Answered: given the circuit below, compute for…

given the circuit below, compute for the following a. Source phase voltages b. Source line voltages c. Line currents 440/0°V 440/120° V 71 L 6-18 Ω 440/-120° V Iz 6-j8Q2 N 6-18 Ω

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.5MCQ

See similar textbooks

Related questions

Q: 1- Use the node-voltage method to find the vo in Figure shown. 25 V 20 Ω w 2A] € 3500 {55 Ω • 150 Ω

A: The circuit is shown below: Applying K.C.L at the super node x,…

Q: 55- Form and draw bus admittance matrix (Ybus) matrix for the following power systems. Bus code…

A: A four bus system having some line impedances and admittances are given. All the identities in Y-Bus…

Q: Find the value of power gain for an amplifier in decibels, given that output voltage value is 40v,…

A: In this question we will find power gain of an amplifier in decibel....

Q: 1. Use nodal analysis and find the voltages across z1, z2, z3 and z4. Use node A as your reference…

Q: roblem 15: Find the angular velocity w of a waveform when the frequency is: a. 100Hz b. 0.25kHz c.…

Q: 4. The propagation constant consists of two terms. the first term is the attenuation constant, and…

A: In this question we need to choose a correct option

Q: Chapter 18: Problem 5 (Mesh Analysis): Find the current that flows through the resistor R. R Η 4 Ω E…

Q: 2. Find the voltage across a 5µH inductor if i equals A) 30te-t nA B) 4e-5t sin 100t mA

A: We need to find out voltage for given current

Q: a) The current 1₁ b) The voltage V c) The voltage Vab I = 2 A 230° 4₁₁ R₁ 3 Ω XL 000 4 Ω Val ab…

A: The above circuit can be solved by using current division rule.

Q: calculate the Nyquist diagram of the following transfer function sys = 334.1 s^2 + 45.38 5 + 227.3

A: We need to calculate the Nyquist diagram of the following transfer function:…

Q: For the circuit shown in Figure 2 let Vcc=5 V, R₂ = 4 k2, Re - 3 k2, R₁ = 60 k2, and R₂ = 40 k02.…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: An emf e1=100sin(314t - 60°) while emf e2 = 120 cos(314t -60°). Find the angle of phase difference…

A: An emf e1=100sin(314t - 60°) while emf e2 = 120 cos(314t -60°). Find the angle of phase difference…

Q: Determine the values of is.va, is, and vs in the circuit shown below. U1 12Ω 5Ω 6Ω Μ 18 V {89 8 Ω Μ…

Q: 2. The sequence component of phase a current are: Zero sequence current = = Positive sequence…

A: Types of sequence current in unbalanced system Zero sequence current ( finite value ) Negative…

Q: loke Js, Rs C₁₂ І. Пока 31 -10v B = 180 a) VCE, IE re b) Zi, % 4), Aus Ai he Is +V 2k REMTRL 2ke F

A: Given: Consider the given circuit: To find: (a) VCE, IE, re (b) Zi, Zo, Av, Avs, Ai

Q: Three resistors of 50 ohms, 100 ohms,

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+........... Resistance in series-…

Q: a. Find the function f(t) define by the square waveform shown below. f(t) +HD -2π 2π 3 f b. Find the…

A: For the given square waveform the function f(t) is calculated as shown in below steps. And also for…

Q: Indicate graphically the effect of increasing the source resistor RS on the Q-point of the JFET. Va…

A: JFET(Junction Field Effect Transistor): One of the most basic varieties of field-effect transistor…

Q: Can you do it using Ohm's Law?

Q: Find I in the circuit shown in the figure below using superposition.

Q: Determine the value of the current ?for the circuit shown below.

Q: 9. Calculate the return loss in dB if the voltage load reflection coefficient is 0.24. O None of…

A: We need to find out return loss

Q: An amplifier has a midband voltage gain of 120 operating between f1=10 Hz (lower cut-off) to 100 kHz…

A: We need to find out the output voltage for given amplifier

Q: Let w= 800rad/s in the circuit. Find the input impedance,Zin

Q: The use of the magnetization curve to solve a problem like separately-excited and self-excited shunt…

A: In this question we will write about magnetisation curve of dc generator....

Q: 2. Find Vo using superposition -j4Ω = 8 Ω Μ +1 10/0° V +1 -j2 Ω 4) 4/0° A j5 Ω m 6Ω 3/0°

Q: Please determine(with a complete solution): a.) R_E b.) Z_i, Z_o, A_V, A_VS, A_i

Q: Find the value of power gain for an amplifier in decibels, given that output voltage value is 40v,…

Q: Given: IE (dc)= 1.2mA, B =120 and r= 40 k ohms. In common-emitter hybrid equivalent model, convert…

A: In this question we will find common base hybrid parameter h ib with the help of common emitter…

Q: Q1: For the circuit shown in figure. Derive the stability factors S(Ico), S(VBE) and S(ß). RB +Vcc…

Q: 15. Why should design our circuits to operate below the SRF of electrical elements? to increase the…

A: In order to avoid the abnormal behaviour of the elements connected in the circuit we generally…

Q: Design a 4-bit Gray Code to Excess-3 code converter. Include the truth table, simplified equation…

A: Introduction - Gray code - The Gray code is a binary number scheme arrangement in which two…

Q: Q/Find the Power supplied by all Sources. "by using Loop analysis 2) 1222 m. зл 25 100 V 3;x +1 M ix…

Q: 18. A current of 16 amperes divides between two branches in parallel of resistances 8 ohms and 12…

A: Given two branch parallel circuits with, Total current, IT=16 A First branch resistance, R1=8 Ω…

Q: For R1=40, R2=60, R3-60, R4-30, R5=30, V1=10 V, V2=40 V & 11=8 A in the circuit shown below, apply…

A: given here a circuit and asked to find Vx using source transformation.

Q: Or if X(t) = Cos 25x₁0lt. find the followy. 5²s(+-10") x(tidt = { D SH-10²) X(+) =

A: We need to find out the value of given signal

Q: Find the voltage gain Vo/V₁ of the Op-Amp

A: Operational amplifier- An integrated circuit which amplifies weak electric signals into a strong…

Q: Problem 12: For the network show below, find: a) The total impedance Z b) The value of C in…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: The resistance of a 2m length of cable is 2.5 . Determine (a) the resistance of a 7m length of the…

Q: Find 1, in the circuit shown in the figure below using superposition. 6 kil 2 kil 2 kf2 www

Q: A linear dynamic system is governed by the following Laplace transformed equation. (3s + 5)X(s) = =…

Q: Assume 0.6 V for all diodes if forward bais, reverse breakdown voltages are given, sketch IV curves…

A: Given,For all the diodes,If the diode is forward baised,The voltage is, V=0.6V

Q: Problem 40: For the following two signals shown on an oscilloscope: a. Determine the period of the…

Q: determine :- Ex₂ : (How) A Single-phase Full wave Ac Voltage & Remove Watermark No below, has a…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Find the value of power gain for an amplifier in decibels, given that output voltage value is 40v,…

A: Given data, V0=40 VVin=10 VI0=30 AIin=3 A

Q: B)-A DC generator has Ra=0.12, Rs=0.502, VT-250V, I₁=100 find Ea= and copper losses

A: In this question we need to find a induced emf and copper loss in generator

Q: 4. The propagation constant consists of two terms. the first term is the attenuation constant, and…

A: We need to find out attenuation constant for lossless transmission line

Q: Solve for: a. Id (atleast 4 decimal place) b. Vgs c. Vd (Atleast 3 decimal value) d. Vs a. Id-Blank…

Q: Half adder has two inputs and full adder has three inputs. Select one: O True O False

A: A half adder circuit is, A full adder circuit is,

Q: represents the electrical fields distribution between 2. The equivalent_ the two wires of the…

A: Capacitor stored energy in the form of electric field.

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

given the circuit below, compute for the following
a. Source phase voltages
b. Source line voltages
c. Line currents
I₂
A
440/0° V
440/120° V
21
6-j8 Ω
440/-120° V
Iz
Ic
6-j8Q2
N
6-j8 Ω

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the expression of waveforms A and B clearly. HUS Voltage (V) 8 0 K/N B 7: ST ot
244. The apparent power drawn by an a.c. circuit is 20 kVA and reactive power is 12 kVA. The real power in the circuit in kW will be
Two alternating voltages are represented by vị = 50 sin wt volts and v2 = 100 sin(wt - -). Draw the phasor diagram and find by calculations a sinusoidal expression to represent vi and v,. www The instantane ous values of two alternating currents are given by i = 20 sin wt and i, = 10 sin (wt + ) A. Find the sinusoidal expression for (i1 + i2) by drawing phasors and by calculations.
A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power factor is ________. Hint: Draw the circuit and get Vs and Is
The below figure shows the waveform of the voltage and current in a purcly inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor O Is in phase with the voltage Lags by 90° O Leads by 90° Lags and then leads by 160°
Prob. I and Vc For the following RMS phasor circuit, a coworker has determined values for 50 Ohms 50 Ohms i,- 225 2253.13° = 190.92 + 254.56 VRMS R1 + R2 Vc = 237.17/26.565° = 212.13+ 106.07 VRMS 100 2 -3Z98.13° =-0.4243 + J2.970 ARMS C -j60 Ohms For this problem provide at least 3 digits of precision for the answers. The results for the following calculations are to be answered in - a) Find the current I b) Determine the real (P) and reactive(Q) power DELIVERED by the source c) Determine the real (P) and reactive (Q) power ABSORBED by each impedance ( resistors R1 and R2, inductor and capacitor). The values for P and Q can be positive or negative. Remember S =P+jQ, so do not include the j with your answer for Q. Each of these answers will require two parts. For the phasor a magnitude and angle will be needed. For the powers, The real power P and the reactive power Q are required.
A non-sinusoidal voltage (e=20+15sin10o0t+ 10sin3000t+5sin4000t) Volt is applied to the circuit shown. Find the * ?total power iT 42 İL ic ET -J92 J4N
Ohmic components have a V-I curve O Non-linear VI curve. Parabolic VI curve. Sinusoidal VI curve. Straight line VI curve.
what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms
Which cannot be said since Z is an inductive load in the circuit given below? A) load voltage period is 0.02sec. B) Load voltage peak value is 311V. C) Load voltage frequency is 50Hz D) Load voltage average value is 220V.