break out point

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

seels e A unity feedback system has G(s) as shown below in figure, what is the range K for * ?stability K(1+0.25)(1 +0.0255) () = 51+ 0.001 ) + 0,005 5) 600
A feedback system signal flow graph diagram shown in figure below. The number of two nontouching loops is G9 G. Y(s) R(s) 五 -H,
A feedback system signal flow graph diagram shown in figure below. The number of the forward path is -H2 GA )s(ر مل G3 G7 R1(s)< -1-1 G8 G6 G2 R2(s).
Ques 2: What is the Voltage series feedback? Explain the effect of feedback on gain and input, outputimpedance
HG(s) = QUESTION 6 s²+4s+5 Consider the root locus of a unity feedback system that has the open loop transfer function shown below. Find the break point. K(s+1) ² $3 HG(s) = AKI a... bmit. Click Save All Answers to save all answers.
For the system shown in Figure 3, first find the values of K1 and K2 to obtain a peak time of 1 second, and a settling time of 2 seconds, for the closed-loop step response of the system. Then find the poles of the closed-loop transfer function, T(s) = C(s)/R(s). Construct the corresponding graph of poles and zeros
=. The block diagram of a multiple-loop feedback control system is shown in the following figure, please find the transfer function of C(s)/ R(s) H,(s) R(s) G,(s) G,(s) C(s) G,(s) H,(s)
What are the barkhausen criteria for oscillations in a open loop circuit?
write forward paths and feedback paths.
Consider the feedback system is shown in following figure. The system has one parameters R(s) C(s) 10 s(s+1) TS (1) Find the transfer function. (2) When 70 determine the overshoot M, and setting time t at A = +2%. (3) Find the value to determine the overshoot Mp = 10% and tp = 1s
A feedback system root locus graph shown in figure below. For damped frequency 8.04 Hz, the gain K = 10 Imaginary Axis (seconds) ÖAN÷O-NWAGALBE -10 -20 -18 -16 Root Locus -14 -12 -10 -8 -6 -4 Real Axis (seconds) Ņ 0
A feedback solution