Given the three-wire leveling note below, find the elevation of BM2 and perform the customary arithmetic check.

Q: Compare sand and flow plumbing

A: Given terms- Sand & Flow plumbing, Comparison is required.

Q: For the particles in problem 3, determine the percent removal in a sedimentation basin with a depth…

A: Answer  We are given Before flocculation Average diameter = 20 μm  Specific gravity S = 2  After…

Q: Use the information provided and the figure below to determine the hydraulic gradient for the entire…

A:

Q: H.W.2: Find the maximum applied load (P) that can be applied on the rectangular beam with dimension…

A: A beam span 12 m of 300*600 mm is given to this 2 point loads of equal magnitude P is applied at a…

Q: 4- For each truss below, determine the forces in a a checkmark () using the method of sections. a)…

A: As per Bartleby's guidelines we are supposed to answer only first question. Kindly repost other…

Q: Calculate the area from the following coordinates

A: Given : x1=300   y1=300x2=400   y2=800x3=600   y3=1200x4=1000    y4=1000x5=1200   y5=400

Q: Determine the resultant of the four forces that set on the machine element shown. Indicate the…

A:

Q: Given the system of forces shown, determine algebraically the magnitude, position, and direction…

A: To find the position and magnitude of the resultant.

Q: 75mmy 25mmp 24.0M 750mm Hg @56 = 13.6 Ve75mmg = 0.6m/s Reqd² h = ?

A: A pipe flow in which one end is open to the atmosphere and manometer is inserted at one point to…

Q: 11 3 ut of n Use the information provided and the figure below to sand-filled Darcy tube. Also…

A:

Q: 6- A Sample of saturated clay had a volume of 97cm and a mass. of 0.202 kg. When Completely dried…

A: Given Data  Saturated clay volume  = 97 cm3 Mass of saturated clay = 0.202 kg  Dry volume of clay =…

Q: ● ● ● Example: reading around a 10x10 cm square area = 0.995 rev Reading around the required area =…

A: Given- 10 cm×10 cm square area,Reading=0.995 rev,Required area reading=5.765 rev,Scale of map…

Q: 7. The void ratio of an unconsoloidated clay samle is 1.19. Determine the porosity of the sample

A: Introduction : The given question is related to geotechnical engineering . In this question with…

Q: between the trusses. The weight of the roofing materials, including the weight of pur vice live load…

A:

Q: Q1 Determine the shear and moment throughout the beam as functions of x. 250 lb 4 ft 150 lb/ft 6 ft…

A: Given: A symmetrical loading for a beam  Required: Shear and moment equation throughout the beam as…

Q: Question 1 Which material is mold-resistant? Cork Bamboo Mycelium Cob Question 2 What was the main…

A: Construction materials are things that are utilized in buildings. Buildings have been made using a…

Q: A trapezoidal concrete dam is 27ft. high. The upstream face is vertical and the water is flush with…

A:

Q: 2 kN/m A F 3m 12 m 6 kN 4 m 750 N/m 18 m 3 m 3 kN B 4 m

A:

Q: PLEASE DO NOT USE COMMA (S) ON YOUR ANSWER!!! Moist unit weight of soil, gamma = 127 lb/ft³ Cohesion…

A: Objective: To determine the ultimate and allowable bearing capacity of the circular footing using…

Q: Determine the forces in members DJ and EJ of the loaded truss. The forces are positive if in…

A:

Q: Determine the magnitude of the gripping forces exerted along line aa on the nut when two 52-lb…

A: P=52lb To find force exerted along aa

Q: A fluid of dynamic viscosity 2 × 10-5 kg/ms and density 1 kg/m³ flows with an average velocity of 1…

A: Given data- Dynamic viscosity- μ=2×10-5 kg/ms, Density- ρ=1 kg/m3, Average velocity- Vavg=1 m/s,…

Q: -30 ft- ft OE 60 k 40 k - 30 k -30 ft- OF 20 ft impi snossib

A:

Q: H.W.2: Find the maximum applied load (P) that can be applied on the rectangular beam with dimension…

A: Given a simply supported beam, spanning = 12m Carrying two point loads at 4m from either sides of…

Q: A hollow shaft of external and internal diameter as 100 mm and 40 mm respectively is transmitting…

A: From Given Data : External diameter Do = 100 mmExternal radius ( r ) = Do2 = 1002 = 50 mmInternal…

Q: If other materials were allowed to be used to strengthen the balsawood frame of the bridge, what…

A: In order to offer access to a physical impediment, such as a body of water, a valley, or a road, a…

Q: The void ratio of an undisturbed soil sample is 0.55 and the moisture content - is 11%. If Gs =…

A:

Q: Problem 4: The cantilevered beam is subjected to a concentrated force P at its end. Determine the…

A: Given : Allowable Stress = 180 MPa Determine the largest magnitude of force so that the bending…

Q: Crude oil (p = 870 kg/m³, μ = 8x10-³ kg/(m-s)) is to be pumped out of an oil tanker into a storage…

A: Given, Density (ρ) = 870 kg/m3  Viscosity, μ = 0.008 kg/ms L = 100 + 200 = 300 m  D = 6 in or 0.15 m…

Q: Q13. Fig.12 Shows a two cylinder engine with pistons arranged at 90° to each other. The crank OBE is…

A:

Q: Discuss how a unit hydrograph is used and provide an example on how it is applied.

A:

Q: The void ratio of an undisturbed soil sample is 0.55 and the moisture content is 11%. If Gs = 2.68,…

A: Given data:- The given undistributed soil sample is, 0.55 The given moisture content of 11% The…

Q: d otch-yoke o reciprocating motion of the Rod BC. If OA is rotating at 5 rad/s and has an angular…

A:

Q: pipe of 1.2 m diameter was provided in a reservoir to act as an outlet. Due to disuse, it was buried…

A: According to given data A pipe of 1.2 m diameter was provided in a reservoir to act as an outlet.…

Q: Theory of structure Drow S.F.d A.F.D B.M.D

A: Given Data  Draw axial force, Shear force and bending moment diagram.

Q: Determine (a) the magnitude of the counterweight W for which the maximum absolute value of the…

A: Given data : Introduction : 1 - According to the problem we have to determine Magnitude of…

Q: A ceramic matrix composite contains internal flaws as large as 0.001 cm in            length. The…

A: Given data:- The given value of f is, f=1 The value of internal flaws is as large as 0.001 cm. The…

Q: For a sandy soil, the ultimate bearing capacity of 30 cm plate is found to be 120 kN/m² cm during…

A: Given data:- The given width of the plate, Bp=30 cm Qup=120 kN/m2 The given width of the footing,…

Q: A 20-cm long soil sample is acquired with a cylindrical tub having a 5-cm diameter. On removal from…

A: Given: 20 cm long sample  Diameter of cylinder = 5 cm  Initial weight = 525 g  Dry weight = 503.2g…

Q: Q3 Draw the shear and moment diagrams for each member of the frame. Assume the frame is pin…

A: The given figure is shown below:

Q: Q4/ SAE 30 oil at 60 °F flows through a 2-in.-diameter pipe with a mean velocity of 5 ft/s.…

A:

Q: Determine: a. The arithmetic mean speed b. The standard deviation c. The median speed (Locate in the…

A:

Q: A compound steel [G-82 GPa) shaft consists of solid 34-mm-diameter segments (1) and (3) and tube…

A: Given : G = 82 GPa Diameter of shaft = 34 mm Outside diameter of tube segment = 56 mm inside…

Q: The SFSU alumni in problem 1 was happy with your work and needs your assistance to design a pipeline…

A: Given: Length, L = 2.5 km = 2500 m Empty reservoir depth, h = 100 m water surface below the surface…

Q: 3. The soil profile at a site for a proposed building is shown in the following figure. The density…

A: Given Data: The data is given as: Over consolidated ratio of clay(OCR)=1.5Initial void…

Q: Sedimentation is the process of allowing particles in suspension in water to settle out of the…

A: Given: Discharge for four clarifiersQ=1.5 MGD Q=1.5×3785.4 m3day       1 MGD=3785.4 m3day Q=5678.10…

Q: What are Xrefs and its applications?

A:

Q: 1.2 A soil has a bulk density of 1.91 Mg/m³ and a water content of 9.5%. The value of G, is 2.70.…

A: Given : Bulk density of soil = 1.91 Mg/m3 Water content = 9.5% Gs = 2.70  WE have given the table in…

Q: A soil sample taken from a borrow pit has a natural void ratio of 1.15. The soil will be used for a…

A: According to given data  A soil sample taken from a borrow pit has a natural void ratio of 1.15. The…

Q: An ISHB 300 with plastic section modulus of 921.68x103 mm³, flange width of 250 mm, the yield stress…

A:

Site Plan Requirements

A site plan (also known as a plot plan) is a diagram or process to show the proposed improvements on an existing property. A site plan is important, as it provides information regarding the landscape features of a given plot of land.  Zoning is done or can be understood with the help of a site plan.